2009 FIAT PANDA Parts

180KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCYCAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
F0Z0135m
fig. 183
F0Z0134m
fig. 182
AIR FILTERREPLACEMENT (petrol versions) fig. 182 and 183
Release the clips A, remove the cover front side B
and extract the filtering element C to be replaced.
Brake fluid is poisonous and highly corro-
sive. In the event of accidental contact, im-
mediately wash the affected parts with water
and neutral soap. Then rinse thoroughly. Call a
doctor immediately if swallowed.
WARNING
The symbol
π
on the container indicates
a synthetic brake fluid, distinguishing it
from the mineral kind. Use of a mineral type flu-
ids will damage the special rubber seals of the
braking system beyond repair.WARNING
The symbol πon the container indicates
a synthetic brake fluid, which is different
from a mineral fluid. Use of a mineral-based flu-
id will damage the special rubber seals of the brak-
ing system beyond repair.
WARNING
169-190 PANDA EN 7-10-2009 14:15 Pagina 180

188KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCYCAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
❒
spraying of protective plastic material in the more ex-
posed points: underdoor, inner mudguard parts, edges,
etc...;
❒
Use of “open” boxed sections to prevent condensation
and pockets of moisture which could cause triggering
rust inside.
BODY AND UNDERBODY
WARRANTY
Your car is covered by warranty against perforation due
to rust of any original element of the structure or body.
For the general terms of this warranty, refer to the War-
ranty Booklet.
ADVICE FOR PRESERVING THE BODYWORK
Paint
Paintwork does not only serve an aesthetic purpose, but
also protects the underlying sheet metal.
Touch-up abrasions and scratches immediately to prevent
the formation of rust. Only use genuine spare paint prod-
ucts for touch-ups (see “Bodywork paint identification plate”
in the “Technical Specifications” chapter).
Standard maintenance of paintwork consists in washing the
vehicle; its frequency depends on the conditions and envi-
ronment where the vehicle is used. For example, in highly
polluted areas, or if the roads are sprayed with salt, it is
advisable to wash the car more frequently.
BODYWORKPROTECTION FROM ATMOSPHERIC AGENTS
The main causes of corrosion are the following:❒
atmospheric pollution;
❒
salty air and humidity (coastal areas, or hot humid cli-
mates);
❒
seasonal environmental conditions.
Not to be underestimated is also the abrasive action of
wind-borne atmospheric dust and sand, along with mud
and gravel raised by other vehicles.
On your car, Fiat implemented the best manufacturing
technologies to effectively protect the bodywork against
corrosion.
These include:
❒
painting products and systems which give the car par-
ticular resistance to corrosion and abrasion;
❒
use of galvanised (or pretreated) steel sheets, with high
resistance to corrosion;
❒
spraying the underbody, engine compartment, wheel
housing internal parts and other parts with highly pro-
tective wax products;
169-190 PANDA EN 7-10-2009 14:15 Pagina 188

189KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCYCAR
MAINTENANCETECHNICAL
SPECIFICATIONS
INDEX
Glasses
To clean glasses, use specific window cleaner products.
Also use clean cloths to avoid scratching the glass or dam-
aging the transparency.
IMPORTANT Wipe the rear window inside gently with
a cloth in the direction of the filaments to avoid damag-
ing the heating device.
Engine compartment
At the end of the winter the engine compartment should
be carefully washed, without directing the jet against any
electronic control unit. Have this operation performed
at a specialised workshop.
IMPORTANT The washing should take place with the en-
gine cold and the ignition key in the
STOP
position. After
the washing operation, make sure that the various pro-
tections (e.g. rubber caps and guards) have not been re-
moved or damaged.
Front headlights
IMPORTANT Never use aromatic substances (e.g.: petrol)
or ketenes (e.g.: acetone) for cleaning front headlight plas-
tic lens. To correctly wash the vehicle, proceed as follows:
❒
remove the aerial from the roof to prevent damage to
it if the car is washed in an automatic system;
❒
wash the body using a low pressure jet of water;
❒
wipe a sponge with a slightly soapy solution over the
bodywork, frequently rinsing with the sponge;
❒
rinse well with water and dry with a jet of air or
a chamois leather.
Dry the less visible parts, such as the door frames, bonnet
and the headlight frames with special care, as in these ar-
eas water may stagnate more easily. The car should not
be taken to a closed area immediately, but left outside so
that residual water can evaporate.
Do not wash the car after it has been left in the sun or
with the bonnet hot: this may alter the shine of the paint-
work.
Exterior plastic parts must be cleaned in the same way as
the rest of the car.
Where possible, do not park under trees; the resinous
substance many species release give the paint a dull ap-
pearance and increase the possibility of triggering rust
processes.
IMPORTANT Bird droppings must be washed off imme-
diately and thoroughly as the acid they contain is particu-
larly aggressive.
Detergents cause water pollution. The vehi-
cle should be washed in areas equipped for
collecting and cleaning the liquid used in the
washing process.
169-190 PANDA EN 7-10-2009 14:15 Pagina 189

190KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCYCAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
INTERIORSRegularly check that water is not trapped under the mats
(due to water dripping off shoes, umbrellas, etc.), as this
would cause oxidation of the sheet metal.
Never use flammable products, such as
petrol ether or rectified petrol to clean the
car inside. The electrostatic charges which are
generated by rubbing during the cleaning opera-
tion may cause a fire.
WARNING
Do not keep aerosol bottles in the vehicle:
risk of bursting. Aerosol bottles must not
be exposed to a temperature exceeding 50 °C.
When the car is exposed to sunlight, inner tem-
perature can greatly exceed this value.
WARNING
SEATS AND FABRIC PARTS
Remove dust with a soft brush or a vacuum cleaner. It is
advisable to use a moist brush on velvet upholstery.
Rub the seats with a sponge moistened with a solution of
water and neutral detergent.
INTERIOR PLASTIC PARTS
It is advisable to clean interior parts with a moist cloth and
a solution of water and mild soap. Use specific products
for cleaning plastic, without solvents and specifically de-
signed to prevent damage to the appearance and colour
of the treated parts to remove grease and tough stains.
IMPORTANT Never use alcohol or petroleum to clean
the instrument panel.
CLEANING SEAT PROTECTORS
In order to clean/remove stains from the
seat protectors, it is not advisable to use
alcohol or alcohol based products (e.g. solvents).
WARNING
169-190 PANDA EN 7-10-2009 14:15 Pagina 190

220KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONSINDEX
Isofix (child seat)
– fitness for child seat use........ 101
– preparation for child
seat use .................................... 103Jack
– warnings .................................. 137
– use ...................................... 137-143
Jets
– windscreen/rear window
washer ..................................... 187Keys ............................................... 6
– door opening/closing with
remote control ...................... 8
– key with remote control ..... 7
– key without remote
control ..................................... 7
– replacing the battery of
the remote control ............... 9
– request for additional keys
with remote controls ........... 8
Know your vehicle................... 3Level check .................................. 175
– brake fluid ............................... 179– engine coolant ........................ 177
– engine oil ................................. 176
– windscreen/rear window
washer fluid .............................. 178
Lifting of vehicle
– with arm lift ............................ 167
– with the jack ........................... 137
– with workshop lift ................. 167
Light units
– installation ............................... 208
Liquids (specifications) ............... 204
Load limiters ................................. 95
Low consumption
driving style ................................ 116
Lubricants (specifications) ......... 204
Luggage compartment
ceiling light .................................. 53
– bulb replacement ................... 159
Luggage compartment
volume ......................................... 201
Luggage compartment
– boot extension ................... 67-68
– opening with remote control. 8
M
ain beam headlights
– bulb replacement ................... 153
– switching on ............................ 48
Main beam headlights
– bulb replacement ................... 153
– flashing ..................................... 48
– switching on ............................ 48
Maintenance and care ................. 169
– check of fluid level ................ 217
– heavy usage of the car .......... 216
– scheduled servicing
programme ...................... 170-171
– scheduled servicing ............... 172
Maintenance and cleaning
– bodywork ................................ 189
– engine compartment ............ 189
– fabric seats .............................. 190
– interior ..................................... 190
– plastic parts ............................. 190
– windows .................................. 50
Manual climate
control system ........................... 41
– controls ................................... 41
215-224 PANDA EN 7-10-2009 15:09 Pagina 220