Downloaded from www.Manualslib.com manuals search engine EXAMPLE
64J191
3) Remove the engine under cover. 4) Loosen the drain plug attached to the lower part of the radiator and drain the coolant into a suitable container.
5) Reinstall the reservoir and fill it with coolant to the "FULL.:' line. 6) Tighten the drain plug on the radiator. 7) Reinstall the engine under cover. 8) Fill the radiator with coolant and install
the radiator cap. 9) After filling, let the engine idle for about 2-3 minutes to get rid of air in the cooling system.
1 O)Stop the engine. 11 )Check the coolant level in the radiator
again. If the level has gone down, add
more coolant.
CAUTION
The coolant must be replaced with
the vehicle on level ground.
(For
Diesel Engine Model) Since special procedures are required, we recommend you take your vehicle to your SUZUKI dealer for coolant replacement.
INSPECTION AND MAINTENANCE
Air Cleaner
EXAMPLE
66J167
If the air cleaner is clogged with dust, there
will be greater intake resistance, resulting in decreased power output and increased fuel consumption.
Check and
clean periodically according to
the following procedure:
1) Take off the air cleaner case cover.
Remove the element from the air cleaner case cover. 2) This air cleaner element is of dry type.
Remember that it needs cleaning
according to the following method.
3) Blow off dust on cleaner element by
compressed air from inside the element, or replace the element as necessary.
7-16
