17C-10
MR-372-J84-17C000$118.mif
V2
GAS INJECTION
Fault finding - System operation
LPG 3000
Program No: AB
Vdiag No: 08/10
17C
The GAS 3000 computer manages "gas" actuator control, i.e. the "gas" injectors, the gas system relays and solenoid
valves, the fuel pump cut-off relay and the management of the fuel sender. Before switching to "Gas" mode, the
computer always checks that the pressure and the temperature of the gas are correct and that the "gas" solenoid
valves are open.
The combustible material is stored in an independent toric tank. LPG is stored in a semi-gaseous state at a pressure
of approximately 15 bar.
CNG is stored in a cylindrical tank in a gaseous state at a pressure of approximately 200 bar, and is transported to
the expansion valve/reducer via a rigid high pressure pipe. The rest of the system is a low pressure pipe going from
the expansion valve/reducer to the injectors. For CNG, there is a gas filter between the expansion valve and the rail.
Malfunctions / Special cases
These are characterised by operation in Petrol mode, although the driver has selected LPG mode.
An operational fault must be caused by the LPG system if it cannot be reproduced in Petrol mode.
Forced Petrol mode when LPG is faulty.
The level 1 warning light is controlled by the petrol injection computer; the gas warning light is controlled by the GAS
3000 computer.
The system automatically switches to "petrol" mode when the tank is empty or when the conditions allowing
operation in "gas" mode are not satisfied.
