Fuses and light bulbs
248
- parking lights and main beam lights
- low beam lights
- Turn signal light (at the front)
Parking lights and main beam lights
Removing the light bulb for the parking light
– Switch the ignition and all lights off.
– Open the bonnet.
– Remove the protective cap ⇒page 247, fig. 217 .
– Remove the socket ⇒fig. 218 .
– Take the faulty bulb out of the fixture and insert a new one.
Removing the light bulb for the main beam light
– Switch the ignition and all lights off.
– Open the bonnet.
– Remove the protective cap ⇒page 247, fig. 217 . – Press the sprung wire clamps
⇒fig. 218 together and hang them
to the side.
– Remove the socket ⇒fig. 218 .
– Take the faulty bulb out of the fixture and insert a new one
Installation takes place in the reverse order.
Note
We recommend that you have the headli ght setting checked by a Skoda Service
Partner after replacing the light bulb.
Low beam light
– Switch the ignition and all lights off.
– Open the bonnet.
– Remove the protective cap ⇒page 247, fig. 217 .
– Turn the connector with the light bulb up to the stop towards the left
and remove ⇒fig. 219 .
AA
AB
AC
B3T-0034H
Fig. 218 Removing the light
bulb for the parking and
main beam light
AA
AA
AA
AB
AC
Fig. 219 Removing the light
bulb for the low beam light
AB
NKO B6 20.book Page 248 Wednesday, March 26, 2008 3:15 PM
Fuses and light bulbs
250
Remove and install the outer part of the rear light unit
– Switch the ignition and all lights off.
– Open the boot lid/luggage compartment door.
– Take out the plug ⇒page 249, fig. 222 and unscrew the rear light unit
using a torx wrench
18).
– Carefully remove the rear light unit. Do not pull the grommet with the cables out of the body.
– To re-insert the rear light unit, first of all guide it with the support ⇒fig. 224 towards the front onto a bolt on the bodywork.
– Carefully press the rear light unit into the bodywork.
– Screw the rear light unit tight and press in the plugs ⇒page 249,
fig. 222 .
Remove and install the inner part of the rear light unit
– Switch the ignition and all lights off.
– Open the boot lid/luggage compartment door. – Take off the cover of the rear light unit on the inner side of the bonnet
lid ⇒fig. 223 .
–Press the spring bolt ⇒fig. 223 and take the lamp holder out of the
housing of the rear light unit.
– To re-insert the lamp holder, guide it into the housing of the rear light
unit.
– Press onto the spring bolt until it locks in place.
– Guide the cover of the rear light uni t into the inner side of the bonnet
lid.
Caution
When removing and installing the rear light unit make sure not to damage the
paintwork of the vehicle and the rear light unit.
Changing light bulbs in the rear light unit
18)The torx wrench is located in a vehicle toolkit box on the spare wheel.
Fig. 223 Remove the inner
part of the rear light unit
AA
Fig. 224 Outer part of the
rear light unit: Lamps
NKO B6 20.book Page 250 Wednesday, March 26, 2008 3:15 PM
