2009 Alfa Romeo 8C window

104
4
AB
D
F
H
J
C
E
G
I
Controls A) Left-hand temperature controlB) Air conditioning compressor activation/
deactivationC) Left-hand air distribution controlD) Windscreen defogging/demistingE) Fan speed adjustmentF) Recirculation functionG) Right-hand air distribution controlH)
Rear window and external rear-view mirror
defogging/demisting
I) Right-hand temperature settingJ) Residual heat function.

106
4

Residual heat function J
This function allows the user to maintain the
temperature set for the passenger compartment
for a certain time (15 minutes), even after the
key has been turned to STOP. To activate this
function, push the “REST” button before turning
the key to STOP.
Once selected, this function is activated when
the key is turned to STOP and sets the following
features:
- bilevel air distribution
- compressor deactivation
- minimum fan speed
- air recirculation activation
- water recirculation pump activation
The system is deactivated after 15 minutes or
when the key is turned to MAR.
In addition, the REST function will be disabled
(if active), when the battery voltage is below
11.5V. When the outside temperature is above
25°C it will not be possible to activate the
function.

Air recirculation switch F
Released
the air flow comes from the outside.
When outside temperatures exceed 35 °C,
the air recirculation option remains on with a
120-second pause every twenty minutes, to
refresh the air.
Pressed (LED on)
The air flow comesfrom inside the passenger
compartment.
The recirculation speeds up air heating or
cooling.
Prolonged use is not advisable.

Windscreen defogging/
demisting switch D
Press this switch (LED on) to activate
windscreen defogging/demisting.
To deactivate this function, press the switch.

Defogging/demisting switch
H for rear window and
external rear-view mirrors
It is activated by operating the switch
H and
activation is signalled by the LED.
If it is not deactivated within thirty minutes
after activation, this function deactivates
automatically.
It is however advisable to deactivate it once the
defogging/demisting process is complete.
Once the internal temperature has stabilised at
the desired level, you are advised not to change
the position of the selector unless the external
temperature changes drastically.
A change in the position of the temperature
selection switch will involve a difference
between temperature inside the passenger
compartment and the air coming out of the
vents. This difference will gradually decrease as
the system works at full, stabilised speed.

114
5
MAR
STARTING THE
ENGINE
CAUTION
Hold the brake pedal depressed
when starting the engine.
CAUTION
It is dangerous to operate the
engine in an enclosed space. The engine
consumes oxygen and discharges
carbon dioxide, carbon monoxide and
other toxic gases.
WARNING: Before start-up, switch off the
electrical devices with a high power consumption
(air-conditioning and heating system, heated
rear window, headlights, etc.).
WARNING: Do not start the engine if the fuel
level in the tank is low.
1) Make sure that the parking brake is applied
and that the doors are closed.
2) Hold the brake pedal depressed when
starting the engine.
3) Do not depress the accelerator pedal.
4) Set the gear to neutral by pulling both
paddles UP and DOWN towards the
steering wheel and check that the gear
display indicates N not fl ashing.
5) Turn the ignition key to MAR.
6) press button START button and release it as
soon as the engine starts.
Do not hold the START button for a long time.If the engine does not start, turn the key back to
position STOP and wait for the gear display to go
off before retrying.
The engine can also be started with a gear
engaged; turning the key to position MAR, with
the brake pedal depressed, press the START
button. The system allows the clutch to open and
the gearshift to engage neutral gear; then the
starter motor receives clearance for start-up. This
procedure usually requires one second. At very
low temperatures, the procedure could take a
slightly longer time.
If the gearbox is instead in the N position,
starting is immediate.
If the engine does not start after turning the key
to position STOP, wait for the gear display to go
off and then repeat the entire procedure.

163
6
IN AN EMERGENCY
Relays in the passenger compartment, to the left of the steering wheelPos. Type Function
T01 Micro-relay 30A Low-beams
T11 Micro-relay 30A Heated rear window
T12 Micro-relay 30A Connected devices 1
T13 Maxi-relay 50A Connected devices 2
Fuses inside the passenger compartment, to the left of the steering wheel
Pos. Amp. Colour System / Component
F12 15A Light blue +30 Right-hand low beam
F13 15A Light blue +30 Left-hand low beam
F31 7.5A Brown INT/A For A.C. unit NBC (Body Computer Node)
F32 10A Red +30 dome lights, step lights, CAV, driver- and passenger-side footwell lights
F33 20A Yellow Position available
F34 20A Yellow Position available
F35 7.5A Brown +15 engine signals, coils R5, R6, R9, R24, SCC, door locking/unlocking control
F36 10A Red +30 NQS
F37 10A Red +15 NQS, left-hand and right-hand headlights
F38 15A Light blue Rear window lock

