2008 SMART FORTWO COUPE wheel bolts

Tires and wheels
182
>> Operation Contact an authorized smart center for infor

mation on tested and recommended rims and
tires for summer and winter operation. They
can also offer advice concerning tire service
and purchase.
Modifications to the brake system and wheels
and the use of spacer and brake dust rings
are not permissible.
Important guidelines• Only use sets of tires and rims of the same
type and make.
• Tires must be of the correct size for the
rim.
• Break in new tires for approximately
60 miles (100 km) at moderate speeds.
• Regularly check the tires and rims for
damage. Dented or bent rims can cause tire
inflation pressure loss and damage to the
tire beads.
• If vehicle is heavily loaded, check tire infla

tion pressure and correct as required.
• Do not allow your tires to wear down too far.
Adhesion properties on wet roads are
sharply reduced at tread depths of less
than
1/8in (3 mm).
G
Warning!
Replace rims or tires with the same des

ignation, manufacturer and type as shown
on the original part. Contact an autho

rized smart center for further informa

tion. If incorrectly sized rims and tires
are mounted:
• The wheel brakes or suspension
components can be damaged.
• The operating clearance of the wheels
and the tires may no longer be correct.
G
Warning!
Worn, old tires can cause accidents. If the
tire tread is badly worn, or if the tires
have sustained damage, replace them.
When replacing rims, only use genuine
smart wheel bolts specified for the
particular rim type. Failure to do so can
result in the bolts loosening and possibly
an accident.
Retreaded tires are not tested or recom

mended by smart, since previous damage
cannot always be recognized on retreads.
The operating safety of the vehicle can

not be assured when such tires are used.

Tires and wheels
>> Operation
207
Uniform Tire Quality Grading Standards
A tire information system that provides
consumers with ratings for a tire’s traction,
temperature and treadwear. Ratings are
determined by tire manufacturers using
government testing procedures. The ratings
are molded into the sidewall of the tire.
Vehicle maximum load on the tire
Load on an individual tire that is determined
by distributing to each axle its share of the
maximum loaded vehicle weight and dividing it
by two.
Rotating tiresThoroughly clean the mounting face of the
wheels and brake disks, i.e. the inner side of
the wheels/tires each time the wheels/tires
are changed. Check for and ensure proper
tire inflation pressure.For information on wheel change, see "Flat
tire" (

page 265).
G
Warning!
Do not rotate front and rear wheels as
they have different dimensions, e.g. rim
size, wheel offset etc. Otherwise, the
handling can be affected and you could
endanger yourself and others.
G
Warning!
Have the tightening torque checked after
changing a wheel. Wheels could become
loose if not tightened with a torque of
81 lb
ft (110 Nm).
Only use genuine smart wheel bolts
specified for your vehicle’s rims.

Flat tire
270
>> Practical hints.
!
The manufacturer is unable to guarantee
that all tire punctures can be repaired with
the tire repair kit, in particular cuts or
perforations larger than approximately
0.16 in (4 mm) or away from the tire's tread.
The manufacturer is not liable for damage
sustained through improper use of the tire
repair kit.>Drive to the nearest authorized smart cen

ter, to have the damaged tire replaced.
>Contact an authorized smart center as soon
as possible to obtain a new filler hose
4 and
a new tire sealant container
9.
>Bring used tire sealant materials to an
authorized smart center for proper dispos

al.
>Replace your tire sealant container every
4 years. Replacement containers are avail

able at any authorized smart center.
G
Warning!
Follow recommended tire inflation
pressures.
Do not overinflate tires. Overinflated
tires can adversely affect handling and
ride comfort, wear unevenly, increase
stopping distance, and result in sudden
deflation (blowout) because they are
more likely to become punctured or
damaged by road debris, potholes etc.
Do not underinflate tires. Underinflated
tires wear excessively and/or unevenly,
adversely affect handling and fuel econ

omy, and are more likely to fail from being
overheated.
Do not overload the tires by exceeding
the specified load limit as indicated on
the Tire and Loading Information placard
on the driver’s door B
pillar. Overload

ing the tires can overheat them, possibly
causing a blowout. Overloading the tires
can also result in handling or steering
problems, or brake failure.
G
Warning!
After changing a tire, contact a smart
center to make sure that the bolts holding
the wheel to the car are tight enough.
Otherwise, the wheels could come off.
Each bolt should be tightened to a torque
of 81 lb
ft (110 Nm).