2008 MERCEDES-BENZ SLK55AMG wiper blades

Contents
Replacing wiper blades ...................... 406
Placing wiper arms in vertical
position ........................................ 406
Removing wiper blades ................ 407
Installing wiper blades.................. 407
Flat tire .............................................. 408
Preparing the vehicle.................... 408
Sealing tires with TIREFIT ............. 408
Mounting the spare wheel ............ 414
MOExtended system*................... 421
Battery ............................................... 422
Disconnecting the battery ............ 423
Removing the battery ................... 424
Charging and reinstalling battery . 424
Reconnecting the battery ............. 425
Jump starting ..................................... 426
Towing the vehicle ............................. 428
Installing towing eye bolt.............. 429
Fuses ................................................. 432
Fuse box in passenger
compartment................................ 433
Fuse box in engine
compartment................................ 433
Technical data................................. 435
Parts service ...................................... 436
Warranty coverage............................. 437
Loss of Service and Warranty
Information Booklet ..................... 437
Identification labels ........................... 438
Layout of poly-V-belt drive ................. 440
SLK 280, SLK 350 ........................ 440
SLK 55 AMG................................. 440
Engine................................................ 441
Rims and tires.................................... 442
Same size tires ............................. 443
Mixed size tires ............................ 445
Spare wheel ................................. 447
Electrical system ............................... 448
Main Dimensions ............................... 449
Weights.............................................. 450Fuels, coolants, lubricants, etc. ......... 451
Capacities .................................... 451
Engine oils ................................... 453
Engine oil additives ...................... 453
Air conditioning refrigerant .......... 453
Brake fluid.................................... 454
Premium unleaded gasoline ......... 454
Fuel requirements ........................ 455
Gasoline additives ........................ 455
Coolants ...................................... 456
Windshield washer system and
headlamp cleaning system*......... 458
Index................................................. 459

23 At a glance
Exterior view
ItemPage
1Trunk
Opening the trunk99
Closing the trunk100
Spare wheel392
Vehicle tool kit389
2Rear lamps400
3Rear window defroster170
4Fuel filler flap291
Refueling291
Gasoline454
5Doors
Locking and unlocking94
Opening98
Locking/unlocking in an
emergency394
ItemPage
6Towing428
Installing towing eye bolt429
7Tires and wheels304
Checking tire inflation
pressure313
General information304
Flat tire408
8Front lamps400
9Hood
Opening294
Engine oil296,
453
Coolant300,
456
ItemPage
aWindshield wipers56
Wiper blades, replacing406
Wiper blades, cleaning343
bWindshield
Cleaning with wiper fluid58
Cleaning343
cRetractable hardtop240
Opening/closing242
Wind screen246
Luggage cover241
dExterior rear view mirrors
Adjusting46
Auto-dimming rear view
mirrors*168

56 Getting started
Driving
Press the combination switch in
direction of arrow1 or2.
The corresponding turn signal indicator
lampKorL in the instrument
cluster flashes (
page 26).
The combination switch resets auto-
matically after major directional chang-
es.
Windshield wipers
The combination switch is located on the
left of the steering column.
Combination switch
1Single wipe
Wiping with windshield washer fluid
2Switching on windshield wipers
Switch on the ignition (page 37).
iTo signal minor directional changes such as
changing lanes, press combination switch only
to point of resistance and release. The corre-
sponding turn signals will flash three times.
!Do not operate the windshield wipers when
the windshield is dry. Dust that accumulates on
a windshield might scratch the glass and/or
damage the wiper blades when wiping occurs on
a dry windshield. If it is necessary to operate the
windshield wipers in dry weather conditions,
always operate the windshield wipers with
windshield washer fluid (
page 58).
!If anything blocks the windshield wipers
(leaves, snow, etc.), switch them off
immediately.

For safety reasons, stop the vehicle in a safe
location, turn off the engine and remove the
SmartKey from the starter switch before
attempting to remove any blockage.

Remove blockage.

Turn the windshield wipers on again.
If the windshield wipers fail to function at all with
the combination switch in positionI,

set the combination switch to the next
higher wiper speed

have the windshield wipers checked at the
nearest authorized Mercedes-Benz Center

