2008 PEUGEOT 207 display

FAMILIARISATION

1. Steering wheel adjustments control.

2. Cruise control/speed limiter switch.

3. Lights and direction indicators
controls.

4. Hazard warning lights switch.

5. Fragrance diffuser.

6. Multifunction display.
Seat belt fastening status warning lights.

7. Sunshine sensor.

8. Passenger air bag.

9. Speaker (tweeter).

10. Glove box/Passenger air bag
disarming/Audio/video sockets/
Fuse box.

11. Bonnet release control.

12. Front ashtray/Lighter.

13. Heating/air conditioning controls.

14. CD changer.

15. Audio RD4 or RT4 GPS audio/
telephone.

16. Central adjustable and closing
vents.

FAMILIARISATION
Instrument panel Controls bar

A. With the ignition on, the fuel gauge
needle should rise.

B.
With the engine running, the associated
low level warning light should switch
off.

C. With the ignition on, the oil level
indicator should display "OIL OK"
for a few seconds.
If the levels are not correct, top up the
level which is low.

 18 Lighting of the indicator light indicates
the status of the corresponding function.

A. Deactivation of the ESP/ASR system.

 103

B. Deactivation of the rear parking as-
sistance.

 122

C. Central locking.

 66

D. Deactivation of the interior protection
alarm.

 70

E. Activation of the electric child lock * .

 99

1. With the ignition on, the orange and
red warning lights come on.

2. With the engine running, these
warning lights should switch off.
If a warning light remains on, refer to
the page concerned.

 19
Warning lights
* Except 3-door.

FAMILIARISATION
Speed limiter "LIMIT" Instrument panel display

1. Selecting/Switching off speed limiter
mode.

2. Decrease the programmed value.

3. Increase the programmed value.

4. Speed limiter on/off.
The values must be set with the engine
running.

 114 The cruise control or speed limiter mode
appears on the instrument panel when
it is selected.

1. Selecting/Switching off cruise control
mode.

2. Decrease the programmed value.

3. Increase the programmed value.

4. Cruise control off/resume.
In order to be programmed or activated,
the vehicle speed must be higher than
25 mph (40 km/h), with at least fourth
gear engaged on the manual gearbox
(second gear on the "2 Tronic" or auto-
matic gearbox).

 116
Cruise control "CRUISE"
Cruise control Speed limiter

FAMILIARISATION
"2 Tronic" gearbox
This fi ve-speed piloted manual gearbox
offers a choice between the comfort of
fully automatic operation or the pleas-
ure of manual gear changing.

1. Gear lever.

2. Steering wheel control "-" .

3. Steering wheel control "+" . Display on the instrument panel
The gear or the driving mode selected
appears on the instrument panel.

N: neutral.

R: reverse.

1 2 3 4 5: gears engaged.

AUTO: automatic mode.


: automatic "snow" mode. Moving off

 Select position N and press the
brake pedal fi rmly while starting the
engine.

 Engage fi rst gear (position A or M )
or reverse (position R ) using the
gear lever 1 .

 Release the handbrake.

 Take your foot off the brake pedal
and accelerate.

 112

18
PETROL - DIESEL MANUAL GEARBOX OR "2 TRONIC" OR
AUTOMATIC GEARBOX INSTRUMENT PANELS
Panel which groups together the vehicle
operation dials and indicator lights.
5. Oil temperature.
Indicates the temperature of the oil in the engine (° Celsius).

6. Display.

7. Display zero reset button.
Resets the selected function to zero (trip distance recorder or service in-
dicator).

8. Instrument panel lighting button.
Adjusts the brightness of the lighting of the instruments and controls.

9. "2 Tronic" or automatic gearbox.
Indicates the programme selected and the gear engaged.
Dials

1. Rev counter.
Indicates the speed of rotation of the engine (x 1 000 rpm).

2. Fuel gauge.
Indicates the quantity of fuel remaining in the tank.

3. Cooling temperature.
Indicates the temperature of the engine coolant (° Celsius).

4. Speedometer.
Indicates the current speed of the moving vehicle (km/h or mph).
A. Speed limiter
or
Cruise control.
(km/h or mph)

B. Trip distance recorder.
(km or miles)

C. Service indicator.
(km or miles) then,
Engine oil level indicator.
then
Distance recorder.
(km or miles)
These three functions are displayed in succession when the ignition is
switched on.
Display
For further information, refer to the section
which corresponds to the function and to
the display associated with it.

