Downloaded from www.Manualslib.com manuals search engine OPERATING YOUR VEHICLE
OPERATING YOUR VEHICLE
Exhaust Gas Warning ......................................................... 3·1
Daily Inspection Checklist .................................................. 3·2
Engine Oil Consumption .................................................... 3·3
Ignition
Switch ..................................................................... 3·3
Parking Brake Lever .............................. ~ ............................ 3·7
Pedal
........................................................................\
............ :3·8
Starting the Engine ....•...................................... : .................. 3·9
Using the Transmission ..................................................... 3·11
If You Can Not Shift Automatic Transmission Gearshift
Lever
Out of "P" (PARK) .................................................... 3·17
Using the Transfer Switch (if equipped) ........................... 3·18
Cruise Control (if equipped) ............................................... 3·29
Braking ........................................................................\
......... 3·30
Electronic
Stability Program (ESP®) (if equipped) .......... 3·33
60G40B
Downloaded from www.Manualslib.com manuals search engine Daily Inspection Checklist
Before Driving
60A187S
1) Make sure that windows, mirrors, lights, and reflectors are clean and unob
structed.
2) Visually check the tires for the following points:
- the depth of the tread groove
-
abnormal wear, cracks and damage
-loose wheel nuts
- existence of foreign material such as nails, stones, etc.
Refer to "Tires" in "INSPECTION AND MAINTENANCE" section for details. 3) Look for fluid and oil leaks.
NOTE:
It is normal for water to drip from the air conditioning system after use.
4) Make sure the hood is fully closed and latched. 5) Check the headlights, turn signal lights, brake lights and horn for proper opera
tion.
6) Adjust the seat and adjustable head
restraint (if equipped).
7) Check the brake pedal and the parking
brake lever. 8) Adjust the mirrors. 9) Make sure that you and all passengers
have properly fastened your seat belts.
10)Make sure that all warning lights come on as the key is turned to the "ON" posi
tion.
11 )Check all gauges.
12)Make sure that the BRAKE SYSTEM
WARNING light turns off when the
parking brake is released.
Once
a week, or each time you fill your fuel tank, perform the following under-hood
checks:
1) Engine oil level 2) Coolant level 3) Brake fluid level 4) Power steering (if equipped) fluid level 5) Windshield washer fluid level 6) Battery solution level 7) Hood latch operation Pull the hood release handle inside the vehicle. Make sure that you cannot
open the hood all the way without releasing the secondary latch. Be sure
to close the hood securely after check-
OPERATING YOUR VEHICLE
ing for proper latch operation. See the
item "All Latches, Hinges & Locks" of "CHASSIS AND BODY" in the "Periodic Maintenance Schedule" in the "INSPECTION AND MAINTENANCE" section for lubrication schedule.
A WARNING
Make sure the hood is fully closed
and latched before driving. If it is not,
it can fly up unexpectedly during
driving,
obstructing your view and
resulting in an accident.
Once a month, or each time you fill your fuel tank, check the tire pressure using a
tire pressure gauge. Also check the tire
pressure of the spare tire.
3-2
Downloaded from www.Manualslib.com manuals search engine OPERATING YOUR VEHICLE
A. WARNING
(Continued) • Always return the ignition switch to the "LOCK" position and remove
the ignition key and the remote controller (if equipped) when leaving the vehicle even if a short time. Also do not leave children or pets alone in a parked vehicle. Unat
tended children could cause accidental movement of the vehicle or could tamper with power windows or power sunroof. They also could suffer from heat stroke in warm or hot weather. These could result in
severe injury or even death.
CAUTION
• Do not use the starter motor for more than 15 seconds at a time.
For diesel engine model, do not use the starter motor for more than 30 seconds at a time. If the engine
does not start, wait 15 seconds
before trying again. If the engine
does not start after several attempts, check the fuel and ignition systems or consult your SUZUKI dealer.
• Do not leave the ignition switch in
the "ON" position if the engine is not running as the battery will discharge.
3-7
Parking Brake Lever
EXAMPLE
(1) To set (2) To release (3) To release
64J081
The parking brake lever is located between the seats. To set the parking brake, hold the brake pedal down and pull the parking
brake lever all the way up. To release the parking brake, hold the brake pedal down, pull up slightly on the parking brake lever, push the button on the end of the lever with
your thumb, and lower the lever to its original position. For
automatic transmission
vehicles,
always set the parking brake before moving the gearshift lever to the "P" (PARK) position. If you park on an incline and shift
into "P" before setting the parking brake, the weight of the vehicle may make it difficult to shift out of "P" when you are ready to drive the vehicle.
