2008 TOYOTA LAND CRUISER lock

65
1
1−3. Adjustable components (seats, mirrors, steering wheel)
Before driving
Head restraints
Front seats, second seats
Vertical adjustment
Press and hold the lock
release button when lowering
the head restraint.
Angle adjustment (front
seats only)
Removal
Pull the head restraint up while
pressing the lock release but−
ton.
Lock
release
button
ITY13C105
ITY13C106
lock
release
button

66 1−3. Adjustable components (seats, mirrors, steering wheel)
Third outboard seats
To f o l d
Pull the head restraint angle
lever to fold the head restraint.
Third center seat
Removal
Pull the head restraint up while
pressing the lock release but−
ton.
ITY13C040
ITY13C041
lock
release
button

68 1−3. Adjustable components (seats, mirrors, steering wheel)
nInstalling the third outboard seat head restraints
Align the head restraint with the installation holes.
Push down the head restraint to the lock position.
nWhen not using the third center seat head restraint
CAUTION
nHead restraint precautions
Observe the following precautions regarding the head restraints. Failure to
do so may result in death or serious injury.
lUse the head restraints designed for each respective seat.
lAdjust the head restraints to the correct position at all times.
lAfter adjusting the head restraints, push down on them and make sure
they are locked in position.
l
Do not drive with the head restraints removed.
STEP1
STEP 2
Open the zipper on the back of the third
seat and stow the head restraint inside.
ITY13C043

72 1−3. Adjustable components (seats, mirrors, steering wheel)
Seat belt pretensioners (front, second outboard seats)
The pretensioner helps the seat
belt to quickly restrain the occu−
pant by retracting the seat belt
when the vehicle is subjected to
certain types of severe frontal
collision.
The pretensioner may not acti−
vate in the event of a minor frontal
impact, a side impact or a rear
impact.
Precollision seat belts (front seats of vehicles with precollision
system)
When operating in the event of sudde n braking, the seat belts lessen
collision injury by retracting the slac
k in the front seat belts before the
collision, thus restraining the driver and passenger at an earlier
stage. (
P. 208)
nEmergency locking retractor (ELR)
The retractor will lock the belt during a sudden stop or on impact. It may also
lock if you lean forward too quickly. A slow, easy motion will allow the belt to
extend, and you can move around fully.
nAutomatic locking retractor (ALR)
When a passenger ’s shoulder belt is completely extended and then
retracted even slightly, the belt is locked in that position and cannot be
extended. This feature is used to hold the child restraint system (CRS) firmly.
To free the belt again, fully retract the belt and then pull the belt out once
more. (
P. 127)

75
1−3. Adjustable components (seats, mirrors, steering wheel)
1
Before driving
CAUTION
nWhen using the third center seat belt
nSeat belt damage and wear
lDo not damage the seat belts by allowing the belt, plate or buckle to be
jammed in the door.
lInspect the seat belt system periodically. Check for cuts, fraying, and loose
parts. Do not use a damaged seat belt until it is replaced. Damaged seat
belts cannot protect an occupant from death or serious injury.
lEnsure that the belt and tab are locked and the belt is not twisted. If the
seat belt does not function correctly, immediately contact your Toyota
dealer.
lReplace the seat assembly, including the belts, if your vehicle has been
involved in a serious accident, even if there is no obvious damage.
l
Do not attempt to install, remove, modify, disassemble or dispose of a seat
belt. Have any necessary repairs carried out by your Toyota dealer. Inap−
propriate handling of the pretensioner may cause it to activate or operate
improperly and may cause death or serious injury.
Do not use the third center seat belt with
either buckle released. Fastening only
one of the buckles may result in death or
serious injury in case of sudden braking
or a collision.

83
1
Before driving
1−4. Opening and closing the windows and moon roof
Power windows
Lock switch
Press the switch down to lock
passenger window switches.
Use this switch to prevent chil−
dren from accidentally opening or
closing a passenger window. The power windows can be opened and closed using the following
switches.
Closing
One−touch closing
*
Opening
One−touch opening
*
*
: Pressing the switch in the
opposite direction will stop
window travel partway.

84 1−4. Opening and closing the windows and moon roof
nThe power windows can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode.
nLinked door lock window operation
lThe power windows can be opened and closed using the mechanical
key. ( P. 43)
lThe power windows can be opened using the wireless remote control.
(P. 40)
lThe power windows can be closed using the smart key system.
nOperating the power windows after turning the “ENGINE START STOP”
switch OFF
The power windows can be operated for approximately 45 seconds even
after the “ENGINE START STOP” switch is turned ACCESSORY mode or
turned OFF. They cannot, however, be operated once the driver ’s or front
passenger ’s door is opened.
nJam protection function
If an object becomes caught between the window and the window frame,
window travel is stopped and the window is opened slightly.
nCustomization that can be configured at Toyota dealer
Settings (e.g. linked door lock operation) can be changed. (Customizable
features P. 519)

87
1−4. Opening and closing the windows and moon roof
1
Before driving
nThe moon roof can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode.
nLinked door lock moon roof operation
lThe moon roof can be opened and closed using the mechanical key.
(P. 43)
lThe moon roof can be opened using the wireless remote control.
(P. 40)
lThe moon roof can be closed using the smart key system.
n
Operating the moon roof after tu rning the “ENGINE START STOP”
switch OFF
The moon roof can be operated for approximately 45 seconds even after the
“ENGINE START STOP” switch is turned to ACCESSORY mode or turned
OFF. It cannot, however, be operated once the driver ’s or front passenger ’s
door is opened.
nJam protection function
If an object is detected between the moon roof and the frame while closing
or tilting down, travel is stopped and the moon roof opens slightly.
nIf the moon roof cannot be closed automatically
Keep the switch depressed.
nTo reduce moon roof wind noise
Drive with the moon roof opened automatically (just before fully opened
position).
nSunshade
The sunshade can be opened and closed manually. However, the sunshade
will open automatically when the moon roof is opened.