2008 Peugeot 308 SW BL Fault

11
i
!
!
168
PRACTICAL INFORMATION
* According to country. Risk of electrocution
Xenon bulbs (D1S - 35 W) must be
replaced by a PEUGEOT dealer.


CHANGING A BULB
Procedure for replacing a faulty bulb
with a new bulb without the use of
tools.
Front lights


Model with halogen lights

1. Direction indicators
(PY 21 W amber).

2. Dipped headlamps (H7 - 55 W).

3. Main beam headlamps
(H1 - 55 W).

4. Daytime * /side lights (P21/5 W).

5. Fog lamps (H8 - 35 W).
1. Direction indicators
(PY 21 W SV silver).

2. Dipped/main beam headlamps
(D1S - 35 W).

3. Additional main beam headlamps
(H1 - 55 W).

4. Daytime*/side lights (P21/5 W).

5. Fog lamps (H8 - 35 W).
Model with xenon lights and
directional headlamps
In certain climatic conditions (low
temperature, humidity), the pres-
ence of condensation on the in-
side of the headlamp and light
glass is normal ; it disappears a few
minutes after the lights are switched
on.

 Handle the bulbs using a dry
cloth.
The headlamps are fi tted with poly-
carbonate lenses, coated with a
protective varnish:

 do not clean them with a dry
or abrasive cloth or using a
detergent or solvent product,

 use a sponge and soapy water,

 when using a high pressure
washer on stubborn dirt, do
not spend too long on the
headlamps, lights and their
surrounds to avoid damaging
their varnish and their seals.

11
174
PRACTICAL INFORMATION
Changing the number plate light
bulbs (W 5 W)

 Insert a thin screwdriver into one of
the outer holes of the lens.

 Push it outwards to unclip.

 Remove the lens.

 Pull the bulb and change it.

Changing the third brake light
(SW - 4 bulbs W 5 W)

 Remove the two light fi xing nuts A .

 Take out the light from the outside.

 Disconnect the connector and the
screenwash pipe from the light.

 Turn the bulb holder corresponding
to the faulty bulb a quarter of a turn.

 Pull the bulb and change it.
To refi t, carry out these operations in re-
verse order.
Do not force the light when tightening
the nuts. Changing the third brake light
(SW - diodes)
On the versions with opening rear
screen, for the replacement of this type
of diode light, contact a PEUGEOT
dealer.

11
!
i
175
PRACTICAL INFORMATION PEUGEOT will not accept responsi-
bility for the cost incurred in repairing
your vehicle or for rectifying malfunc-
tions resulting from the installation
of accessories not supplied and not
recommended by PEUGEOT and
not installed in accordance with its
instructions, in particular when the
combined consumption of all of the
additional equipment connected ex-
ceeds 10 milliamperes.
Installing electrical accessories
Your vehicle's electrical system is
designed to operate with standard
or optional equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a PEUGEOT dealer.
CHANGING A FUSE
Procedure for replacing a faulty fuse
with a new fuse to rectify a failure of the
corresponding function.
Access to the tools
The extraction pliers and the spare fus-
es are installed on the back of the fascia
fuse box cover.
To gain access to them:

 open the glove box lid,

 push the opening guide to the left to
open to beyond the fi rst notch,

 open the glove box lid fully, Changing a fuse
Before changing a fuse, the cause of
the failure must be identifi ed and recti-
fi ed.

 Identify the faulty fuse by checking
the condition of its fi lament.

 Use the special pliers to extract the
fuse from its housing.

 Always replace the faulty fuse with a
fuse of the same rating.

 Check the correspondence between
the number etched on the box, the
rating etched on the fuse and the
tables below.
Correct Incorrect

 turn the screw a quarter of a turn to
the left,

 unclip the fuse box cover by pulling
at the top right,

 remove the cover completely,

 remove the pliers.

