2009 Acura TL bluetooth

Î
Î
Your vehicle is equipped with a
Bluetooth
audio system, which
allows you to listen to streaming
audio f rom your Bluetooth audio
compatible phone. This f unction is
only available on Bluetooth Audio
Compatible phones that are paired
and linked to the vehicle’s
Bluetooth
HandsFreeLink(HFL)
system (see page ).
Not all Bluetooth-enabled phones
with streaming audio capabilities are
compatible with the system. You can
f ind an approved phone by visiting ,orby
calling the HandsFreeLink
consumer support at 1-888-528-7876.
In Canada, visit , or call
1-888-9-ACURA-9.
In some states, it may be
illegal to perf orm some data device
f unctions while driving. Make sure that your phone is paired
and linked to the HFL.
Press the AUX button with the
ignition switch in the ACCESSORY
(I) or ON (II) position. The audio
displayshowstheBluetooth
Audio
message and mark. Until the phone
is recognized, you will see ‘‘NO
CONNECT’’ on the display. This
message will go of f when the phone
is recognized, then the system
begins to play. If more than one phone is paired to
the HFL system, there will be delay
bef ore the system begins to play.
Af ter a device is linked, press the
TITLE button to confirm the device
name. The name of the device will
appear on the audio display.
To begin to play the audio f iles, you
may need to operate your phone. If
so, f ollow the phone maker’s
operating instructions.
If an iPod, USB flash memory
device, or audio unit connected
to the auxiliary input jack was
selected at the last mode, you
will see iPod, USB, or AUX in
the audio display. Push the AUX
button again to play audio f iles
f rom your Bluetooth
Audio
phone.
:
392
www.acura.com/handsfree
link
www.acura.ca
CONT INUED
T o Play BluetoothAudio Files
BluetoothAudio System (Models without navigation system)
Features
273
NOTE:
\f—\f—\fy
\f\fy
) \f\fy\fy
2009 TL

In the following conditions, the
display shows ‘‘NO CONNECT’’
message.The phone is not linked to HFL. Press the side of the SKIP bar
to skip f orward to the next f ile, and
press the side to skip backward
to the beginning of the current f ile.
Push the side again to skip to
the previous f ile.
Turning the selector knob to the
right or lef t also changes a f ile.
The resume/pause mode can stop
playing a f ile temporarily. Press the
SETUP button to display the audio
settings.
Turn the selector to select
RESUME/PAUSE mode, then press
ENTER to set your selection. Repeat
to resume play.
Thepausefunctionmaynot
be available on some phone devices.
The phone is not turned on.
The phone is not in the vehicle.
Another HFL compatible phone,
which is not compatible f or
Bluetooth
Audio, is already
connected.
BluetoothAudio System (Models without navigation system)
T o skip a f ile
T o pause or resume a f ile
274
NOTE:
\f—
—y
\f

y
) \f\fy\fy
2009 TL

Af ter ending the call, press the HFL
Backbuttontogobacktothe
Bluetooth
Audio mode.
If you receive a call while the system
is in the pause mode, the mode will
be canceled and Bluetooth
Audio
will continue to play.
Press the SETUP button to display
the audio settings. Turn the selector
to select a desired sound mode, then
press ENTER to set your selection.
Turn the selector to your liking (see
page f or more sound setting
inf ormation). Select any other audio mode by
pressing a button: AM/FM, or
CD (if a disc is loaded), on the audio
control panel, or press the mode
buttononthesteeringwheelto
select another audio mode. If an iPod
or USB f lash memory device is
connected to the USB adapter cable,
or audio unit is connected to AUX
jack, pressing the AUX button also
changes the mode.
Switching to another mode pauses
the music playing f rom your phone.
If you receive a call when the
Bluetooth
Audio is playing, press
the HFL Talk button on the steering
wheel. The display switches to the
HFLmode(seepage ).
231 394
CONT INUED
To change sound settings
To switch to HFL mode To turn off the BluetoothAudio
mode
BluetoothAudio System (Models without navigation system)
Features
275
\f—
—y
\f

y
) \f\fy\f\fy
2009 TL

As required by the FCC:This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.
BluetoothAudio System (Models without navigation system)
276
\f—\f—y