164
6
Pos. Amp. Colour System / Component
F39 10A Red +30 NIM, NCL, EOBD, NTP, CSA
F40 30A Green Heated rear window
F41 15A Light blue Not used
F42 7.5 Brown +15 weight sensors (USA only), airbag deactivation warning light
F43 30A Green Windscreen wipers
F44 20A Yellow Cigarette lighter (on centre console)
F45 25A White Not used
F46 15A Light blue Not used
F47 20A Yellow Not used
F48 20A Yellow Not used
F49 7.5A Brown +15 for CMD on centre console, small dashboard, rear-view mirror, emergency control light, NCL,
coil R19.
F50 7.5A Brown +15 Airbag system
F51 7.5A Brown +15 NCR, gear display (for BL)
F52 15A Light blue Position available
F53 10A Red +30 Rear fog lights

166
6
Relays inside the luggage compartmentPos. Type Function
R17 BOSCH micro-relay 20A 1st speed fuel pump
R18 BOSCH micro-relay 20A 2nd speed fuel pump
R19 Micro-relay 20A Reverse
R25 Micro-relay 20A Glove compartment motor
R26 Micro-relay 20A Third stop
R27 - Position available
Fuses inside the luggage compartment
Pos. Amp. Colour System / Component
F30 - - Position available
F54 20A Yellow Gearbox
F55 - - Position available
F56 - - Position available
F60 20A Yellow +30 NPG lock actuators (Driver door node), NPP (Passenger Door Node), left- and right-hand power
window motor electronics
F61 - - Position available
F63 20A Yellow +30 Fuel pump
F64 7.5A Brown +30 Reverse gear

197
8
MAINTENANCE
AIR FILTERHave the air filter replaced at an Authorised
Service Centre of the Manufacturer’s
Network.
ANTI-DUST/ANTI-
POLLEN FILTERThis filter performs mechanic/electrostatic air
filtering, provided that windows and doors are
fully closed.
Have the anti-pollen/dust filter replaced at least
once a year, at an Authorised Service Centre of
the Manufacturer’s Network preferably at the
beginning of the warm season.
If the vehicle is mainly used in the city traffic,
on highways or dusty roads, we recommend
that you replace the filters more frequently than
prescribed in the Maintenance Schedule.
WARNING: Failure to replace the filter may
considerably reduce the air conditioning and
heating system efficiency.
CAUTION
We advise you to have the
anti-pollen/dust filter replaced at
an Authorised Service Centre of the
Manufacturer’s Network.

205
8
MAINTENANCE
Normal paint maintenance consists in washing,
the frequency of which depends on the
conditions of use and of the environment.
For example, in areas where there is high
atmospheric pollution or if the roads are spread
with anti-freeze salt, it is advisable to wash the
vehicle more frequently. WARNING: Detergents pollute water. Therefore
the vehicle should be washed in areas equipped
for the collection and purification of the fluids
used for washing.For correct washing:
- Wet the bodywork with a low-pressure
water jet.
- Run a sponge soaked in a neutral detergent
solution over the bodywork, remembering
to rinse the sponge frequently.
- Thoroughly rinse with water and dry with a
jet of air or suede.
When drying, take particular care with the parts
that are less visible, such as the door bays, front
lid, headlight edges, in which water can be
trapped more easily. You are recommended not to take the vehicle
immediately into an enclosed environment, but
leave it in the open air so as to allow the water
to evaporate.
Do not wash the vehicle after it has been left in
the sun or when the hood is hot: the paint gloss
could be affected.
External plastic parts must be cleaned with the
same procedure followed for the normal washing
of the vehicle.
Avoid, as far as possible, parking the vehicle
under trees; the resinous substances that very
often drop from the trees give the paint a dull
appearance and increase the possibility of
originating corrosive processes.
WARNING: Bird droppings must be washed off
immediately and thoroughly, since their acidity is
particularly corrosive.
WARNING: To provide better protection for the
paint, polish the vehicle at regular intervals with
a suitable product leaving a protective film on
the paint.
Windows
To clean the windows use special detergents.
Only use clean cloths so as not to scratch the
windows or rendering them less transparent. WARNING: In order not to damage the electric
elements fitted inside the heated rear window,
rub gently following the direction of the
elements. ENGINE COMPARTMENT
At the end of each winter season, carefully wash
the engine compartment, remembering to not
direct the jet of water for too long on the ECUs
and on the relay and fuse boxes on the right-
hand side of the engine compartment (driving
direction). To perform this operation, you must
contact a specialised workshop. WARNING: Wash only when the engine is cold
and with the ignition key turned to STOP. After
washing, make sure that the various protections
(e.g. rubber boots/caps, guards etc.) have not
been removed or damaged.