2009.5 Citroen C5 DAG air conditioning

III
61
C O M F O R T
Storing driving positions
System which takes into account the
settings of the driver's seat and air
conditioning. It enables you to store
up to two positions using the buttons
on the side of the driver's seat. Storing a position
Using buttons M/1/2

 Switch on the ignition.

 Adjust your seat.

 Press button M , then press but-
ton 1 or 2 within four seconds.
An audible signal is heard indicating
that the settings have been stored.
Storing a new position cancels the
previous position.
Recalling a stored position
Ignition on or engine running

 Briefl y press button 1 or 2 to re-
call the corresponding position.
An audible signal is heard indicating
the end of the adjustment.
When the ignition is on, after a few
consecutive position recalls, the
function will be deactivated until the
engine is started, to prevent dis-
charging of the battery. For your safety, avoid storing a
driving position while driving.
REAR HEAD RESTRAINTS
The rear head restraints can be re-
moved and have two positions:
- high, position for use,
- low, storage position.
To raise a head restraint, pull it up-
wards.
To lower it, press the lug then the
head restraint.
To remove it, place it in the high
position, push the lug and pull it
upwards.
To refi t it, engage the head restraint
rods in the holes taking care to re-
main in line with the seat back.
Never drive with the head restraints
removed, they must be in place
and correctly adjusted.

III
61
C O M F O R T
Storing driving positions
System which takes into account the
settings of the driver's seat and air
conditioning. It enables you to store
up to two positions using the buttons
on the side of the driver's seat. Storing a position
Using buttons M/1/2

 Switch on the ignition.

 Adjust your seat.

 Press button M , then press but-
ton 1 or 2 within four seconds.
An audible signal is heard indicating
that the settings have been stored.
Storing a new position cancels the
previous position.
Recalling a stored position
Ignition on or engine running

 Briefl y press button 1 or 2 to re-
call the corresponding position.
An audible signal is heard indicating
the end of the adjustment.
When the ignition is on, after a few
consecutive position recalls, the
function will be deactivated until the
engine is started, to prevent dis-
charging of the battery. For your safety, avoid storing a
driving position while driving.
REAR HEAD RESTRAINTS
The rear head restraints can be re-
moved and have two positions:
- high, position for use,
- low, storage position.
To raise a head restraint, pull it up-
wards.
To lower it, press the lug then the
head restraint.
To remove it, place it in the high
position, push the lug and pull it
upwards.
To refi t it, engage the head restraint
rods in the holes taking care to re-
main in line with the seat back.
Never drive with the head restraints
removed, they must be in place
and correctly adjusted.

XI
183
P R A C T I C A L I N F O R M A T I O N
Fuses under the bonnet
After a repair, take care to reclose
the cover.

Any repairs on the MAXI fuses
(that give additional protection),
located in the fuseboxes, must
be left to a
CITROËN

dealer.
Access to the fuses

 Undo each screw by a 1/4 turn.

 Change the fuse. Table of fuses

Fuse N° Rating Function

F1 20 A Engine control unit

F2 15 A Horn

F3 10 A Screen wash pump

F4 10 A Headlamp wash pump

F5 15 A Engine actuators

F6 10 A Air fl ow meter - Directional headlamps -
Diagnostic socket

F7 10 A Automatic gearbox lever lock - Power steering

F8 25 A Starter motor

F9 10 A Clutch switch - Stop switch

F10 30 A Engine actuators

F11 40 A Air conditioning blower

F12 30 A Wipers

F13 40 A BSI supply (ignition on)

F14 30 A -

F15 10 A Right-hand main beam

F16 10 A Left-hand main beam

F17 15 A Right-hand dipped beam

F18 15 A Left-hand dipped beam

F19 15 A Engine actuators

F20 10 A Engine actuators

F21 5 A Engine actuators