2009 FIAT DOBLO ignition

181
KNOW
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
F0V0088mfig. 173
CHANGING A FUSE
GENERAL INFORMATION
The fuse is a protective device for the electric system: it
operates if there is a fault or improper intervention in the
system.
Check the state of the corresponding fuse when a device
does not work: the filament A-fig. 173 should be intact.
If it is not, replace the blown fuse with a new one of the
same amperage (same colour).
B intact fuse.
Cfuse with damaged filament.
To change a fuse, use the tweezer D located in the tool
box or the Fix&Go container (for versions/markets where
provided).
If the same fuse blows again, contact
a Fiat Dealership.
WARNING
Never replace a damaged fuse with metal
wires or other recycled material.
Do not replace one fuse with another of
greater amperage; FIRE HAZARD.
If a general protection fuse (MEGA-FUSE, MIDI-
FUSE) is activated, contact a Fiat Dealership.
Remove the key from the ignition and switch off
or disable all electrical devices before replacing
a fuse.
WARNING
To identify the protective fuse, see the tables on the fol-
lowing pages.

183
KNOW
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEXPROTECTED DEVICE FUSE AMPS FIGURE
BCM – Body Computer Control Unit F01 60 175
Rear window winder driver’s side manual gearbox
(Doblò/Doblò Combi versions) F02 20 175
Ignition switch F03 20 175
BSM Braking system control unit (electropump) F04 40 175
Additional heater PTC2 (diesel engines) F05 50 175
Radiator fan (low speed) F06 30 175
Radiator fan (high speed, 187/300/350W) F07 40 175
Radiator fan (high speed, 500W) F07 60 175
Passenger compartment fan F08 40 175
Remote control switch for opening swing door (Cargo version) F09 10 175
Single tone horn F10 10 175
Engine control system secondary loads F11 10 175
Main beams F14 15 175
Additional heater PTC1 (diesel engines) F15 30 175
ECM Engine management control unit, ignition management relay 1
with Start&Stop system F16 7,5 175

190
KNOW
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
F0V0051mfig. 179
Before towing, turn the ignition key to
MAR and then to STOP without extract-
ing it. The steering column will automatically lock
when the key is removed, making it impossible to
turn the wheels.
WARNING
Before tightening the ring, clean the
threaded housing thoroughly. Before tow-
ing the vehicle, make sure that the tow ring is ful-
ly tightened in its appropriate housing.
Never start the engine when the vehicle is being
towed.
WARNING
Remember that, while being towed, you
will need to brake harder because there
will be no assistance from the brake booster. Do
not use bendy cables for towing and avoid jerk-
ing. During towing operations, make sure that the
fastened joint does not damage adjoining com-
ponents. When towing the vehicle, comply with
the specific rules of the highway code regarding
the towing device and road conduct. Do not start
the engine while being towed.
WARNING
The front and rear tow hooks should be
used only for emergencies on the road. You
are allowed to tow the car for short dis-
tances using an appropriate device in accordance
with the highway code (a rigid bar), to move the
vehicle on the road in readiness for towing or trans-
porting via a breakdown vehicle. Tow hooks MUST
NOT be used to tow vehicles off the road or where
there are obstacles and/or for towing operations
using cables or other non-rigid devices. Respecting
the above conditions, towing must take place with
two vehicles (one towing, the other towed) aligned
as much as possible along the same centre line.

