FUSES/TIPM
Cavity Cartridge
Fuse Mini-
Fuse Description
M27 — 10 Amp RedIgnition Switch
(IGN SW), Window
Module (WIN
MOD), PEM, Steer-
ing Column Lock
M28 — 10 Amp RedNext Generation
Controller (NGC),
PCM, Transmission
Feed (TRANS
FEED), TCM
M29 — 10 Amp RedOccupant Classifi-
cation Module
(OCM)FUSES/TIPM
Cavity Cartridge
Fuse Mini-
Fuse Description
M30 — 15 Amp BlueRear Wiper Module
(RR WIPER MOD),
Power Folding Mir-
ror (PWR FOLD
MIR), J1962 Diag-
nostic Feed
M31 — 20 Amp YellowBack-Up Lamps
(B/U LAMPS)
M32 — 10 Amp RedOccupant Restraint
Controller (ORC),
TT EUROPE
M33 — 10 Amp RedNext Generation
Controller (NGC),
Global Powertrain
Engine Controller
(GPEC), TCM
480 MAINTAINING YOUR VEHICLE
WARNING!
A transient high voltage occurs at the bulb sockets of
High Intensity Discharge (HID) headlamps when the
headlamp switch is turned ON. It may cause serious
electrical shock or electrocution if not serviced prop-
erly. See your authorized dealer for service.
NOTE: On vehicles equipped with High Intensity Dis-
charge (HID) headlamps, when the headlamps are
turned on, there is a blue hue to the lamps. This dimin-
ishes and becomes more white after approximately
10 seconds, as the system charges.
Quad Headlamps
1. Raise the hood to access the high or low beam bulbs at
the rear of the headlamp housing.
2. Release the two tabs on the side of the connector and
remove the connector from the bulb. 3. Twist the headlamp bulb and pull the bulb from the
headlamp housing.
4. Install the new headlamp bulb and twist until locked
into the headlamp housing.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
5. Reconnect the wiring connector to the bulb.
Front Park/Turn Signal Lamp
1. Raise the hood to access the rear of the headlamp
housing.
2. Twist the turn signal socket and remove from the
headlamp housing, then pull the bulb out.
484 MAINTAINING YOUR VEHICLE
