2008 MITSUBISHI SHOGUN maintenance

6-8 For emergencies
6
5. Check the coolant level in the reserve tank (A). 6. Add
coolant to the radiator and/or reserve tank if neces-
sary. (Refer to the “Maintenance” section.)
7. Examine the radiator hoses
for coolant leakage and the
drive belt for looseness or damage. If there is anything wrong with the cooling system ordrive belt, we recommend you to have it check and repaired.
WARNING
!●
If there is none, make sure that the engine has cooled down before removi
ng the radiator cap (B),
because hot steam or boiling water otherwise will gush from the filler port and may scald you.
CAUTION
!●
Do not add coolant while the engine is hot. Suddenly adding cold coolant coul
d damage the engine. Wait
for the engine to cool down
, then add coolant a little
at a time.
BK-BK2008E1ENUK.en-uk-Section9.fm Page 8 Wednesday, January 9, 2008 4:46 PM

7-2 Vehicle care
7
Vehicle care precautions
E00900100375
In order to maintain the value of your vehicle, it is necessary to perform regular maintenance using the proper procedures. Always maintain your vehicle
in compliance with any environ-
mental pollution control regulations. Carefully select the mate- rials used for washing, etc., to be sure that they do not contain corrosives. If in doubt, we reco
mmend you to consult a special-
ist for selection of these materials.
CAUTION
!●
Cleaning products can be dangerous. Always follow the instructions of the cl
eaning product supplier.
●
To avoid damage, never us
e the following to clean
your vehicle:• Gasoline • Paint Thinner • Benzine • Turpentine• Naphtha • Lacquer Thinner • Carbon Tetrachloride • Nail Polish Remover • Acetone
BK-BK2008E1ENUK.en-uk-Section10.fm Page
2 Wednesday, January 9, 2008 4:48 PM

8
Maintenance
Service precautions . . . . . . . . . . . . . . . . . . . . . . . .8- 2 Catalytic converter . . . . . . . . . . . . . . . . . . . . . . . . .8- 3Bonnet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8- 3Engine oil . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8- 6Engine coolant . . . . . . . . . . . . . . . . . . . . . . . . . . . .8- 10Washer fluid . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8- 11Brake fluid . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8- 13Clutch fluid* . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8- 14Power steering fluid . . . . . . . . . . . . . . . . . . . . . . . .8- 16Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8- 16Tyres . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8- 19Parking brake break-in . . . . . . . . . . . . . . . . . . . . . .8- 24Wiper blade rubber replacement . . . . . . . . . . . . . .8- 25General maintenance . . . . . . . . . . . . . . . . . . . . . . .8- 27For cold and snowy weather . . . . . . . . . . . . . . . . .8- 28Fusible links . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8- 29Fuses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8- 29Replacement of lamp bulbs . . . . . . . . . . . . . . . . . .8- 36
BK-BK2008E1ENUK.en-uk-Section11.fm Page
1 Wednesday, January 9, 2008 4:50 PM

8-2 Maintenance
8
Service precautions
E01000100331
Adequate care of your vehicle at
regular intervals serves to pre-
serve the value and appear
ance as long as possible.
Maintenance items as described in this owner’s manual can beperformed by the owner. We recommend you to have the periodic inspection and main- tenance performed by a MITS
UBISHI MOTORS Authorized
Service Point or another specialist. In the event a malfunction or other problem is discovered, we recommend you to have it checked and repaired. This s
ection contains information on
inspection maintenance procedures that you can do yourself. Follow the instructions and
cautions for each of the various
procedures.
WARNING
!●
When checking or servicing
the inside of the engine
compartment, make sure th
e engine is switched off
and has had a chan
ce to cool down.
●
If it is necessary to do
work in the engine compart-
ment with the engine runni
ng, be especially careful
that your clothing, hair, et
c., does not become caught
by the fan, drive belts, or other moving parts.
●
Do not smoke, cause sparks or allow open flames around fuel or battery. The fumes are flammable.
●
Be extremely cautious wh
en working around the
battery. It contains poison
ous and corrosive sulphu-
ric acid.
●
Do not get under your vehicle with just the body jack supporting it. Always use automotive jackstands.
●
Improper handling of comp
onents and materials
used in the vehicle ca
n endanger your personal
safety. We recommend you to consult a specialist fornecessary information.WARNING
!
BK-BK2008E1ENUK.en-uk-Section11.fm Page
2 Wednesday, January 9, 2008 4:50 PM

Maintenance
8-3
8
Catalytic converter
E01000200550
For ordinary use, there are no
particular precautions except that
of using unleaded petrol. The exhaust gas scavenging de
vices used with the catalytic
converter are extremely efficien
t for the reduction of noxious
gases. The catalytic converter is
installed in the exhaust sys-
tem.It is important to keep the engine properly tuned to ensure proper catalyst
operation and prevent po
ssible catalyst damage.
NOTE●
In case of the petrol-power
ed vehicles, use UNLEADED
PETROL ONLY of the type recommended in “Fuel selec- tion” on page 2.
Bonnet
E01000301125
To open 1. Pull the release lever towards you to unlock the bonnet.
WARNING
!●
As with any vehicle, do not park or operate this vehicle in areas where comb
ustible materials such as
dry grass or leaves can come in contact with a hotexhaust since a fire could occur.
●
Paint should not be applied to the catalytic con- verter.
LHD
BK-BK2008E1ENUK.en-uk-Section11.fm Page
3 Wednesday, January 9, 2008 4:50 PM

8-4 Maintenance
8
2. Raise the bonnet while pressing the safety lock. NOTE●
Only open the bonnet when th
e wipers are in the parked
position. Failure to do so may cause bonnet damage.
RHDBK-BK2008E1ENUK.en-uk-Section11.fm Page
4 Wednesday, January 9, 2008 4:50 PM

Maintenance
8-5
8
3. Support the bonnet by inserting the support bar in its slot.
To close 1. Unlatch the support bar and clip it in its holder. 2. Slowly lower the bonnet to a position about 30 cm above
the closed position, then let it drop.
3. Make sure the bonnet is securely locked by softly lifting
the centre of the bonnet.
NOTE●
If this does not close the bonne
t, release it from a slightly
higher position.
●
Do not press down the bonnet hard with a hand as it may damage the bonnet.
CAUTION
!●
Note that the support bar may disengage the bonnet if the open bonnet is lifted by a strong wind.
●
After inserting the suppor
t bar into the slot, make
sure the bar supports the bonnet securely from fall-ing down on to your head or body.
CAUTION
!●
Be careful that hands or fingers are not trapped when closing the bonnet.
BK-BK2008E1ENUK.en-uk-Section11.fm Page
5 Wednesday, January 9, 2008 4:50 PM

8-6 Maintenance
8
Engine oil
E01000401171
To check and refill engine oil
The engine oil used has a signifi
cant effect on the engine’s per-
formance, service life and startabi
lity. Be sure to use oil of the
recommended quality and appropriate viscosity. All engines consume a certain amount of oil during normal operation. Therefore, it is important to check the oil level atregular intervals or before starting a long trip.
3200 models
3800 models
BK-BK2008E1ENUK.en-uk-Section11.fm Page
6 Wednesday, January 9, 2008 4:50 PM