16A-11V1 MR-372-J84-16A000$050.mif
STARTING - CHARGING
Fault finding – Fault finding charts16A
Scénic II ph 2
ALP 2 The starter turns but does not engage
NOTESSpecial notes:
Disconnect the battery earth before handling.
Remove the starter (see MR 370, Mechanical, 16A, Starting - Charging, Starter: Removal - Refitting).
Check that the ring gear of the flywheel is in good condition.
Are the ring gear teeth damaged?
Replace the flywheel (see MR 370, Mechanical,
Engine and peripherals, Engine and cylinder
block assembly).
Check the condition of the starter (broken teeth or
worn gears).
Is the starter in good condition?
Replace the starter (see MR 370,
Mechanical, 16A, Starting - Charging,
Starter: Removal - Refitting).
Refit the starter (see MR 370, Mechanical, 16A,
Starting - Charging, Starter: Removal - Refitting).
YESNO
NO
YES
16A-13V1 MR-372-J84-16A000$050.mif
STARTING - CHARGING
Fault finding – Fault finding charts16A
Scénic II ph 2
ALP 3
CONTINUED 1
Remove the starter and check that the centring pin is
present. Check the condition of the pinion and carry
out a full check of the ring gear.Inhibit the engine injection (see 13B or 17B,
Interpretation of commands), activate the
starter for 2 seconds, and release the key.
Is a fault noticed?
Does the starter continue to run after the key is
released?
Fit a centring pin, or replace the
flywheel (see MR 370,
Mechanical, 10A, Flywheel:
Removal - Refitting), or replace
the starter (see MR 370,
Mechanical, 16A, Starting -
Charging, Starter: Removal -
Refitting).Starter control fault, check the entire starter
control line (see ALP1 The starter does not
work, continued 3 C).
Replace the starter (see MR 370, Mechanical, 16A,
Starting - Charging, Starter: Removal - Refitting).Make several attempts, waiting for 5 minutes
after 5 attempts (let the starter cool). If the result
is still the same after several attempts, replace
the starter (see MR 370, Mechanical, 16A,
Starting - Charging, Starter: Removal –
Refitting).
B
YES
A
YESNO
YESNO
