2008 YAMAHA RHINO 700 key

8-127
However, if the vehicle must be jump-started, pro-
ceed as follows.
1. Turn the key to “OFF”.
2. Open the hood. (See pages 8-17–8-19 for
hood opening and closing procedures.)
3. Remove the battery compartment cover.
(See pages 8-131–8-135 for battery compart-
ment cover removal and installation proce-
dures.)
4. Remove the console. (See pages 8-21–8-23
for console removal and installation proce-
dures.)
5. Using a charged 12-volt battery, connect the
positive lead of the jumper cable to the posi-
tive terminal of the battery in the vehicle and
the other end of the positive lead to the posi-
tive terminal of the charged battery.
EE.book Page 127 Monday, October 8, 2007 4:48 PM

8-131 1. Quick fastener screw (× 2)
2. Battery compartment cover
1. Vis à serrage rapide (× 2)
2. Couvercle du compartiment de la batterie
1. Tornillo de fijación rápida (× 2)
2. Tapa del compartimento de la batería
1
2
5B410023
Fuse replacement
The main fuse, the fuel injection system fuse, and
the fuse box are located under the hood. (See
pages 8-17–8-19 for hood opening and closing
procedures.)
If a fuse is blown, turn off the main switch and in-
stall a new fuse of the specified amperage.
If a fuse is blown, replace it as follows.
1. Remove the quick fastener screws.
2. Remove the battery compartment cover by
lifting it up and pulling it out.
Turn the key to “OFF” and turn off the electrical cir-
cuit in question.NOTICE
To prevent accidental short-circuiting, turn off
the main switch when checking or replacing a
fuse.
EE.book Page 131 Monday, October 8, 2007 4:48 PM

8-135
4. Turn the key to “ON” and turn on the electrical
circuit in question to check if the device oper-
ates.
5. If the fuse blows again immediately, have a
Yamaha dealer check the electrical system.
6. Reinstall the battery compartment cover by
installing the quick fastener screws.
7. Close the hood.
EE.book Page 135 Monday, October 8, 2007 4:48 PM

11-1
1-CONSUMER INFORMATION
EVU00090
Identification number records
Record the key identification number, vehicle iden-
tification number, and model label information in
the spaces provided for assistance when ordering
spare parts from a Yamaha dealer or for refer-
ence, in case the vehicle is stolen.
1. KEY IDENTIFICATION NUMBER:ACA-02E2. VEHICLE IDENTIFICATION NUMBER:ACA-02E3. MODEL LABEL INFORMATION:ACA-01E
EE.book Page 1 Monday, October 8, 2007 4:48 PM

11-3 1. Key identification number
1. Numéro d’identification de la clé
1. Número de identificación de la llave
EVU00100
Key identification number
The key identification number is stamped on the
key, as shown in the following illustration.
This number can be used for ordering a new key.
EE.book Page 3 Monday, October 8, 2007 4:48 PM