Page 61 of 115
ACCESS and STARTING58 -
OPENING THE BONNET
Inside the vehicle: pull the handle on
t h e l e f t - h a n d s i d e , u n d e r t h e f a s c i a .
Outside the vehicle: lift the catch
a n d r a i s e t h e b o n n e t .
BONNET STRUT
Secure the strut to hold the bonnet
o p e n .
Before closing the bonnet, replace
t h e s t r u t i n i t s h o u s i n g .
FILLING WITH FUEL
W h e n t h e m i n i m u m
fuel level in the tank is
reached, this warning
l i g h t c o m e s o n . W h e n t h e c a p i s r e m o v e d ,
the right-hand sliding side
d o o r c a n n o t b e o p e n e d .
The key cannot be removed
from the lock until the cap
has been replaced on the
f u e l t a n k .
A label reminds you which type of
f u e l t o u s e .
W h e n y o u fi l l y o u r t a n k , d o n o t c o n -
tinue after the third cut-off of the
p u m p . T h i s c o u l d c a u s e y o u r v e h i c l e
t o m a l f u n c t i o n .
To close
Lower the bonnet and release it at
t h e e n d o f i t s t r a v e l .
C h e c k t h a t t h e b o n n e t i s l o c k e d .
Low fuel level
You have enough fuel remaining
to drive for approximately 30 miles
(50 km).
The engine must be switched off
w h e n fi l l i n g w i t h f u e l .
Insert the key then turn it to the
l e f t .
R e m o v e t h e c a p .
The capacity of the tank is approxi-
mately 55 litres for petrol engines
and 60 litres for Diesel engines.
A f t e r fi l l i n g t h e t a n k , l o c k t h e c a p .
Page 69 of 115
67COMFORT AND SAFETY-
LASHING RINGS
It is recommended that the
load is immobilised by securing
i t fi r m l y u s i n g t h e l a s h i n g r i n g s
o n t h e fl o o r .
Use the 6 lashing rings on the lug-
g a g e c o m p a r t m e n t fl o o r t o s e c u r e
your loads.
You can use suitable load retainers
(half-height partitions, grille, etc.) sup-
plied by the CITROËN network.
Page 71 of 115
69COMFORT AND SAFETY-
1.
Trays between the front and rear seats
2. Load-space cover
To install it:
- position the front ends of the load space cover on its support and press gently to put it in place,
- unfold the load space cover fully,
- position the rear ends of the load space cover on its support and press gently to put it in place.
To remove it:
- unclip the rear ends,
- fold the load space cover fully,
- unclip the front ends and remove the load space cover.
To store it, fold it like an accordion. Do not roll it . 3. Stowing rings
4. High load retaining net
T h e h i g h l o a d r e t a i n i n g n e t c a n b e fi t t e d behind the front or rear seats.
Open the covers A of the correspond-ing upper fastenings.
Fit the ends of the metal bar in these fastenings.
Secure the two net strap hooks be-hind the front seats, with the rear seat folded, or in the stowing rings B o n t h e fl o o r .
The rings are located directly below the corresponding upper fastenings.
Pull the two straps C taut.
5.
Side door storage compartments
6. Seat back storage pockets
