2008 TOYOTA LAND CRUISER Shift lock

421
4−3. Do−it−yourself maintenance
4
Maintenance and care
nDriver ’s side instrument panel
FuseAmpere Circuit
1 CIG 15 A Cigarette lighter
2 BK/UP LP 10 A Back−up lights, trailer
3 ACC 7.5 AStereo component amplifier
assembly, multi−display
assembly, gateway ECU, radio
receiver assembly, main body
ECU, mirror ECU, rear seat
entertainment, smart key sys−
tem, clock
4 PANEL 10 A
Four−wheel drive system, ash−
tray, cigarette lighter, brake
controller, cool box, cruise con−
trol, center differential lock,
DAC, multi−display assembly,
seat heater, air conditioning
system, glove box light, emer−
gency flasher, radio receiver
assembly, headlight cleaner,
inverter, driving position mem−
ory system, mirror ECU, over−
head module, roll sensing of
curtain shield airbags off
switch, shift lever switch, steer−
ing switches, VSC, console
switch

422 4−3. Do−it−yourself maintenance
5 ECU−IG NO.2 10 AAir conditioning system,
heater, overhead module,
ABS, VSC, steering sensor,
yaw rate & G sensor, main
body ECU, stoplights, moon
roof, clock, EC mirror
6 WINCH 5 A No circuit
7 A/C IG 10 ACool box, condenser fan,
cooler compressor, MG CL,
rear window defogger, RR
MGC VLV
8 TA I L 15 ATail lights, license plate lights,
front fog lights, front side
marker lights, rear side marker
lights, parking lights
9 WIPER 30 A Windshield wiper
10 WSH 20 A Windshield washer
11 RR WIPER 15 A Rear wiper
12 4WD 20 A 4WD
13 LH−IG 5 AAlternator, sub battery, seat
heater, windshield wiper de−
icer, seat belt pretensioners,
emergency flasher, inverter,
shift lever switch
14 ECU−IG NO.1 5 AABS, VSC, tilt and telescopic
steering, gateway ECU, shift
lock system, cruise control sys−
tem, pre−collision seat belt,
headlight cleaner, multi−dis−
play assembly, driving position
memory system, power door
lock system
15 S/ROOF
25 A Moon roof
FuseAmpereCircuit

5
When trouble arises
441 5−1. Essential information
nEmergency towing procedure
The engine must be in ACCESSORY mode (engine off) or IGNI−
TION ON mode (engine running).
Put the four−wheel drive control switch in “H4”. (The center differen−
tial is unlocked.)
Put the shift lever in “N”.
Release the parking brake.
CAUTION
nWhile towing
lUse extreme caution when towing the vehicle.
Avoid sudden starts or erratic driving maneuvers which place excessive
stress on the emergency towing hook and the cable or chain.
lIf the engine is not running, the power assist for the brakes and steering
will not function, making steering and braking more difficult.
NOTICE
nTo prevent causing serious damage to the transmission
lNever tow this vehicle wheels on the ground.
l
Use only the front emergency towing hooks or towing eyelets (depending
on vehicles) when towing your vehicle.
STEP1
STEP 2
STEP 3
STEP 4

5
When trouble arises
477 5−2. Steps to take in an emergency
Emergency start function
When the engine does not start, the following steps can be used as
an interim measure to start the engine if the “ENGINE START STOP”
switch is functioning normally.
Set the parking brake.
Put the shift lever in “P”.
Set the “ENGINE START ST
OP” switch to ACCESSORY
mode.
Press and hold the “ENGINE START STOP” switch about 15
seconds while depressing the brake pedal firmly.
Even if the engine can be start
ed using the above st eps, the system
may be malfunctioning. Have the vehicle checked by your Toyota
dealer. nThe starter motor does not turn over, the interior lights and
headlights do not turn on, or the horn does not sound.
One of the following may be the cause of the problem.
l
One or both of the battery terminals may be disconnected.
l
The battery may be discharged. ( P. 484)
lThere may be a malfunction in the steering lock system.
Contact your Toyota dealer if the problem cannot be repaired, or if
repair procedures are unknown.
STEP1
STEP 2
STEP 3
STEP 4

