2008 MITSUBISHI COLT wheel size

General information5
4. To fill with fuel correctly mainly depends on correct han-dling of the fuel filler gun. Do not tilt the gun. Insert the
gun in the tank port as far as it will go.
5. When the gun stops automatically, withdraw it halfway in the tank port. After the second automatic stop, do not fill
with any more fuel.
6. To close, turn the fuel tank filler tube cap slowly clock-
wise until you hear a clicking sound, then gently push the
fuel tank filler door closed.Installation of accessories
E00200300413
We recommend you to consult your MITSUBISHI MOTORS
Authorized Service Point.
● The installation of accessories, optional parts, should only
be carried out within the limits prescribed by law in your
country, and in accordance wi th the guidelines fitting
instructions and warnings contained within the documents
accompanying the parts or accessories.
● Improper installation of electrical components may cause
an electrical fire if incorrect ly fitted. Please refer to the
“Modification/alterations to th e electrical or fuel systems”
section within this owner’s manual.
● Using a cellular phone or radio set inside the vehicle with-
out an external antenna may cause electrical system inter-
ference, which could lead to unsafe vehicle operation.
● Tyres and wheels which do no t meet specifications must
not be used.
Refer to the “Specifications ” section for information
regarding wheel and tyre sizes.
CAUTION!
● A label which reads “UNLEADED FUEL ONLY” is
attached to the fuel tank f iller lid of vehicles which
can only operate on unlead ed petrol. Serious engine
and catalytic converter damage will result if leaded
petrol is put into these ve hicles, and this must conse-
quently never be attempted.
CAUTION!
● To avoid fuel spillage and overfilling, do not “top-
off” the fuel tank.
CAUTION!
●If you need to replace the fuel tank filler tube cap,
use only the cap specified for your vehicle model.

Starting and driving4-37
4
●Operation of ABS is not rest ricted to situations where
brakes are applied suddenly. Th is system may also operate
to prevent wheel lock when you are driving over man-
holes, steel road-work plates, or the vehicle is driven over
steps or level differences in the road, road markings, or
other surfaces which are diffic ult for the wheels to grip.
● When the ABS is activated, you may feel the brake pedal
pulsating and hear a characteristic noise. Also at this time,
it may feel as if the pedal attempts to resist being
depressed.
In this situation, to let the ABS work for you, just hold
the brake pedal down more firmly. Do not pump the
brake. This will result in reduced braking perform-
ance.
CAUTION!
● Even the ABS cannot prevent the natural laws of
physics from acting on th e vehicle. It cannot for
instance avoid accidents that may result from exces-
sive speed on bends or following another vehicle too
closely or aquaplaning. It should remain the driver’s
task to observe safety pr ecautions to judge speeds
and brake applications corr ectly in such conditions.
●Be sure to use tyres of the same type and size on 4
wheels.
If tyre types or sizes are mixed, ABS may not func-
tion properly.
●Never install a limited slip differential, which is not
MITSUBISHI MOTORS genuine parts, as the ABS
may not function properly.
We recommend to consult a MITSUBISHI
MOTORS Authorized Service Point.
CAUTION!

4-42 Starting and driving
4Traction control system (TCL)/Active
stability control system (ASC)
*
E00611700033
The traction control system (TCL )/active stability control sys-
tem (ASC) takes overall control of the anti-lock brake system,
traction control system and activ e stability control system to
help maintain the vehicle’s control and traction. Please read
this section in conjunction with the page on the anti-lock brake
system, traction control system and active stability control sys-
tem.
Anti-lock brake system (ABS) → P. 4-36
Traction control system (TCL) → P. 4-43
Active stability control system (ASC) → P. 4 - 4 3
NOTE● Immediately after the vehicle starts moving after engine
start up, a whining sound of a motor will be heard from
the engine compartment. If the brake pedal is depressed at
that moment, a brake pedal pulsating is felt.
This whining sound and pulsation are due to the self-diag-
nosis operation of the traction control system (TCL)/
active stability control system (ASC) and does not indi-
cate a malfunction.
● Some vibration will be felt in the vehicle body and a
whining sound of a motor will be heard from the engine
compartment when the tract ion control system (TCL)/
active stability control system (ASC) functions. This is a
normal result of the traction control system (TCL)/active
stability control system (ASC) operation, and does not
indicate a malfunction.
● The traction control system (T CL)/active stability control
system (ASC) does not operate while the ABS warning
lamp is illuminated.
CAUTION!
● Do not over-rely on the traction control system
(TCL)/active stability control system (ASC). Even
when the traction control system (TCL)/active sta-
bility control system (ASC ) is operating, there are
limits to the system and its ability to maintain con-
trol and traction. Reckless driving may lead to acci-
dents. Always drive carefully, taking account of the
road conditions.
● Be sure to use the same specified type and size of
tyre on all 4 wheels. Otherw ise, there is a possibility
that the traction control system (TCL)/active stabil-
ity control system (ASC) will not work properly.