216
KNOW
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEXINTERIORS
Check regularly that water is not trapped under the mats
(from dripping off shoes, umbrellas, etc.) which could cause
the metal to rust. Windows
Use specific detergents to clean the windows. Also use
clean cloths to avoid scratching the glass or altering the
transparency.
IMPORTANT Wipe the rear window gently with a cloth
in the direction of the filaments to avoid damaging the
heating device.
Engine compartment
At the end of each winter, thoroughly wash the engine
compartment, taking care to avoid spraying the water jet
directly onto the electronic control units and the relay/fuse
control unit on the left side of the engine compartment
(as you look from behind the wheel). Have this operation
performed at a specialist garage.
IMPORTANT The washing should take place with the en-
gine cold and the ignition key in the STOP position. After
the wash, make sure that the various protective devices
(e.g. rubber caps and guards) have not been removed or
damaged.
Front headlights
IMPORTANT Never use aromatic substances (e.g. petrol)
or ketenes (e.g. acetone) for cleaning the plastic lenses of
the front headlights.
Never use flammable products, such as pe-
troleum ether or modified petrol, to clean
the inside of the vehicle. The electrostatic charges
which are generated by rubbing during cleaning
may cause a fire.
WARNING
Do not keep aerosol cans in the vehicle:
these could explode. Aerosol cans must
not be exposed to temperatures of more than
50 °C. When the vehicle is exposed to sunlight,
the temperature inside can greatly exceed this
value.
WARNING

266
KNOW
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
– technical
specifications................... 224
Glove compartment ............. 71
Handbrake lever.................. 135
Handbrake ........................... 135
Hazard warning lights
– switching on ...................... 70
Headlamp alignment
corrector............................... 95
Headlamp washers................ 62
– checking levels
and topping up................ 203
– headlamp washer fluid
specifications................... 248
Headlight alignment
corrector .............................. 95
Headlights ............................... 95
– adjusting headlights
abroad ..................................96
– alignment corrector ......... 95– bulb replacement ........... 169
– bulbs (type) ............ 170-171
– light beam direction ......... 95
Headrests
– front ................................... 38
– rear ...................................... 38
Heated rear
window......................46-49-58
Heating and ventilation
system; .................................. 42
Heating and ventilation ......... 44
Heavy use of the vehicle .... 198
Hill Holder system................. 99
Identification data........ 219-220
Ignition keyhole ....................... 9
Ignition lock .............................. 9
Ignition ...................................... 9
In an emergency ................. 155Installing electrical/
electronic devices ............. 110
– radio transmitters
and mobile phones ........ 110
Installing the tow hook ..... 139
Instrument panel ................... 11
Interior fittings ...................... 71
Interior lighting
– front .......................65-66-69
– rear ...................66-67-68-69
Interiors (cleaning) ............. 216
Internal equipment ............... 71
Isofix child seat
– suitability for using
child seats ....................... 124
– capability for Isofix
child seat.......................... 125
Jack
– precautions...................... 158
– usage ................................. 159

269
KNOW
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
– general information ...... 118
– load limiters .................... 118
– maintenance ................... 120
– pretensioners ................. 117
– SBR ................................... 117
– using the seat belts ....... 115
Safety ..................................... 115
Satellite navigation
socket .................................... 75
Saving fuel ............................. 137
SBR system .......................... 117
Scheduled Servicing
Plan .....................192-194-196
Scrappage ............................. 255
Seat belt pretensioners ...... 117
– load limiters .................... 118
Seat heating ......................30-32
Servicing and
maintenance ...................... 191
– checking fluid levels
...........................199-200-201– heavy use of
the vehicle ....................... 198
– precautions
and warnings .................. 191
– regular checks ................ 198
– scheduled servicing plan
....192-193-194-195-196-197
Setting the clock ................... 22
Side airbags (side bag
– window bag).....130-131-132
– general information ...... 131
Sliding side doors ................... 78
Smart washing
(windscreen wipers) .......... 61
Snow chains ......................... 141
Sockets ..............................72-73
Sound system
(wiring) .......................109-110
Spare wheel ......................... 228
– technical
specifications .................. 228Spark plugs (type) ............... 223
Speed block ......................... 102
Speedometer.......................... 12
Start&Stop system............... 105
Starting the engine ............. 133
– emergency
starting.......................134-155
– ignition switch .................... 9
– ignition switch .................... 9
– procedure for
diesel versions................. 134
– procedure for petrol
versions ........................... 133
– stopping the engine ........ 135
– warming up
the engine ....................... 134
Starting up and driving ....... 133
Steering lock and ignition
switch ...................................... 9
Steering lock ............................ 9