561
2008 TUNDRA from Apr. ’08 Prod. (OM 34477U)
As you might have difficulty in
identifying a flat or deflated tire, a tire
pressure warning system is provided on
this vehicle.
When replacing the wheels, be sure to
install tire pressure warning valves and
transmitters on the wheels. Consult your
Toyota dealer about how to set up the tire
pressure warning valves and transmitters.
CAUTION
Have the tires, wheels or tire pres-
sure warning valves and transmit-
ters replaced and ID codes regis-
tered by Toyota dealer. If you need
tire pressure warning valves and
transmitters, purchase from Toyota
dealer.
The tire pressure warning valve and
transmitter nuts should always be
tightened to a torque of 4 N·m (0.4
kgf·m, 2.9 ft·lbf).
The use of non genuine wheels may
result in the tire pressure warning
system failure or air leak.
WHEN TO REPLACE YOUR WHEELS
If you have wheel damage such as
bending, cracks or heavy corrosion, the
wheel should be replaced.
If you fail to replace a damaged wheel,
the tire may slip off the wheel or cause
loss of handling control.
WHEEL SELECTION
When replacing wheels, care should be
taken to ensure that the wheels are re-
placed by ones with the same load ca-
pacity, diameter, rim width, and offset.
Correct replacement wheels are available
at your Toyota dealer.
A wheel of a different size or type may
adversely affect handling, wheel and bear-
ing life, brake cooling, speedometer/odom-
eter calibration, stopping ability, headlight
aim, bumper height, vehicle ground clear-
ance, and tire or snow chain clearance to
the body and chassis. Replacement with used wheels is not rec-
ommended as they may have been sub-
jected to rough treatment or high mileage
and could fail without warning. Also, bent
wheels which have been straightened may
have structural damage and therefore
should not be used. Never use an inner
tube in a leaking wheel which is designed
for a tubeless tire.
CAUTION
Observe the following instructions.
Otherwise, an accident may occur re-
sulting in death or serious injuries.
Do not use wheels other than the
manufacturer ’s recommended size,
as this may cause dangerous han-
dling characteristics resulting in
loss of control.
Four wheel drive models:
Do not use wheels of different
brands, sizes and types, as this
may cause dangerous handling
characteristics resulting in loss of
control.
Replacing wheels
578
2008 TUNDRA from Apr. ’08 Prod. (OM 34477U)
Tw o−wheel drive models
mm (in.)
Cabin type
Regular cab modelsDouble cab modelsCrew Max models
Bed typeStandard bedLong bedStandard bedLong bedShort bed
Overall length5330 (209.8)5810 (228.7)5810 (228.7)6290 (247.6)5810 (228.7)
Overall width2030 (79.9)2030 (79.9)2030 (79.9)2030 (79.9)2030 (79.9)
Overall height1930 (75.9)∗ 11925 (75.7)∗11930 (75.9)∗11925 (75.7)∗11925 (75.7)∗1
1925 (75.7)∗2, ∗
31920 (75.5)∗21925 (75.7)∗2, ∗
31920 (75.5)∗21920 (75.5)∗2, ∗
3
Wheelbase3220 (126.7)3700 (145.6)3700 (145.6)4180 (164.5)3700 (145.6)
Front tread1725 (67.9)1725 (67.9)1725 (67.9)1725 (67.9)1725 (67.9)
Rear tread1725 (67.9)1725 (67.9)1725 (67.9)1725 (67.9)1725 (67.9)
∗1: With P255/70R18 tires
∗ 2: With P275/65R18 tires
∗3: With P275/55R20 tires
Dimensions
579
2008 TUNDRA from Apr. ’08 Prod. (OM 34477U)
Four−wheel drive models
mm (in.)
Cabin type
Regular cab modelsDouble cab modelsCrew Max models
Bed typeStandard bedLong bedStandard bedLong bedShort bed
Overall length5330 (209.8)5810 (228.7)5810 (228.7)6290 (247.6)5810 (228.7)
Overall width2030 (79.9)2030 (79.9)2030 (79.9)2030 (79.9)2030 (79.9)
Overall height1940 (76.3)∗ 11935 (76.1)∗11940 (76.3)∗11935 (76.1)∗11935 (76.1)∗1
1935 (76.1)∗2, ∗
31930 (75.9)∗21935 (76.1)∗2, ∗
31930 (75.9)∗21930 (75.9)∗2, ∗
3
Wheelbase3220 (126.7)3700 (145.6)3700 (145.6)4180 (164.5)3700 (145.6)
Front tread1725 (67.9)1725 (67.9)1725 (67.9)1725 (67.9)1725 (67.9)
Rear tread1725 (67.9)1725 (67.9)1725 (67.9)1725 (67.9)1725 (67.9)
∗1: With P255/70R18 tires
∗ 2: With P275/65R18 tires
∗3: With P275/55R20 tires