2009 Citroen C6 DAG warning
[x] Cancel search: warningPage 69 of 189
85
III
1
2a2b1
3a3b4
765
A U T O M A T I C A I R C O N D I T I O N I N G
The system has a differentiated adjustment for the driver's side and passenger's side, in terms of temperature and a i r d i s t r i b u t i o n . T h e a i r fl o w i s c o m m o n t o b o t h s i d e s .
Symbols and messages relating to the automatic air conditioning controls will display on the multifunction screen.
2. TEMPERATURE ADJUSTMENT
To adjust the temperature, press button 2a for the driv-er's side and button 2b for the passenger's side.
An adjustment around 21 will give you the optimum comfort level. However, depending on your preferences anywhere between 18 and 24 is quite usual.
Operating the air conditioning system on "AUTO" guar-antees good ventilation inside the cabin.Note: there may be a difference between the actual c a b i n t e m p e r a t u r e a n d t h e fi g u r e d i s p l a y e d .
This is the normal operating mode for the system. Depending on the temperature chosen, a press on this b u t t o n , c o n fi r m e d b y t h e l i g h t i n g o f t h e w a r n i n g l a m p , will automatically and simultaneously bring all the fol-lowing functions into play: A i r fl o w .
Cabin temperature.
Air distribution.
Exterior air intake/Air recirculation.
It is recommended to keep all the air vents open. Just by pressing any of the buttons, except for tempera-ture 2a and 2b, you can change to manual mode. The warning lamp goes off, and the automatic air intake function is deactivated.
Page 72 of 189
88
III
5
6
7
A U T O M A T I C A I R C O N D I T I O N I N G
5. FRONT DEMISTING - DEICING
Press button 5 for rapid clear windows. The warning lamp comes on. This system controls the air condi- t i o n i n g , t h e a i r fl o w a n d t h e e n t r y o f a i r f r o m o u t s i d e . I t sends the ventilation towards the windscreen and side windows.
A press on the 1 button returns you to "AUTO" mode.
6. REAR DEMISTING - DEICING
Press button 6, with the engine running, to start a rapid deicing or demisting of the rear screen and rear view mirrors. The warning lamp comes on.
This mode stops automatically as a function of the out-side temperature. It can be paused by pressing again on button 6 or by stopping the engine.
In the latter case, demisting will resume when the engine is switched on again.Note: The heated rear screen operates independently of the automatic air conditioning.
7. AIR RECIRCULATION – ENTRY OF AIR FROM OUTSIDE
Press repeatedly on button 7 to select the air entry mode. The corresponding warning lamp lights up:Air intake in automatic pollution control mode (on by default, with automatic comfort regulation).
The automatic mode makes use of an air quality sen-sor. It analyses the air and isolates the cabin from the exterior if the presence of pollutants is detected. In this case it automatically activates recirculation of the cabin air.
Please note: this function does not detect and there-fore protect the cabin from unpleasant odours. It is not active when the ambient temperature is below + 5 °C so as to avoid the risk of misting the vehicle’s windows.
Closing the exterior air intake
Press button 7 to close the intake of air from the exterior.
While maintaining the other settings, this position allows the driver to avoid unpleasant odours and smoke out-side the vehicle at any time.
It should be cancelled as soon as possible to allow exchange of the cabin air and to avoid misting of the vehicle’s windows.
Exterior air intake
Press button 7 once to open the exterior air intake.
Page 74 of 189
90
III
A
B
C
D
Deactivation
A press on any of the buttons B, C or D, deactivates the automatic operation of the rear air condition-ing.
the warning lamp on button A goes out.
Note: If the air conditioning in the front of the cabin is stopped (func-tion deactivated in the "Air condi-tioning" menu or via the control 4 f o r a d j u s t i n g t h e a i r fl o w ) , t h e n t h e rear automatic air conditioning is not available.
ADJUSTING THE AIR FLOW
If you press buttons B or D you increase or decrease t h e fl o w f o r the rear air conditioning.
The number of diode(s) lit up, c o m p o s i n g t h e s y m b o l f o r a i r fl o w (helix, situated between buttons Band D) expresses its power level.
T o d e a c t i v a t e t h e a i r fl o w a n d a i r distribution for the rear air con-ditioning, press successively on button D so that all the diodes go out.
DISTRIBUTION TO FOOTWELLS/HEADS
Successive presses on button Cwill modify the distribution of the a i r fl o w .
Three directions are available:Passengers' heads.
Passenger footwells.Passengers' heads and footwells.
The arrow lit up indicates the dis-tribution of air chosen manually. In "AUTO" mode, no arrow lights up.
ADJUSTMENT OF THE FLOW OF AIR INTO THE STORAGE UNDER THE FRONT CENTRAL ARMREST
I f y o u c h o o s e a m a x i m u m fl o w of air in the rear by pressing Band distribution towards passen-ger's heads by pressing C, having closed the rear air vents, you will o b t a i n a m a x i m u m fl o w o f a i r i n t o the storage beneath the armrest.
Page 78 of 189
94
III
Replacing the battery
The remote control is powered by a 6V-28L battery cell, which is included.
Information appears on the screen when this battery should be replaced.
Unclip the casing and replace the battery.
The remote control must then be re-initialised, as described on this page.
Do not discard old batteries; take them to an approved recycling point.