When preparing to drive the vehicle, move the gearshift lever out of the "P" position
before releasing the parking brake.
A. WARNING
• Never drive your vehicle with the
parking brake on: rear brake effec
tiveness can be reduced from over
heating, brake life may be
shortened,
or permanent brake
damage may result.
• If
the parking brake does not hold the vehicle securely or does not fully release, have your vehicle inspected immediately by an autho
rized SUZUKI dealer.
Downloaded from www.Manualslib.com manuals search engine A WARNING
Always set the parking brake fully before leaving your vehicle or it may
move, causing injury or damage.
When parking, make sure the
gearshift lever for manual transmission
vehicles is in 1 st gear or "R" (Reverse) and the gearshift lever for
automatic transmission vehicles is in "P" (Park). Never leave the transfer
lever (if equipped) in "N" (Neutral)
when you are parked.
Remember, even though the transmission is in gear or in Park, you must set the parking brake fully.
A WARNING
When parking the vehicle in extremely cold weather, the following procedure should be used: 1) Set the parking brake. 2) Shift the manual transmission into
reverse or first gear, or the automatic transmission into "P" (Park). 3) With the engine off, get out of the
vehicle and put chocks under the
wheels.
4) Release the parking brake.
When
you return to your vehicle, you must remember to first set the
parking brake, then remove the
wheel chocks.
Pedal
Manual transmission
(2)
(1)
Automatic transmission
(2)
(3)
64JOB2
(3)
64JOB3
OPERATING YOUR VEHICLE
Clutch Pedal (1) (For manual transmission)
The clutch pedal is used to disengage the
drive to the wheels when, starting the
engine, stopping, or shifting the gearshift
lever or transfer lever (if equipped).
Depressing the pedal disengages the
clutch.
CAUTION
Do not drive with your foot resting-on the clutch pedal. It could result in excessive clutch wear, clutch damage, or unexpected loss of engine
braking.
Brake Pedal (2) Your SUZUKI vehicle is equipped with
either front and rear disc brakes or front
disc brakes and rear drum brakes.
Depressing the brake pedal applies both
sets
of brakes.
You may hear occasional brake squeal
when you apply the brakes. This is a normal condition caused by environmental
factors such as cold, wet, snow, etc.
A WARNING
If brake squeal is excessive and
occurs each time the brakes are
applied,
you should 'have the brakes
checked by your SUZUKI dealer.
3-8
Downloaded from www.Manualslib.com manuals search engine OPERATING YOUR VEHICLE
A. WARNING
Do not "ride" the brakes by applying
them continuously or resting your
foot
on the pedal. This will result in overheating of the brakes which
could cause unpredictable braking
action, longer stopping distances, or
permanent brake damage.
Accelerator Pedal (3) This pedal controls the speed of the
engine. Depressing the accelerator pedal
increases power output
and speed.
3-9
Starting the Engine
Before Starting the Engine
64J140
1} Make sure the parking brake is set fully. 2} Manual transmission -Shift into UN" (Neutral) and depress the clutch pedal
all the way to the floor. Hold the clutch
pedal while starting the engine.
Automatic transmission -
If the gear
shift lever is not in Up" (Park) position,
shift into Up" (Park). (If you need to restart the engine while the vehicle is moving, shift into UN".)
NOTE: Automatic transmission vehicles have a starter interlock device which is designed to keep the starter from operating if the transmission is in any of the drive posi
tions.
A. WARNING
Make sure that the parking brake is set fully and the transmission is in Neutral (or Park for vehicles with an automatic transmission) before
attempting to start the engine.
Downloaded from www.Manualslib.com manuals search engine OPERATING YOUR VEHICLE
Diesel Particulate Filter (DP~ ;::D.:..p.:..j=®----=:w:..::a::..:rn..:.:i:..::ng~lig~h:..:..:t~ _____ _____, The DPj=® filters off the soot 'particles in the exhaust gas, so the DPp!9 could get clogged depending on the driving condition. The DPPW is cleaned by the regenerating function that combusts the soot
particles in the DPPW by raising the
exhaust gas temperature during driving.
A WARNING
Keep away from the exhaust pipe
when the engine is running. If the DPj=® is regenerating, the exhaust
gas temperature could be higher.
NOTE: When you drive your vehicle, white smoke
may be emitted depending on the grade of fuel used. This is due to the particle filter
regenerating automatically, and does not
affect the way the vehicle runs.
3-11
64J244
If the DPpID warning light comes on when
driving, the DPpID is nearly clogged. You should regenerate the DPpID when the DPPW warniqg light comes on. To regenerate the DPp!9, you must drive the vehicle
until the light goes out, at a speed of 75 km/h (47 mph) or higher for a while (max. 30 minutes).
