2009 FORD ECONOLINE lock

[x] Cancel search: lock

Page 213 of 320

FORD ECONOLINE 2009  Owners Manual P (Park)
This position locks the transmission and prevents the rear wheels from
turning.
To put your vehicle in gear:
•Start the engine
•Depress the brake pedal
•Move the gearshift lever into th

Page 215 of 320

FORD ECONOLINE 2009  Owners Manual •The transmission will not downshift into 1 (First) at high speeds; it
will downshift to a lower gear and then shift into 1 (First) when the
vehicle reaches slower speeds.
Forced downshifts
•Allow

Page 216 of 320

FORD ECONOLINE 2009  Owners Manual WARNING:Always set the parking brake fully and make sure
the gearshift is latched in P (Park). Turn the ignition to the
LOCK position and remove the key whenever you leave your vehicle.
R (Reverse)
Wi

Page 218 of 320

FORD ECONOLINE 2009  Owners Manual REVERSE SENSING SYSTEM (IF EQUIPPED)
The Reverse Sensing System (RSS) sounds a tone to warn the driver of
obstacles near the rear bumper when the R (Reverse) is selected and the
vehicle is moving at s

Page 224 of 320

FORD ECONOLINE 2009  Owners Manual ROADSIDE ASSISTANCE
Getting roadside assistance
To fully assist you should you have a vehicle concern, Ford Motor
Company offers a complimentary roadside assistance program. This
program is separate f

Page 229 of 320

FORD ECONOLINE 2009  Owners Manual WARNING:Always disconnect the battery before servicing high
current fuses.
If your vehicle is equipped with an auxiliary battery,
disconnecting the primary under-hood battery DOES NOT remove
power fro

Page 230 of 320

FORD ECONOLINE 2009  Owners Manual Fuse/Relay
LocationFuse Amp
RatingProtected Circuits
6 20A Turn signal, Hazard, Stop lamps
7 10A Left low beam
8 10A Right low beam
9 15A Courtesy lamps
10 15A Switch illumination
11 10A Not used (spa

Page 239 of 320

FORD ECONOLINE 2009  Owners Manual 3. Remove the jack handle from the
right side compartment and insert
the tip of the jack handle through
the access hole and into the tube.
4. Turn the jack handle
counterclockwise until the cable is
s