y
) \f\fy\f
y
2009 TL

µµ µ
The SVC mode controls the volume
based on vehicle speed. The f aster
you go, the louder the audio volume
becomes. As you slow down, the
audio volume decreases.
Adjusts the strength of
sound f rom the center speaker.
To adjust the
strength of the sound f rom the
subwoof er speaker, select it and
press ENTER on the interf ace
selector. Turn the interf ace dial to
the desired level, and enter your
selection by pressing ENTER on the
interf ace selector. Dolby
PL (ProLogic) II signal processing
creates multi-channel surround
sound f rom 2 channel stereo audio
sources. Dolby ProLogic II can only
activate when listening to DISC
(CD-DA,MP3,WMA,AAC),XM
radio, AUX (USB, iPod
,AUX,
Bluetooth
Audio), and HDD Audio.
When ProLogic II is available, ‘‘PL
II’’ is shown in the audio display.
When ProLogic II is not available in
the selected audio source, ‘‘DPL2 N/
A’’ is shown on the center display.
The SVC has f our modes: OFF,
LOW, MID, and HIGH. The def ault
setting is MID. To change the SVC
mode, select SVC, then press
ENTER on the interf ace selector.
The current setting is shown on the
screen. Turn the interf ace dial to the
desired level, and enter your
selection by pressing ENTER on the
interf ace selector. If you f eel the
sound is too loud, choose low. If you
f eel the sound is too quiet, choose
high.
Speed-sensit ive Volume
Compensat ion (SVC)CENT ER
SUBWOOFER Dolby PL (ProL ogic) II
Playing the A M/FM Radio (Models with navigation system)
290
\f—
—y
\f
\f\fy
) \f\fy\fy
2009 TL

µ
Î
Turn the interf ace dial, select
Shuf f le and press ENTER on the
interf ace selector.
Turn the interf ace dial, select the
Album Shuf f le icon and press
ENTER on the interf ace selector.
Shuf f le playback of the album will
begin.
To cancel this f unction, turn the
interf ace dial and select the Shuf f le
OFFicon,andthenpressENTERon
the interf ace selector.
Available operating f unctions vary on
models or versions. Some f unctions
may not be available on the vehicle’s
audio system.
Shuf f les
playback of all available albums,
which are selected by the desired
list: playlists, artists, albums or songs.
This f unction can be selected at the
same time that Repeat Playback is
setup.
On the iPod screen, push the
interf ace selector down to display
AUDIO MENU. To play the radio, press the AM/FM,
or button. Press the DISC
button to switch to the disc mode.
Press the HDD/AUX button to
switch the audio mode between
HDD Audio, USB and Bluetooth
Audio.
You can disconnect the iPod at any
time when you see ‘‘OK to
disconnect’’ message in the iPod
display. Always make sure you see
‘‘OK to disconnect’’ message in the
iPod display bef ore you disconnect it.
Make sure to f ollow the iPod’s
instructions on how to disconnect
the dock connector f rom the USB
adapter cable.
2.
1. 3.
Playing an iPod(Models with navigation system)
T o Stop Playing Your iPod
ALBUM SHUFFLE
Disconnect ing an iPod
352
NOTE:
ALBUM SHUFFLE ICON
\f—
—y
\f

\fy
) \f\fy\fy
2009 TL

This f unction samples the f irst f ile in
each f older within the USB f lash
memory device.If you reconnect the same USB f lash
memory device, the system will
begin playing where it lef t of f .
On the USB main screen, push the
interf ace selector down to display
AUDIO MENU.
Turn the interf ace dial, select the
Scan icon and press ENTER on
the interf ace selector. Turn the interf ace dial, select
Folder Scan icon and press
ENTER on the interf ace selector.
The f irst f ile of the f irst f older is
sampled f or 10 seconds. If no other
operations are carried out, the f irst
f iles of the remaining f olders are
played f or 10 seconds. Af ter the f irst
f ile of the last f older is played back,
regular playback is resumed.
To cancel this f unction, turn the
interf ace dial and select the Scan
OFFicon,andthenpressENTERon
the interf ace selector. To play the radio, press the AM/FM,
or XM button. Press the DISC button
to switch to the disc mode. Press the
HDD/AUX button to switch the
mode between the HDD Audio, USB,
and Bluetooth
Audio.
1.
2. 3.
To Stop Playing a USB Flash
Memory Device
FOLDER SCAN
Playing a USB Flash Memory Device (Models with navigation system)
364
FOLDER SCAN ICON
\f—\f—y
\fy
) \f\fy\fy
2009 TL

CONT INUED
BluetoothAudio System (Models with navigation system)
Features
367
INTERFACE DIAL
TITLE BUTTON
SKIP BAR
CENTER DISPLAY
NAVIGATION SCREEN
AUDIO BUTTON HDD/AUX BUTTON
\f—\f—y
y
) \f\fy\fy
2009 TL