However, you should drive carefully and
within the legal speed limit, and should
take in to consideration the surrounding
traffic condition. If you drive your vehicle
until the light goes out, the regeneration of
the DPPW will be completed.
CAUTION
Be sure to regenerate the DPj=® when
the DPj=® warning light comes on.
Failure to regenerate the DPj=® will cause a vehicle malfunction due to the clogged filter.
Using the Transmission
Manual Transmission
Starting off
650449
To start off, depress the clutch pedal all the
way to the floor and shift into 1 st gear. After releasing the parking brake, gradually release the clutch. When you hear a
change in the engine's sound, slowly press
the accelerator while continuing to gradu
ally release the clutch.
Shifting All forward gears are synchronized, which
provides for quiet, and easy shifting.
Always push
in the clutch pedal fully before
shifting gears.
Downloaded from www.Manualslib.com manuals search engine OPERATING YOUR VEHICLE
o (Drive)
Use this position for all normal driving.
With the gearshift
lever in "D" range you can get an automatic downshift by press
ing the accelerator pedal. The higher the
vehicle speed is, the more you need to
press the accelerator pedal to get a down
shift.
3
(Low 3) Use this position for driving on moderate uphill and downhill gradients. The engine
braking effect on moderate down hills can be used in this position. The transmission
shifts up only to 3rd gear.
2 (Low 2) Use this position to provide extra power
when climbing hills, or to provide engine
braking when going down hills.
NOTE: In these 3 or 2 positions, if the power mode
selector switch is turned to the "ON" position, the transmission will not downshift
into "L.:' (Low 1).
L (Low 1)
Use this position to provide maximum
power when climbing steep
hills or driving
through deep snow or mud, or to provide
maximum engine braking when going
down steep hills.
3-17
NOTE:
If you move the gearshift lever to a lower
gear while driving faster than the maximum
allowable speed for the lower gear, the
transmission will not actually downshift
until your speed drops below the maximum
speed for
the lower gear.
CAUTION
Be sure to take the following precautions to help avoid damage to the
automatic transmission:
• Make sure that the vehicle is completely stationary before shifting into "P" or "R". • Do not shift from "P" or "N" to "R", "0", "3", "2", or "L:' when the
engine is running above idle speed. • Do not rev the engine with the transmission in a drive position ("R", "0", "3", "2", or "L:') and the rear wheels not moving. • Do not use the accelerator to hold the vehicle on a hill. Use the vehicle's brakes.
If You Can Not Shift Automatic
Transmission Gearshift Lever
Out
of "P" (PARK)
Left hand drive vehicle
78K043
Vehicles with an automatic transmission
have an electrically operated park-lock fea
ture. If the vehicle's battery is discharged,
or there is some other electrical failure, the
automatic transmission cannot be shifted
out of Park in the normal way. Jump start
ing may correct the condition. If not, follow the procedure described below. This pro
cedure will permit shifting the transmission
out of Park.
1) Be sure the parking brake is firmly
applied.
2) If the engine is running, stop the
engine.
3) Make sure the key is in the "ON" or "ACC" position.
Downloaded from www.Manualslib.com manuals search engine 4) Remove the cover (1) on the hole. 5) With inserting the key or the flat end rod into the slot in the hole, shift the 'gear
shift lever to the desired position.
This procedure
is for emergency use only. If repeated use of this procedure is necessary, or the procedure does not work as described, take the vehicle to your dealer for repair. '
Right hand drive vehicle
~(1)
78K044
Vehicles with an automatic transmission have an electrically operated park-lock fea
ture. If the vehicle's battery is discharged,
or there is some other electrical failure, the
automatic transmission cannot be shifted
out of Park in the normal way. Jump start
ing may correct the condition. If not, follow the procedure described below. This pro- cedure
will permit shifting the transmission
out of
Park.
1) Be sure the parking brake is firmly
applied.
2) If the engine is running, stop the
engine.
3) Make sure the key is in the "ON" or "ACC" position. 4) With pushing the release button (1),
shift the gearshift lever to the desired
position.
This procedure
is for emergency use only. If repeated use of this procedure is necessary, or the procedure does not work as described, take the vehicle to your dealer for repair.
OPERATING YOUR VEHICLE
Using the Transfer Switch
(if equipped)
66J168
Your vehicle is equipped with a four-mode full-time 4x4 system. You can use the
transfer switch to select any of the four
modes: N, 4H, 4H LOCK, 4L LOCK.
3-18