2008 TOYOTA LAND CRUISER tow

5
When trouble arises
441 5−1. Essential information
nEmergency towing procedure
The engine must be in ACCESSORY mode (engine off) or IGNI−
TION ON mode (engine running).
Put the four−wheel drive control switch in “H4”. (The center differen−
tial is unlocked.)
Put the shift lever in “N”.
Release the parking brake.
CAUTION
nWhile towing
lUse extreme caution when towing the vehicle.
Avoid sudden starts or erratic driving maneuvers which place excessive
stress on the emergency towing hook and the cable or chain.
lIf the engine is not running, the power assist for the brakes and steering
will not function, making steering and braking more difficult.
NOTICE
nTo prevent causing serious damage to the transmission
lNever tow this vehicle wheels on the ground.
l
Use only the front emergency towing hooks or towing eyelets (depending
on vehicles) when towing your vehicle.
STEP1
STEP 2
STEP 3
STEP 4

442 5−1. Essential information
Towing with a slingtype truck
NOTICE
nTo prevent body damage
Do not tow with a sling type truck, either from the front or rear.

5
When trouble arises
443 5−1. Essential information
Towing with a wheel lifttype truck
From front
Use a towing dolly under the rear
wheels.
From rear
Use a towing dolly under the
front wheels.
NOTICE
nTo prevent causing serious damage to the transmission
Never tow this vehicle wheels on the ground.
nTo prevent damaging the vehicle
lDo not tow the vehicle with the “ENGINE START STOP” switch off.
The steering lock mechanism is not strong enough to hold the front wheel
straight.
l
When raising the vehicle, ensure adequate ground clearance for towing at
the opposite end of the raised vehicle. Without adequate clearance, the
vehicle could be damaged while being towed.

444 5−1. Essential information
Using a flat bed truck
If your Toyota is transported by a
flat bed truck, it should be tied
down at the locations shown in
the illustration.
If you use chains or cables to tie
down your vehicle, the angles
shaded in black must be 45 .
Do not overly tighten the tie
downs or the vehicle may be
damaged.
ITY51C021
ITY51C022
NOTICE
nTo avoid serious damage to your vehicle
Do not use the rear emergency towing
hook.
ITY51C023

472 5−2. Steps to take in an emergency
Firmly tighten each nut two or
three times in the order shown in
the illustration.
Tightening torque:
97 ftlbf (131 Nm, 13.4 kgfm)
Reinstall the wheel ornament.
Stowing the flat/spare tire, jack and tools
Lay down the tire with the outer
side facing up, and install the
holding bracket.
Raise the tire.
Pull the tire towards the rear of the vehicle when raising. After
raising, visually check that tire
is not interfering with compo−
nents.
Stow the tools and jack securely, and replace all covers.
STEP4
STEP 5
ITY52C033
STEP1
STEP 2
STEP 3

5
When trouble arises
475 5−2. Steps to take in an emergency
NOTICE
n Do not drive the vehicle with a flat tire
Do not continue driving with a flat tire.
Driving even a short distance with a flat tire can damage the tire and the
wheel beyond repair.
n When stowing the flat tire
Ensure that there is no object cau ght between the tire and the vehicle
underbody.
n When replacing the tires
lWhen removing or fitting the wheels, tires or the tire pressure warning
valve and transmitter, contact your Toyota dealer as the tire pressure
warning valve and transmitter may be damaged if not handled cor−
rectly.
lReplace the grommets for the tire pressure warning valves and trans−
mitters as well.
n To avoid damaging the tire pressure warning valves and transmit
ters
Do not use liquid sealants on flat tires.

5
When trouble arises
491
5−2. Steps to take in an emergency
If the vehicle becomes stuck
CAUTION
nWhen attempting to free a stuck vehicle
If you choose to rock the vehicle back and forth to free it, make sure the sur−
rounding area is clear, to avoid striki ng other vehicles, objects or persons.
The vehicle may also lunge forward or lunge back suddenly as it becomes
free. Use extreme caution.
nWhen shifting the shift lever
Be careful not to shift the shift lever with the accelerator pedal depressed.
This may lead to unexpected rapid acceleration of the vehicle that may
cause an accident and result in death or serious injury.
NOTICE
nTo avoid damaging the transmission and other components
lAvoid spinning the wheels and do not rev the engine.
l
If the vehicle remains stuck after trying these procedures, the vehicle may
require towing to be freed.
Carry out the following procedures if the tires spin or the vehicle
becomes stuck in mud, dirt, or snow.
Stop the engine. Set the parki ng brake and shift the shift
lever in “P”.
Remove the mud, snow or sand from around the stuck tire.
Place wood, stones or some other material to help provide
traction under the tires.
Restart the engine.
Turn off VSC. (
P. 203)
Shift the shift lever to “D” or “R” position and carefully apply
the accelerator to free the vehicle.
STEP1
STEP 2
STEP 3
STEP 4
STEP 5
STEP6

494
6−1. Specifications
Maintenance data (fuel, oil level, etc.)
Dimensions and weight
*: Unladen vehicle
Overall length194.9 in. (4950 mm)
Overall width
77.6 in. (1970 mm)
Overall height
*74.0 in. (1880 mm)
Wheelbase
112.2 in. (2850 mm)
TreadFront64.6 in. (1640 mm)
Rear
64.4 in. (1635 mm)
Vehicle capacity weight
(Occupants + luggage)
1235 lb. (560 kg)
Towing capacity
(trailer weight + cargo weight)
8500 lb. (3856 kg)