2008 MITSUBISHI COLT seats

2-4 Seat and seat belts
2Seat adjustment
E00400300415
Adjust the driver’s seat so
that you are comfortable and can
reach the pedals, steering wheel, sw itches etc. while retaining a
clear field of vision.
WARNING!
● Do not attempt to adjust the seat while driving. This
can cause loss of vehicle control and result in an
accident. After making adjustments, ensure the seat-
ing is locked in position by attempting to move the
seat forward and backward without using the
adjusting mechanism.
●It is extremely dangerous to ride in the vehicle's lug-
gage area (inside or outside). The luggage area and
rear seats should never be used as a play area by
children. In a collision, pe ople or children travelling
unrestrained in these areas are more likely to be
seriously injured or killed.
Do not allow people or children to travel in any area
of your vehicle that is not equipped with seats and
seat belts, and make sure that everyone travelling in
your vehicle is in a seat and wearing a seat belt, or in
the case of a child, is strapped in a child restraint.
● To minimize the risk of pers onal injury in the event
of a collision or sudden braking, the seatbacks
should always be in the almost upright position
while the vehicle is in motion. The protection pro-
vided by the seat belts may be significantly reduced
when the seatback is recl ined. There is greater risk
of the passenger sliding under the seat belt, resulting
in serious injury, when th e seatback is reclined.
CAUTION!
●Make sure the seat is adjusted by an adult or with
adult supervision for corr ect and safe operation.
●Do not place a cushion or similar between your back
and the seatback while driv ing. The effectiveness of
the head restraints will be reduced in the event of an
accident.
● When sliding the seats, be careful not to trap your
hand or foot.
●When sliding or reclinin g the seat backward, pay
careful attention to the rear seat passengers.
WARNING!

Seat and seat belts2-7
2
Heated seats*E00401100162
The heated seats can be operated with the ignition switch in the
“ON” position.
The indicator lamp (A) will illuminate while the heater is on.
CAUTION!
● The reclining mechanism of the seatback is spring
loaded, causing it to return to the vertical position
when the lock lever is op erated. When operating the
lever, sit close to the seatback or hold it with your
hand to control its return motion.
1- Heater high (for quick heating).
2- Heater off.
3- Heater low (to keep the seat warm).
CAUTION!
● Operate in the high positi on for quick heating. Once
the seat is warm, set the heater to low to keep it
warm. Slight variations in seat temperature may be
felt while using the heated seats. This is caused by
the operation of the heater ’s internal thermostat and
does not indicate a malfunction.

2-8 Seat and seat belts
2
NOTE●Do not place heavy objects on th e seat or stick pins, nee-
dles, or other pointed objects into it.
● When cleaning the seat, do not use benzene, gasoline,
alcohol, or other organic solvents; this might damage the
surface of the seat and al so the heater element.
● If water or any other liquid is spilled on the seat, allow it
to dry thoroughly before attempting to use the heater.
Rear seat*
E00401300207
NOTE●It is possible to adjust each si de of the rear seats forward
and backward independently of the other side (5-door
models, separated seat only), to adjust the seatback angle
independently on each side, a nd to fold the seatback for-
ward independently on each side.
● If the following types of p ersons use the heated seats,
they might become too ho t or receive minor burns
(red skin, heat blisters, etc.):
• Children, elderly or ill people
• People with sensitive skin
• Excessively tired people
• People under the influence of alcohol or sleep inducing medication (cold medicine, etc.)
● Do not use a blanket, cushio n, or other material with
high heat insulation properties on the seat while
using the heater; this might cause the heater element
to overheat.
● Turn the heater off immediately if it appears to be
malfunctioning during use.
CAUTION!
WARNING!
●When a person is sitting in the rear seats, pull up the
head restraint to a height at which it locks in posi-
tion. Be sure to make this adjustment before starting
to drive. Serious injuries could otherwise result in
an impact. Refer to “Head restraints” on page 2-10.

