2008 RENAULT SCENIC coolant

AUTOMATIC TRANSMISSION
Fault finding – Fault summary table23A
23A - 16V4 MR-372-J84-23A050$264.mif
SIEMENS TA2000
Vdiag No.: 10-11-15
* RR: rear
* FR: frontTool fault Diagnostic tool title
DF116 Engine multiplex speed signal
DF117 Left RR* wheel multiplex speed signal
DF118 Right RR* wheel multiplex speed signal
DF119 Brake pedal position
DF122 Passenger compartment computer connection
DF123 ABS computer connection
DF126 Turbine speed signal
DF131 Slip
DF144 Coolant temperature multiplex signal
DF174 ABS fault detection
DF175 Left-hand FR* wheel multiplex speed signal
DF176 Right-hand FR* wheel multiplex speed signal
DF177 Automatic transmission overheating

AUTOMATIC TRANSMISSION
Fault finding – Interpretation of faults23A
23A-57V4 MR-372-J84-23A050$396.mif
SIEMENS TA2000
Vdiag No.: 10-11-15
DF144
PRESENT
OR
STOREDCOOLANT TEMPERATURE MULTIPLEX SIGNAL
NOTESNone.
Carry out a test on the multiplex network (see 88B Multiplex).
If the fault is still present, run fault finding on the injection system (see 17B, Petrol injection or 13B,
Diesel injection).
AFTER REPAIRDeal with any other faults. Clear the fault memory.
Switch off the ignition and carry out a road test followed by a test with the
diagnostic tool.
DP0TA2000_V10_DF144/DP0TA2000_V11_DF144/DP0TA2000_V15_DF144

AUTOMATIC TRANSMISSION
Fault finding – Parameter summary table23A
23A - 100V4 MR-372-J84-23A050$660.mif
SIEMENS TA2000
Vdiag No.: 10-11-15
Tool parameter Diagnostic tool title
PR001Coolant temperature
PR003Oil pressure
PR004Gearbox oil temperature
PR006Engine speed
PR007Turbine speed
PR008Computer feed voltage
PR128Engine/turbine speed difference
PR135Standard pedal position
PR138Reference pressure
PR146Difference between reference and pressure

AUTOMATIC TRANSMISSION
Fault finding – Parameter interpretation23A
23A - 101V4 MR-372-J84-23A050$726.mif
SIEMENS TA2000
Vdiag No.: 10-11-15AUTOMATIC TRANSMISSION
Fault finding – Parameter interpretation
PR001
COOLANT TEMPERATURE
NOTESThere must be no present or stored faults.
Check that the cooling circuit is topped up and properly bled.
Perform the required operations.
Check the cleanliness and condition of the coolant temperature sensor and its connections.
If no fault is revealed as a result of these checks, refer to the interpretation of the coolant temperature parameter
(see 17B, Petrol injection or 13B Diesel injection).
Replace the coolant temperature sensor, if necessary.
If the fault is still present after the coolant temperature sensor has been replaced, contact the Techline.
AFTER REPAIRRepeat the conformity check from the start.
DP0TA2000_V10_PR001/DP0TA2000_V11_PR001 /DP0TA2000_V15_PR001
MR-372-J84-23A050$726.mif