11
Operation on the onboard monitor
The following functions can be operated on the
onboard monitor:
>Accepting/rejecting calls
>Dialing a phone number
>Dialing a phone number from the phone
book
>Dialing a stored phone number, e. g. from
the list of accepted calls
>Terminating a call
When the ignition and radio standby mode are
switched off, e.g. after taking the remote control
out of the ignition switch, you can continue an
ongoing call via the hands-free system for a
maximum of 25 minutes.
Voice quality
If the person you are talking to is unable to hear
you clearly, this may be due to excessive back-
ground noise. The mobile phone preparation
can compensate for these noises to a certain
degree. To optimize voice quality, we recom-
mend the following:
>Reduce background noise, e. g. by closing
the windows, lowering the air volume of the
air conditioning system or opening the four
front air vents and pointing them down-
ward.
>Reduce the volume of the hands-free sys-
tem.
Requirements
>The pairing data of the mobile phone are
stored in the vehicle and the mobile phone is
ready to operate.
>The engine is running or the ignition is
switched on.
>The mobile phone is recognized by the vehi-
cle.
Opening communication
menu
Many of the functions described below can be
operated in the "Communication" menu.
Onboard monitor, concept, refer to Owner's
Manual for Vehicle.
1. Press the button to open the start menu.
2.Move the MINI joystick to highlight "Com-
munication" and press the MINI joystick.
Receiving a call
If you have the phone number of the caller
stored in the phone book and the phone num-
ber is transmitted, the name of the entry will be
displayed.
Accepting a call
Press the button on the steering wheel.
Alternatively:
Select "Accept".
ba.book Seite 11 Freitag, 6. Juli 2007 10:48 10
18
Snap-in adapter
Inserting/removing the
snap-in adapter
1.Press area 1 surrounding the button and
remove the cover.
2.Insert the snap-in adapter in the front,
arrow1, and press it downward, arrow 2,
until it engages.
3.To remove the snap-in adapter, press area 1
surrounding the button.
Inserting/removing the
mobile phone
1.If present, remove the protective cap of the
mobile phone antenna connector so that
the mobile phone can snap into place in the
base plate.
2.With the buttons facing up, slide the mobile
phone toward the connectors and press
down until it snaps into place.
The battery will be charged when the vehicle is
at least in radio readiness mode, see the charge
display on the mobile phone.
To remove the mobile phone:
Press button.
ba.book Seite 18 Freitag, 6. Juli 2007 10:48 10