6-26 For emergencies
6
●The vehicle must not be driven at speeds in excess of
80 km/h (50 mph) while using the compact spare
wheel.
● The compact spare tyre is not as good as a standard
tyre in controllability and stability. When the com-
pact spare tyre is used, avoid quick starts, sudden
braking and sharp steering.
●Avoid driving through au tomatic vehicle washers
and over obstacles that could possibly damage the
vehicle’s undercarriage. Because the compact spare
wheel is smaller than th e original wheel, ground
clearance is slightly reduced.
● The compact spare wheel is specifically designed for
your vehicle and it should not be used on any other
vehicle.
CAUTION!CAUTION!
● Do not use a tyre chain with your compact spare
wheel. Because of the small er tyre size, a tyre chain
will not fit properly. This could cause damage to the
wheel and result in the loss of the chain.
If a front tyre becomes flat when using tyre chains,
first replace a rear wheel with the compact spare
wheel and then use the removed rear wheel to
replace the flat front wheel so that you can continue
to use the chains.

6-34 For emergencies
6
Wheel covers*E00801300298
To remove
1. Wrap the tip of the wheel nut wrench (if so equipped) or
straight blade (or minus) screwdriver with a cloth, insert it
deeply behind a spoke of the wheel cover, and use it to
lever up the cover a little.
2. With the cover raised a little, pry it off completely using the wheel nut wrench. Insert the wheel nut wrench under
the cover, and move it around the circumference, prying
the cover away from the wheel little by little as you move
the wheel nut wrench around.
NOTE● The wheel cover is made of pl astic; take care when prying
it off.
● The compact spare tyre is to be used only temporar-
ily when the standard tyre is damaged. Repair the
damaged tyre as soon as possible and use it to
replace the compact spare tyre.
● After changing the tyre and driving the vehicle
about 1,000 km (620 miles) , retighten the wheel nuts
to make sure that they have not come loose.
● If the steering wheel vibr ates when driving after
changing the tyre, we recommend that you have the
tyres checked for balance.
● Do not mix one type of tyre with another or use a
different size from the one listed. This will cause
early wear and poor handling.
CAUTION!

8-20 Maintenance
8
Wheel conditionE01001800407
Check the tyres for cuts, cracks and other damage. Replace the
tyres if there are deep cuts or cracks. Also check each tyre for
pieces of metal or pebbles.
The use of worn tyres can be very dangerous because of the
greater chance of skidding or h ydroplaning. The tread depth of
the tyres must exceed 1.6 mm in order for the tyres to meet the
minimum requirement for use.
If there are tread wear indicator s on the tyres, they will appear
in six places on the surface of the tyre as the tyre wears,
thereby indicating that the tyre no longer meets the minimum
requirement for use. When thes e wear indicators appear, the
tyres must be replaced with new ones. Check that the wheel nuts are ti
ghtened correctly. Refer to the
section entitled “For emergencies” for information concerning
replacement of the tyres.
NOTE● The mark and the location of th e tyre tread wear indicators
are different depending on the tyre manufacturer.
Replacing tyres and wheelsE01007200038
1- Location of the tread wear indicator
2- Tread wear indicator
CAUTION!
●Avoid using different size tyres from the one listed
and the combined use of di fferent types of tyres, as
this can affect driving safety.
Refer to “Tyres and wheels” on page 9-15.
● Even if a wheel has the sa me rim size and offset as
the specified type of wheel , its shape may prevent it
from being fitted correct ly. We recommend you to
consult a specialist befo re using wheels that you
have.

