2 2
CONTENTS
READY TO START ................................................................... 3
OPERATING MODE.................................................................. 4
WARNING LIGHTS AND MESSAGES.................................. 10
TOWING THE CAR.................................................................. 13
FUSE REPLACEMENT ............................................................... 13
SERVICE SCHEDULE.................................................................. 14
CHECKING FLUID LEVELS...................................................... 14ENGINE CODES - BODYWORK VERSIONS..................... 15
TRANSMISSION ......................................................................... 15
PERFORMANCE ........................................................................ 15
CAPACITIES................................................................................. 16
FLUIDS AND LUBRICANTS ................................................... 16
FUEL CONSUMPTION ............................................................ 17
CO
2EMISSIONS ......................................................................... 17
604.39.991 Bravo Dualogic GB 6-04-2009 10:23 Pagina 2
10
WARNING LIGHTS
AND MESSAGESREDUCE GEAR CHANGES
The message appears in the display to in-
dicate that the driver is using the gearbox
incorrectly.
Incorrect use (by the driver) could auto-
matically activate a procedure for pro-
tecting the system. DUALOGIC GEARBOX
FAILURE (red)
When the ignition key is
turned to MAR, the warning
light turns on and should go off after a few
seconds.
The warning light on the dial comes on
flashing (together with a message in the
display and a buzzer) to indicate that the
gearbox is faulty.
t
If a fault is present, contact
a Fiat Dealership as soon as
possible to check the sys-
tem.
Contact a Fiat Dealership if
the message remains in the
display.
❒if necessary, with the engine off it is pos-
sible to engage 1stgear or reverse (R)
with the ignition ONand the brake
pressed. In this case, gear shifts must be
made allowing at least 5 minutes to
elapse between one gear shift and the
next to safeguard the operation of the
hydraulic system and the pump in par-
ticular;
❒pressing the accelerator pedal quickly
until it is in the end of travel position
and switchin off the ASR function, if
present, using the button in the dash-
board allows for a responsive take off.
❒during hill starts, accelerate gradually
but fully immediately after releasing the
handbrake or brake pedal to allow the
engine to increase its rpm to a greater
extent and overcome higher gradients
with more torque.
604.39.991 Bravo Dualogic GB 6-04-2009 10:23 Pagina 10