478
5−2. Steps to take in an emergency
If the shift lever cannot be shifted from P
If the shift lever cannot be shifted with your foot on the brake, there
may be a problem with the shif
t lock system (a system to prevent
accidental operation of the shift lever). Have the vehicle inspected by
your Toyota dealer immediately.
The following steps may be used as an emergency measure to
ensure that the shift
lever can be shifted.
Set the parking brake.
Set the “ENGINE START STOP” switch to the ACCES−
SORY mode.
Depress the brake pedal.
Pry the cover up with a flat−
head screwdriver or equiva−
lent.
Press the shift lock override
button.
The shift lever can be shifted
while the button is pressed.
STEP1
STEP 2
STEP 3
STEP 4
P
R
N
+
SD
ITY51C041
P
R
N
+
SD
ITY51C042
STEP5

5
When trouble arises
483 5−2. Steps to take in an emergency
nStopping the engine
Shift the shift lever to “P” and press the “ENGINE START STOP” switch as
you normally do when stopping the engine.
nReplacing the key battery
As this procedure is a temporary measure, it is recommended that the elec−
tronic battery be replaced immediately when the battery depletes. ( P. 410)
nAlarm
Using the mechanical key to lock the doors will not set the alarm system.
If a door is unlocked using the mechanical key when the alarm system is set,
the alarm may be triggered. (
P. 97)

500 6−1. Specifications
Automatic transmission
Transfer
Brakes
*1: Minimum pedal clearance when depressed with a force of 110 lbf (490 N, 50
kgf) while the engine is running.
*2: Parking brake pedal travel when pulled with a force of 45 lbf (200 N, 20 kgf).
Fluid
capacityWithout oil cooler11.5 qt. (10.9 L, 9.6 Imp.qt.)
With oil cooler
11.7 qt. (11.1 L, 9.8 Imp.qt.)
Fluid type Toyota Genuine ATF WS
NOTICE
Using transmission fluid other than “Toyota Genuine ATF WS” may cause
deterioration in shift quality, locking up of your transmission accompanied by
vibration, and ultimately damage the transmission of your vehicle.
Oil capacity
1.53 qt. (1.45 L, 1.28 lmp.qt.)
Oil type
Gear oil API GL−5
Recommended oil viscosity
SAE75W−90
Pedal clearance
*13.62 in. (92 mm) Min.
Pedal free play 0.04 0.24 in. (1.0
6.0 mm)
Brake pad wear limit
0.04 in. (1.0 mm)
Parking brake lining wear limit
0.04 in. (1.0 mm)
Parking brake adjustment
*25 7 clicks
Fluid type
SAE J1703 or FMVSS No. 116 DOT 3

520 6−2. Customization
ItemFunctionDefault settingCustomized
setting
Door lock
(
P. 43)Unlocking using a keyDriver ’s door
unlocked in
one step, all
doors
unlocked in
two stepsAll doors
unlocked in one
step
Speed−detecting auto−
matic door lock functionOFF ON
Shift the shift lever to
position other than “P”
locks all doorsON OFF
Shift the shift lever to
“P” unlocks all doorsON OFF
Opening driver ’s door
unlocks all doorsOFF ON
Power
windows
(
P. 83)Mechanical key linked
operation (close)ON OFF
Mechanical key linked
operation (open)ON OFF
Wireless remote control
linked operation
(open)ON OFF
Linked entry function ON OFF
Automatic
light control
system
(
P. 170)Light sensor sensitivity Level 3 Level 1 to 5
Daytime running light
systemON OFF
Time elapsed before
headlights automati−
cally turn off after doors
are closed30 seconds0 seconds
60 seconds
90 seconds