8-22 Maintenance
8
Snow tyresE01002000549
The use of snow tyres is recommended for driving on snow and
ice. To preserve driving stability, mount snow tyres of the same
size and tread pattern on all four wheels.
Snow tyres worn more than 50 % are no longer suitable for use
as snow tyres.
Snow tyres which do not meet the specifications must not be
used.
NOTE● The laws and regulations concerning snow tyres (driving
speed, required use, type, etc.) vary. Find out and comply
with the laws and regulations in the area you intend to
drive in.
● If flange nuts are used on your vehicle, change to tapered
nuts when steel wheels are used.
Tyre chains E01002101039
If tyre chains have to be used, ensure that they are fitted only
on the drive wheels (front).
Use only tyre chains which are designed for use with the tyres
mounted on the vehicle: use of the incorrect size or type of
chain could result in damage to the vehicle body.
Before fitting tyre chains, we recommend that you consult a
MITSUBISHI MOTORS Authorized Service Point. The Max.
chain height is as follows.
CAUTION!
● If the tyres have arrows (A) indicating the correct
direction of rotation, swap the front and rear wheels
on the left hand side of th e vehicle and the front and
rear wheels on the right hand side of the vehicle sep-
arately. Keep each tyre on its original side of the
vehicle. When fitting the tyres, make sure the
arrows point in the dir ection in which the wheels
will turn when the vehicle moves forward. Any tyre
whose arrow points in the wrong direction will not
perform to its full potential.
CAUTION!
● Avoid the combined use of different types of tyres.
This can affect driving safety.
Front
CAUTION!
●Observe the permissible maximum speed for your
snow tyres and the legal speed limit.

Maintenance8-23
8
The speed limit for tyre chains is 50 km/h (31 mph). Remove
the tyre chains as soon as possible on snow-free roads.
Ty r e s i z eWheel sizeMax. chain height [mm]
175/65R14*1, *214x5.5 J 12
185/55R15*
315x6.0 J
*
1: Petrol-powered vehicles with turbocharger have 15-inch
brakes, so 14-inch tyres and wheels cannot be used on them.
*
2: Use only 175/65R14 snow tyres (M + S) with the 1500 mod-
els of the petrol-powered vehicles without turbocharger
*
3: Snow tyres (M + S) only
CAUTION!
●
For vehicle with 195/50R15 or 205/45R16 tyres,
chains should not be us ed. The clearance between
the chains and the body is small, and the body might
be damaged.
However, if chains must be used on vehicles with
195/50R15 or 205/45R16 tyres, because of adverse
road conditions such as sn ow or ice, proceed as fol-
lows:
Change all the original tyres (including wheels) to
175/65R14 tyres (14 x 5.5 J wheels) or 185/55R15 M
+ S tyres (15 x 6.0 J wheels) and then use the chains
on the front wheels.
WARNING!
● DO NOT use a jack when fitting the chains, as in the
conditions, the tyres may sl ip on the icy road, caus-
ing the vehicle to slip off the jack.
CAUTION!
● Practice fitting the chains before you need them.
Don’t expect help from ot her people in the cold.
●Choose a clear straight stretch of road where you
can pull off and still be seen while you are fitting the
chains.
● Do not fit chains before you need them. This will
wear out your tyres and the road surface.
●After driving for about 100-300 metres, stop and
retighten the chains.
●Care should be taken with extremes of steering lock
to prevent possible contac t between the chains and
the vehicle body.
● Drive carefully and do no t exceed 50 km/h (31 mph).
Remember, fitting chains is not going to stop acci-
dents from happening.
● When tyre chains are instal led, take care that they
do not damage the disc wheel or body.