Re-initialisation of the remote control
P R O G R A M M A B L E H E A T I N G
If the battery is disconnected or replaced, the remote control must be re-initialised.
A f t e r s w i t c h i n g o n , w i t h i n fi v e s e c -onds press button 4 (OFF) for 1 second.
If the operation is successful, the "OK" message appears in the remote control screen.
If not, the "FAIL" message appears. Repeat the procedure.
As a secondary advantage, use of your programmable heating sys-tem allows it to be used to pre-heat the passenger compartment.
Always switch off the program-mable heating while refuelling in o r d e r t o a v o i d t h e r i s k o f fi r e o r explosion.
To avoid the risk of intoxication or asphyxiation, the program-mable heating should not be used, even for a short time, in an enclosed space such as a garage, or workshop without exhaust gas extraction.
Do not park the vehicle over i n fl a m m a b l e m a t e r i a l s ( d r y grass, dead leaves, papers…), a s t h e r e i s a r i s k o f fi r e .
The programmable heating sys-tem is supplied by the vehicle’s fuel tank. Before using it, ensure t h a t t h e r e i s s u f fi c i e n t f u e l i n t h e tank. If the low fuel warning lamp is on we strongly recommend that you do not programme the heating to come on.
Page 81 of 189
97
III
A
BC
D
R E A R S E A T S
Seat cushion folded.
Stow the head restraints.
Press the control A located at the end of the backrest and fully tilt forwards.
The benchseat backrest can be folded in two sections. When you reposition the backrest, make sure that it locks in place.
Your vehicle's boot can be kept isolated from the passenger com-partment.
To lock the access to the boot:1. Place the benchseat in its correct position.The red warning lamp on control A should no longer be visible.
2. Insert the ignition key in the lock.3. Lock it.
LOCKING/UNLOCKING OF THE ACCESS INTO THE BOOT VIA THE REAR BENCHSEATREAR CENTRAL SEAT BELT
For easier opening of the seat belt cover D , y o u s h o u l d fi r s t r a i s e t h e central head restraint.
I n s e r t t h e fi r s t f a s t e n i n g C into the front left hand (black) buckle, then insert the second fastening B into the front right hand buckle.
Before moving the seats
So as to avoid damaging the seat belts by jamming them, take care to keep them to the sides of the backrest.
Page 99 of 189
115
IIIA
S U N R O O F
Glass sun roof
The sun roof is operated by the electrical control A.
A n a c t i o n t o t h e fi r s t n o t c h o f t h e control starts a movement which stops as soon as you release the control.
An action to the second notch of the control opens or closes the sun roof fully. A further action stops the movement.
ANTI-PINCH
An anti-pinch device is present to stop the sun roof from sliding shut. If it meets an obstacle it slides in the opposite direction.
After a battery disconnection or if there has been a malfunction, you have to re-initialise the anti-pinch function.
To do that, move the control A to the second notch to make the sun roof open fully, then keep the control A pressed for at least 1 seconds.
Warning: During this manœuvre, the anti-pinch does not operate.
Your vehicle's sun roof has a manually-operated blind.
Always remove the ignition key when leaving the vehicle, even if for a Short time.
In the event of anything being caught by the sun roof clos ing, you must reverse the roof movement.
To do that, reverse the position of the control concerned.
When the driver is operating the sun roof, he or she must always make sure that the passengers are not preven ting it from closing properly.
The driver must ensure that passengers use the sun roof control correctly.
PAY ESPECIAL ATTENTION TO WHERE CHILDREN ARE WHEN OPERATING THE SUN ROOF.
Page 101 of 189
118
IVA
B
C
D
L E V E L S
A i r fi l t e r
Follow the requirements set out in the Maintenance and Warranty Guide.
REFER TO THE CHAPTER: USER PRECAUTIONS.
Screen wash and h e a d l a m p w a s h fl u i d
Use CITROËN-approved products wherever possible.
Capacity: See "Capacity".
Engine coolant
T h e fl u i d l e v e l s h o u l d b e between the marks MIN. and MAX. on the header tank.
Engine hot, wait at least 15 minutes.
Quality: See "Maintenance and Warranty Guide".
Never do anything relating to the cooling system of an engine that is hot.
Poles "+" and "-" for starting with a slave battery
See "Starting with a slave battery".
Engine oil
Check the engine oil level on horizontal ground with the engine having been switched off for at least 15 minutes.
Quality: See "Maintenance and Warranty Guide".
Pull out the manual dips-tick.
The level should be between the marks MIN.and MAX. on the gauge.
It must never exceed the maximum.
MAX.
MIN.
B r a k e fl u i d
T h e l e v e l o f fl u i d s h o u l d b e between the marks MIN.and MAX. on the reservoir.
Quality: See "Maintenance and Warranty Guide".
If the warning lamp comes on while you are driving, stop imme-diately and contact a CITROËN while you are driving, stop imme- imme-
dealer.
Power steering and suspension oil
For topping up, it is neces-sary to go to a CITROËN For topping up, it is neces-neces-
dealer.
Quality: See "Maintenance and Warranty Guide".
If opening the bonnet when the engine is hot, even if it is stopped and the ignition is switched off, remember that the cooling fan may operate at any moment.
Between routine servicing visits, check the level of engine oil frequently as well as before going on a long journey.