2009 CHEVROLET AVEO hood open

[x] Cancel search: hood open

Page 96 of 354

CHEVROLET AVEO 2009 1.G Owners Manual Content Theft-Deterrent
Your vehicle may have a content theft-deterrent system.
The theft-deterrent system will not arm when you lock
the doors using the key or the manual door lock. It arms
only when

Page 101 of 354

CHEVROLET AVEO 2009 1.G Owners Manual Engine Heater
The engine heater can provide easier starting and better
fuel economy during engine warm-up in cold weather
conditions at or below 0°F (−18°C). Vehicles with an
engine heater should

Page 141 of 354

CHEVROLET AVEO 2009 1.G Owners Manual Rear Window and Outside Mirror
Defogger
For vehicles with a rear window and outside mirror
defogger, they only work when the ignition is turned to
ON/RUN.
The rear window defogger uses a warming grid

Page 219 of 354

CHEVROLET AVEO 2009 1.G Owners Manual Filling a Portable Fuel Container
{CAUTION:
Never �ll a portable fuel container while it is in the
vehicle. Static electricity discharge from the
container can ignite the fuel vapor. You can be
badly

Page 220 of 354

CHEVROLET AVEO 2009 1.G Owners Manual Hood Release
To open the hood:
1. Pull the hood release
handle inside the
vehicle. It is located on
the lower left side of
the instrument panel.
2. Then go to the front of the vehicle and lift up on t

Page 239 of 354

CHEVROLET AVEO 2009 1.G Owners Manual If Steam Is Coming From The Engine
Compartment
{CAUTION:
Steam from an overheated engine can burn you
badly, even if you just open the hood. Stay away
from the engine if you see or hear steam coming
f

Page 247 of 354

CHEVROLET AVEO 2009 1.G Owners Manual Notice:If you leave the radio or other accessories
on during the jump starting procedure, they could be
damaged. The repairs would not be covered by the
warranty. Always turn off the radio and other
a

Page 252 of 354

CHEVROLET AVEO 2009 1.G Owners Manual Headlamps
To replace a headlamp bulb:
1. Open the hood. SeeHood Release on page 5-12.
2. Remove the three bolts to remove the headlamp
assembly.
3. Disconnect the wiring harness connector from the
rea
Page:   1-8 9-16 next >