2-12 Seat and seat belts
2Making a luggage area
E00403400215CAUTION!
●
Confirm that the height adjusting knob (A) is cor-
rectly adjusted as shown in the illustration, and also
lift the head restraints to ensure that they do not
come out of the seatback.
CAUTION!
● The head restraints for the front and rear seats dif-
fer in size. When installi ng head restraints, make
sure the front and rear head restraints are fitted in
their respective seats.
Failure to do so could cause serious injury in the
event of an accident.
WARNING!
● If required, always adjust the seating before the
vehicle is in motion.
● After seat adjustments are made, ensure the seating
is locked in position by attempting to move the seat
and seatback forward and backward without using
the adjusting mechanism.
● The luggage area in the re ar of the vehicle should
never be used as a play area by children. Children
should be seated with seat belts fastened when the
vehicle is in motion. Ensure that the rear seatbacks
are returned to their fully upright position and
locked in place.
CAUTION!
● Do not stack luggage above the seatback height.
Secure the luggage firmly.
Otherwise, serious accide nts could result due to
restricted rear vision or unrestrained objects enter-
ing the passenger comp artment during sudden
braking.
● Make sure that the seat is operated by an adult. If it
is operated by a child, an unexpected accident might
occur.
● When folding or removing the seat (5-door models,
separated seat only), take care not to trap your hand
or leg.

2-16 Seat and seat belts
2
5. Securely retain the rear seat by hooking the retainingbands onto the head restraints of the front seats.
CAUTION!
● Do not slide the rear se at while pulling the lock
release lever. This may bend the fittings of the lock
mechanism, which m ay prevent unlocking.
Bench seat*
WARNING!
●Be sure to securely retain the folded seat using the
retaining bands. Unless retained, the seat may tip,
causing a serious accident.
CAUTION!
● Do not allow anyone to sit on the folded seat, and do
not place luggage on it. The seat’s mounting fittings
could bend under the weight, making it impossible
for the seat to be retained on the vehicle.
● Do not put rubbish or ot her foreign matter in the
seat retaining holes in the floor. Doing so could pre-
vent the seat being retained on the floor.
Separated seat (5-door models)*

2-26 Seat and seat belts
2
Adjustable seat belt anchor (front seats)E00405000055
The seat belt anchor height can be adjusted.
Move the seat belt anchor down with the lock knob (A)
depressed. To move the anchor up, slide it without depressing
the lock knob (A).
Rear-centre 3-point type seat belt
(5-door models)
E00405200031
The rear-centre 3-point type seat belt must be worn correctly as
illustrated.
CAUTION!
● When adjusting the seat belt anchor, set it at a posi-
tion that is sufficiently high to ensure that the belt
makes full contact with your shoulder but does not
touch your neck.
Anchor down Anchor up

2-40 Seat and seat belts
2
Installing a child restraint system to the lower
anchorage (ISOFIX child restraint mountings)
E00408900228
Your vehicle’s rear seat is fitted with lower anchorages for
attaching a child restraint sy stem with ISOFIX mountings.
Child restraint system with ISOFIX mountingsE00409000473
The child restraint system is designed only for seats that incor-
porate lower anchorages. Retain the child restraint system
using the lower anchorages.
It is not necessary to retain th e child restraint system using the
vehicle’s seat belts. Only a MITSUBISHI MOTORS genuine
child restraint system can be used.
Genuine parts No. : MZ313200
ECE No. : E1-04301133
A: Child restraint system connectors

Seat and seat belts2-41
2
To i n s t a l l
1. Slide the rear seats to the fully backward position. (Refer
to “To adjust forward or backward” on page 2-9.)
2. Push the child restraint syst em’s connectors (A) into the
slit (B) in accordance with the instructions provided by
the child restraint system’s manufacturer.WARNING!
● If a child restraint system other than a
MITSUBISHI MOTORS genuine one is used, it may
not be properly retained an d the child could be seri-
ously injured as a result. Use only a MITSUBISHI
MOTORS genuine child restraint system.
A: Connector
B: Slit
C: Vehicle seatback
D: Vehicle seat cushion E: Lower anchorage