2008 Mercury Mariner Hybrid engine

[x] Cancel search: engine

Page 194 of 320

Mercury Mariner Hybrid 2008  Owners Manuals Understanding the gearshift positions of the
electronically-controlled Continuously Variable Transaxle (eCVT)
P (Park)
This position locks the transaxle and prevents the front wheels from
turning.
To

Page 195 of 320

Mercury Mariner Hybrid 2008  Owners Manuals N (Neutral)
With the gearshift lever in N (Neutral), the vehicle is free to roll; hold
the brake pedal down while in this position. Because of the unique
nature of the hybrid vehicle, the engine will

Page 199 of 320

Mercury Mariner Hybrid 2008  Owners Manuals If your vehicle goes off the edge of the pavement
•If your vehicle goes off the edge of the pavement, slow down, but
avoid severe brake application, and ease the vehicle back onto the
pavement only

Page 204 of 320

Mercury Mariner Hybrid 2008  Owners Manuals DRIVING THROUGH WATER
If driving through deep or standing
water is unavoidable, proceed very
slowly especially when the depth is
not known. Never drive through
water that is higher than the bottom
of

Page 207 of 320

Mercury Mariner Hybrid 2008  Owners Manuals HAZARD FLASHER CONTROL
The hazard flasher is located on the
steering column, just behind the
steering wheel. The hazard flashers
will operate when the ignition is in
any position or if the key is not

Page 212 of 320

Mercury Mariner Hybrid 2008  Owners Manuals Fuse/Relay
LocationFuse Amp
RatingPassenger Compartment Fuse
Panel Description
28 5A Radio
29 5A Instrument panel cluster
30 5A Not used (spare)
31 10A Compass module
32 10A Restraints control module

Page 218 of 320

Mercury Mariner Hybrid 2008  Owners Manuals When driving with the full-size dissimilar spare tire/wheel additional
caution should be given to:
•Towing a trailer
•Driving vehicles equipped with a camper body
•Driving vehicles with a load o

Page 223 of 320

Mercury Mariner Hybrid 2008  Owners Manuals •Rear
View shown from forward of rear
tire. Position the jack directly below
the stud on the rear trailing arm.
3. Position the jack according to the
guides and turn the jack handle
clockwise until