227
22
33
S
O
SSOURCE
MODE BAND ESC
2
abc
5
jkl
8
tuv 3
def
6
mno
9
wxyz
1 4
ghi
7
pqrs0 # MENU LIST
TA
PTY
DARK
ESC
MENU LIST
66
ESC
MENU LIST
ESC
MENU LIST
ESC
MENU LIST
44
ESC
MENU LIST
55
11
COPY CD TO JUKEBOX
COMPLETE CD
CREATE ALBUM
OK
Select COPY CD TO JUKEBOX and press the dial to confi rm.
Select COMPLETE CD to copy the entire CD and press the dial to confi rm.
Select CREATE ALBUM and press the dial to confi rm.
The AUTO CREATION tab automatically copies the CD by default into an album of the type "album n°...".
The audio or MP3 CD is copied onto the hard disc. Copying may take approximately 20 minutes depending on the dura tion of the CD. During this copying phase, it is not possible to listen to the albums previously recorded on the hard disc or the CDs.
Select the letters one by one and select OK to confi rm.
If it is not an MP3 CD, the Jukebox automatically compresses the CD in MP3 format. The compression may take appr oximately 20 minutes depending on the duration of the CD. During this compression phase, it is possible to listen to the CD or to albums previously recorded on the hard disc.
A long press on the SOURCE button starts the copyi ng of the CD.
When copying an MP3 CD, the Jukebox only retains t he last album level. It is not possible to copy fi les from the Jukebox to a CD. The STOP THE CD COPY action does not delete the fi les which have already been transferred onto the jukebox hard disc.
Select AUDIO FUNCTIONS and press the dial to confi rm.
Insert a CD or an MP3 compilation and press the MENU button.
JUKEBOX FUNCTION
COPYING A CD ONTO THE HARD DISC

246
11
22
1
22
Insert circular compact discs only. Some anti-pirating systems, on original discs or CDs copied using a personal recorder, may cause faults which are no refl ection on the quality of the original player. Without pressing the EJECT button, insert a CD in the player, play begins automatically.
To play a disc which has already been inserted, press the SOURCE button several times in succession and select CD.
Press one of the buttons to select a track on the CD. Press the LIST REFRESH button to display the list of tracks on the CD.
Insert an MP3 compilation in the player. The audio equipment searches for all of the music tracks, which may take anything between a few seconds and several tens of seconds, before play begins.
On a single disc, the CD player can read up to 255 MP3 fi les spread over 8 directory levels. However, it is advisable to keep to a limit of two levels to reduce the access time before the CD is played.
To play a disc which has already been inserted, press the SOURCE button several times in succession and select CD.
Press one of the buttons to select a track on the CD. Press the LIST REFRESH button to display the list of directories of the MP3 compilation.
CD
PLAYING A CD
CD
PLAYING AN MP3 COMPILATION

248
11
22
22
11
The controls are displayed and managed via the portable equipment.
First adjust the volume of your portable equipment.
Then adjust the volume of your RD4 audio equipment.
The auxiliary input permits the connection of portable equipment (MP3 player...). It is activated by default.
Connect the portable equipment (MP3 player…) to the audio sockets (white and red, RCA type) located in the glove box using a JACK/RCA audio cable.
Press the SOURCE button several times in succession and select AUX.
USING THE AUXILIARY INPUT (AUX)
JACK/RCA CABLE NOT SUPPLIED
ADJUSTING THE VOLUME OF THE
AUXILIARY SOURCE

252
1
2
3
3
2
3
3
2
3
3
2
3
3
2
3
3
1
2
3
3
2
3
3
1
2
3
3
1
2
2
2
2
2
2
1
2
2
2
2
2
2
2
2
1
2
2
123
23
07
RADIO-CD
REV WIPE ACT
active
inactive
OPTIONS
DISPLAY ADJUST
YEAR
MONTH
DAY
HOUR
MINUTES
12 H/24 H MODE
UNITS
TEMPERATURE: °CELSIUS/°FAHRENHEIT
FUEL CONSUMPTION: KM/L - L/100 - MPG
DISPLAY FLOW CHART monochrome A
MAIN FUNCTION A
* The parameters vary according to vehicle (refer to the "Multifunction displays" chapter).
CHOICE A Choice A1 Choice A2 CHOICE B...
RDS SEARCH
active
inactive
REG MODE
active
inactive
INTROSCAN
active
inactive
CD REPEAT
active
inactive
RANDOM PLAY
active
inactive
GUIDE LAMPS
active
inactive
VEHICLE CONFIG *
ABANDON/CONSULT LIST OF FAULTS
functions activated (or not)
warning messages
LANGUAGES
FRANCAIS
ITALIANO
NEDERLANDS
PORTUGUES
PORTUGUES-BRASIL
DEUTSCH
ENGLISH
ESPANOL