!
19
The indicator/warning light comes
on continuously or fl ashes.
Some indicator/warning lights may
light in two different ways. Only by
relating the type of lighting to the
vehicle operating status can it be
ascertained whether the situation
is normal or whether a fault has oc-
curred.
Indicator and warning lights
Visual indicators which inform the driv-
er when a system comes into opera-
tion (operation or deactivation indicator
lights) or of the occurrence of a fault
(warning light).
Associated warnings
The lighting of certain indicator/warning
lights may be accompanied by an audible
signal and a message on the multifunction
display. Operation indicator lights
The lighting of one of the following indica-
tor lights confi rms that the corresponding
system has come into operation.

Left-hand direction
indicator.

Handbrake applied.

Right-hand direction
indicator.

Main beam headlamps.

Dipped headlamps.

Diesel engine pre-heating.
Wait until this switches off before
operating the starter.

Front fog lamps.

Rear fog lamps.
When the ignition is switched on
The warning lights come on for a few
seconds when the vehicle ignition is
switched on.
When the engine is started, these warning
lights should switch off.
If they remain on, before moving off,
consult the text relating to the warning
light concerned.

!
21
When the engine is running or the vehi-
cle is moving, the lighting of one of the
following warning lights indicates the
occurrence of a fault which requires
action on the part of the driver. Centralised alert.
Lighting of the centralised alert
is associated with the lighting
of another warning light:
- punctured wheel,
- braking,
- engine oil pressure,
- coolant temperature.
It is imperative that the vehicle is
stopped as soon as it is safe to do so. Service.
Lighting of the service warning
light indicates the occurrence of
a problem in one of the systems
which does not have a specifi c
warning light.
To identify the problem, consult the
message on the multifunction display.
After checking:
- the remote control battery,
- the engine oil level,
- the screenwash level,
for other cases, contact a PEUGEOT
dealer.
Punctured tyre.
The lighting of this warning light
indicates that one or more tyres
are punctured. It is imperative
that the vehicle is stopped as soon as it
is safe to do so.
Change the damaged wheel and have it
repaired by a PEUGEOT dealer.
Anti-lock braking system
(ABS).
The lighting of this warning light
indicates the occurrence of a fault
in the anti-lock braking system.
However, this does not prevent the opera-
tion of the vehicle’s assisted braking.
Any fault resulting in the lighting of
a warning light must be the subject
of further diagnostics by reading
the associated message on the
multifunction display.
If a problem arises, do not hesitate
to contact a PEUGEOT dealer.
Warning lights

i
23
Coolant temperature indicator
System which informs the driver of the
changes in the temperature of the engine
coolant while driving.
With the engine running, when the
needle is:
- in zone A , the temperature is correct,
- in zone B , the temperature is too
high; the max temperature warning
light 1 and the central STOP warn-
ing light come on, accompanied by
an audible signal and a message on
the multifunction display.

You MUST stop as soon as it is safe
to do so.
Consult a PEUGEOT dealer. After driving for a few minutes, the tem-
perature and pressure in the cooling
system increase.
To top up the level:

 wait for the engine to cool,

 unscrew the cap by two turns to allow
the pressure to drop,

 when the pressure has dropped, re-
move the cap,

 top up the level to the "MAX" mark. Engine oil temperature
indicator
System which informs the driver of the
changes in the temperature of the engine
oil while driving.
With the engine running, when the
needle is:
- in zone
C , the temperature is correct,
- in zone D , the temperature is too
high; the oil pressure warning light
and the central STOP warning light
come on, accompanied by an au-
dible signal and a message on the
multifunction display.

You MUST stop as soon as it is safe
to do so.
Consult a PEUGEOT dealer.
On petrol engines, the cooling of
the engine is managed electroni-
cally to improve consumption. Con-
sequently, the coolant temperature
levels are no longer simply linked
with the external ambient condi-
tions and the use of the vehicle.
For example, in town, it is normal
for the coolant temperature to be
slightly higher in cold weather than
in hot weather.