2008 SUZUKI GRAND VITARA tow

Downloaded from www.Manualslib.com manuals search engine INSPECTION AND MAINTENANCE
Maintenance Recommended under Severe Driving Conditions
If the car is usually used under the conditions corresponding to any severe condition code given below, it is recommended that applicable maintenance operation be performed at the particular interval as given in the chart below.
Severe condition code A -Repeated short trips B -Driving on rough and/or muddy roads C -Driving on dusty roads D -Driving in extremely cold weather and/or salted roads E -Repeated short trips in extremely cold weather F -Leaded fuel use G -Low quality fuel use H -Trailer towing (if admitted)
Severe
Maintenance
Condition Code
-B C D - -- -Engine accessory drive.belt (Gasoline engine)
-B C D ----Engine accessory drive belt (Diesel engine) Including tensioner, idlers
A -C D E ---Camshaft timing belt (Diesel engine only)
Including tensioner
A -C D E F -H Engine oil and oil filter (Gasoline engine) (Diesel engine)
- --- --G -Engine oil and oil
filter (Diesel engine)
-B - -- - --Exhaust
pipe mountings
A B C -E F -H Spark plugs
7-5
Maintenance
Maintenance Interval Operation
I Every 15000 km (9000 miles) or 12 months
R Every 45000 km (27000 miles) or 36 months
R Every 30000 km (18000 miles) or 24 months
R Every 45000 km (27000 miles) or 36 months
R Every 7500 km (4500 miles) or 6 months
R Every 5000 km (3000 miles) or 6 months
I Every 15000 km (9000 miles) or 12 months
R Every 30000 km (18000 miles) or 24 months

Downloaded from www.Manualslib.com manuals search engine INSPECTION AND MAINTENANCE
For windshield wipers:
70G119
1) Hold the wiper arm away from the win­dow.
7-43
EXAMPLE
EXAMPLE
54G130
2) Squeeze lock (1) towards wiper arm (2) and remove the wiper frame from the
arm as shown.
3)
Unlock the lock end of the wiper blade and slide the blade out as shown.
Type A (Removal)
60A260
Type A (Installation)
..,
54G132
(1) Locked end

Downloaded from www.Manualslib.com manuals search engine Type B (Removal)
54G133
Type B (Installation)
54G134
(1) Locked end
TypeC
650151
NOTE:
For Type C, do not flex the wiper blade frame end more than necessary If you do, it can break off.
INSPECTION AND MAINTENANCE
(1) Retainer
4) If the new blade is provided without the
two metal retainers, move them from
the old blade to the new one. 5) Install the new blade in the reverse
order of removal, with the locked end
positioned toward the wiper arm
(except
Type C). Make sure the blade is properly
retained by all the hooks. Lock the
blade end into place.
6) Reinstall wiper frame to arm, making
sure that the lock lever is snapped
securely into the arm.
7-44