4-19
1
2
34
5
6
7
8
9
10
11
4. Loosen the locknut.
5. Turn the adjusting nut in direction (a) to in-
crease the spring preload and thereby harden
the suspension, and in direction (b) to de-
crease the spring preload and thereby soften
the suspension.NOTE:
A special wrench can be obtained at a Yamaha
dealer to make this adjustment.
The spring preload setting is determined by
measuring distance A, shown in the illustration.
The shorter distance A is, the higher the spring
preload; the longer distance A is, the lower the
spring preload. With each complete turn of the
adjusting nut, distance A is changed by 1.5 mm
1. Bolt
2. Air filter case
2 1
1. Spring preload adjusting nut
2. Locknut
3. Special wrench
2
1
(a)
(b)
3
8-6
1
2
3
4
5
6
78
9
10
11
10
*
Swingarm pivots
Check operation and for excessive play, and
replace bearings if necessary.
Lubricate with molybdenum disulfide grease.
√√√
11
*
Upper and lower
arm pivots
Lubricate with lithium-soap-based grease.
√√√
12 Drive chain
Check chain slack and adjust if necessary.
Check rear wheel alignment and correct if necess-
sary.
Clean and lubricate.
√√√√√
13
*
Drive chain rollers
Check for wear and replace if necessary.
√√√
14
*
Chassis fasteners
Make sure that all nuts, bolts, and screws are
properly tightened.
√√√√√
15
*
Shock absorber
assemblies
Check operation and correct if necessary.
Check for oil leakage and replace if necessary.
√√√
16
*
Rear suspension
relay arm and con-
necting arm pivot-
ing points
Check operation and correct if necessary.
Lubricate with lithium-soap-based grease.
√√√√
17
*
Steering shaft
Lubricate with lithium-soap-based grease.
√√√
18
*
Steering system
Check operation and repair or replace if damaged.
Check toe-in and adjust if necessary.
√√√√√
19
*
Engine mount
Check for cracks or other damage, and replace if
necessary.
√√√
NO. ITEMCHECK OR MAINTENANCE
JOBINITIAL EVERY
Whichev-
er comes
firstmonth136612
km
(mi)320
(200)1300
(800)2500
(1600)2500
(1600)5000
(3200)
hours 20 80 160 160 320
