2008 TOYOTA LAND CRUISER GUR

36 1−2. Opening, closing and locking the doors
*1: A message will be shown on the multi−information display in the instru−
ment cluster.
*2: If the engine does not start when the electronic key is inside the vehicle,
the electronic key battery may be depleted or there may be difficulties
receiving signal front the key. (
P. 481)
nIf the smart key system does not operate properly
l
Locking and unlocking the doors: Use the mechanical key. ( P. 481)
lStarting the engine: P. 150
n
P. 410
nCustomization that can be configured at Toyota dealer
Settings (e.g. smart key system) can be changed. (Customizable features
P. 519)
AlarmSituation Correction procedure
Interior alarm
pings once and
exterior alarm
sounds 3 times
*1
The driver ’s door was
closed after the key was
carried outside the vehicle,
and the “ENGINE START
STOP” switch was not
turned OFFTurn the “ENGINE
START STOP” switch
OFF and close the
driver ’s door again
An occupant carried the
electronic key outside the
vehicle and closed the
door while the “ENGINE
START STOP” switch was
not OFF
Bring the electronic
key back into the vehi−
cle

41
1−2. Opening, closing and locking the doors
1
Before driving
n2step unlocking function
When you press the button, the driver ’s door is unlocked. Pressing
the button again within 3 seconds unlocks the other doors.
nOperation signals
Doors: A buzzer sounds and the emergency flashers flash to indicate that
the doors have been locked/unlocked. (Locked: Once; Unlocked: Twice)
Windows and moon roof: A buzzer s
ounds when the windows and moon roof
begin to open.
n
P. 3 0
n
P. 3 3
nAlarm
Using the wireless remote control to lock the door will set the alarm system.
(P. 97)
n
P. 481
nIf the wireless remote control does not operate properly
l
Locking and unlocking the doors: Use the mechanical key. ( P. 481)
lStarting the engine: ( P. 149)
n
P. 410
n
P. 3 0
nCustomization that can be configured at Toyota dealer
Settings (e.g. 2−step unlocking function) can be changed. (Customizable
features
P. 519)

46 1−2. Opening, closing and locking the doors
When the setting or canceling operation is complete, all doors are
locked and then unlocked.
FunctionShift leverpositionSwitch position
Shift position linked door lock−
ing function
“P”
Shift position linked door
unlocking function
Speed linked door locking func−
tion
“N”
Driver ’s door linked door unlock−
ing function
nImpact detection door lock release system
In the event that the vehicle is subject to a strong impact, all the doors are
unlocked.
Depending on the force of the impact or the type of accident, however, the
system may not operate.
nUsing the mechanical key
The doors can also be locked and unlocked with the mechanical key.
(P. 481)
nCustomization that can be configured at Toyota dealer
Settings (e.g. unlocking function using a key) can be changed. (Customiz−
able features
P. 519)

84 1−4. Opening and closing the windows and moon roof
nThe power windows can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode.
nLinked door lock window operation
lThe power windows can be opened and closed using the mechanical
key. ( P. 43)
lThe power windows can be opened using the wireless remote control.
(P. 40)
lThe power windows can be closed using the smart key system.
nOperating the power windows after turning the “ENGINE START STOP”
switch OFF
The power windows can be operated for approximately 45 seconds even
after the “ENGINE START STOP” switch is turned ACCESSORY mode or
turned OFF. They cannot, however, be operated once the driver ’s or front
passenger ’s door is opened.
nJam protection function
If an object becomes caught between the window and the window frame,
window travel is stopped and the window is opened slightly.
nCustomization that can be configured at Toyota dealer
Settings (e.g. linked door lock operation) can be changed. (Customizable
features P. 519)

88 1−4. Opening and closing the windows and moon roof
nMoon roof open warning buzzer
The buzzer sounds and message is shown on the multi−information display
in the instrument panel when the “E NGINE START STOP” switch is turned
OFF and the driver ’s door is opened with the moon roof open.
nCustomization that can be configured at Toyota dealer
Settings (e.g. linked door lock operation) can be changed. (Customizable
features
P. 519)
CAUTION
nOpening the moon roof
Observe the following precautions.
Failing to do so may cause death or serious injury.
lDo not allow any passengers to put their hands or heads outside the vehi−
cle while it is moving.
lDo not sit on top of the moon roof.
nClosing the moon roof
Observe the following precautions.
Failing to do so may result in death or serious injury.
lCheck to make sure that all passengers do not have any part of their bod−
ies in a position where they could be caught when the moon roof is being
operated.
lDo not allow children to operate the moon roof.
Closing the moon roof on someone can cause death or serious injury.
nJam protection function
lNever try jamming any part of your body to activate the jam protection
function intentionally.
l
The jam protection function may not work if something gets caught just
before the moon roof fully closes.

216 2−5. Driving information
Capacity and distribution
Cargo capacity depends on the total weight of the occupants.
(Cargo capacity) = (Total load capa
city) — (Total weight of occupants)
Steps for Determining Correct Load Limit—
(1) Locate the statement “The co
mbined weight of occupants and
cargo should never exceed XXX kg or XXX lbs.” on your vehi−
cle’s placard.
(2) Determine the combined weight of the driver and passengers
that will be riding in your vehicle.
(3) Subtract the combined weight of
the driver and passengers from
XXX kg or XXX lbs.
(4) The resulting figure equals the available amount of cargo and
luggage load capacity.
For example, if the “XXX” amount
equals 1400 lbs. and there will
be five 150 lb passengers in your vehicle, the amount of avail−
150) = 650 lbs.)
(5) Determine the combined weight of luggage and cargo being
loaded on the vehicle.
That weight may not safely ex
ceed the available cargo and lug−
gage load capacity calculated in Step 4.
(6) If your vehicle will be towing a trailer, load from your trailer will
be transferred to your vehicle. Consult this manual to determine
how this reduces the available cargo and luggage load capacity
of your vehicle. (
P. 221)