57 Getting started
Driving
Switching on windshield wipers
Turn the combination switch to the
desired position depending on the
intensity of the rain.
0Windshield wipers off
IIntermittent wiping
IINormal wiper speed
IIIFast wiper speed
Intermittent wipingVehicles with rain sensor*:
Intermittent wiping interval is dependent
on wetness of windshield.
Turn the combination switch to
positionI.
Vehicles with rain sensor*:
After the initial wipe, pauses between
wipes are automatically controlled by the
rain sensor.!Vehicles with rain sensor*:
Do not leave windshield wipers on an intermit-
tent setting when the vehicle is taken to an auto-
matic car wash or during windshield cleaning.
Windshield wipers will operate in the presence of
water sprayed on the windshield, and windshield
wipers may be damaged as a result.
!Vehicles with rain sensor*:
If you have set intermittent wiping, dirt on the
surface of the rain sensor or optical effects
may cause the windshield wipers to wipe in an
undesired fashion. This could then damage
the windshield wiper blades or scratch the
windshield. You should therefore switch off
the windshield wipers when weather conditions
are dry.iIntermittent wiping is interrupted when the
vehicle is at a standstill and a door is opened.
This protects persons getting into or out of the
vehicle from being sprayed.
Intermittent wiping will be continued when all
doors are closed and

the clutch pedal is depressed (vehicles with
manual transmission)
or

the gear selector lever is in positionDorR
(vehicles with automatic transmission*)
or

the wiper setting is changed using the
combination switch

58 Getting started
Driving
Single wipe
Press the combination switch briefly in
direction of arrow1 (
page 58) to
the resistance point.
The windshield wipers wipe one time
without washer fluid.
Wiping with windshield washer fluid
Press the combination switch in direc-
tion of arrow1 (
page 58) past the
resistance point.
The windshield wipers operate with
washer fluid.
For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system*”
(
page 301).
Problems while driving
The engine runs erratically and misfires

An ignition cable may be damaged.

The engine electronics may not be
operating properly.

Unburned gasoline may have entered
the catalytic converter and damaged it.
Give very little gas.
Have the problem repaired by an au-
thorized Mercedes-Benz Center as
soon as possible.
The coolant temperature is above
248°F (120°C)
The coolant is too hot and is no longer
cooling the engine.
Stop the vehicle as soon as possible
and turn off the engine. Allow engine
and coolant to cool off.
Check the coolant level and add cool-
ant if necessary (
page 300).In case of accident
If the vehicle is leaking gasoline:
Do not start the engine under any
circumstances.
Notify local fire and/or police
authorities.
If the extent of the damage cannot be
determined:
Contact an authorized Mercedes-Benz
Center or call Roadside Assistance.
If no damage can be determined on the

Major assemblies

Fuel system

Engine mount
Start the engine in the usual manner.
iTo prevent smears on the windshield or
noisy/chattering wiper blades, wipe with
windshield washer fluid every now and then even
when it is raining.

343 Operation
Vehicle care
Ornamental moldings
For regular cleaning and care of very dirty
chrome-plated parts, use a chrome clean-
er.Headlamps, tail lamps, side makers,
turn signal lenses
Use a mild car wash detergent, such as
Mercedes-Benz approved Car
Shampoo, with plenty of water.Cleaning the windows and the wiper
blades
Make sure the hood is fully closed.
Switch on the ignition (page 37).
Turn combination switch to wiper
settingII (
page 56).
With wiper arms in vertical position,
switch off the ignition (
page 37).
iAfter running the vehicle through an
automatic car wash, wipe any wax off of the
windshield (
page 343). This will prevent
smears and reduce wiping noise which can be
caused by residual wax on the windshield.
When leaving the car wash, make sure that the
mirrors are folded out. Otherwise they may
vibrate.
!Do not use chrome cleaner on ornamental
moldings. Although ornamental moldings may
have chrome appearance, they could be made of
anodized aluminum that will be damaged when
cleaned with chrome cleaner. Instead, use a
damp cloth to clean those ornamental moldings.
For very dirty ornamental moldings of which
you are sure are chrome-plated, use a chrome
cleaner. If in doubt whether an ornamental mold-
ing is chrome-plated, contact an authorized
Mercedes-Benz Center.
!Only use window cleaners that are suitable
for plastic lamp lenses. Window cleaning solu-
tions which are not suitable may damage the
plastic lamp lenses of the headlamps. Therefore,
do not use abrasives, solvents or cleaners that
contain solvents.
Never apply strong force and use only a soft,
non-scratchy cloth when cleaning the lenses. Do
not attempt to wipe dirty lenses with a dry cloth
or sponge.
Otherwise you may scratch or damage the lens
surface.
!The windshield wipers must be in a vertical
position before folding them away from the wind-
shield. They could otherwise damage the hood.
Never open the hood when the wiper arms are
folded forward.
Warning!G
For safety reasons, switch off wipers and
remove SmartKey from starter switch be-
fore cleaning the windshield and/or the wip-
er blades. Otherwise, the wiper motor could
suddenly turn on and cause injury.


347 Practical hints
What to do if …
Where will I find...?
Unlocking/locking in an emergency
Opening/closing in an emergency
Replacing SmartKey batteries
Replacing bulbs
Replacing wiper blades
Flat tire
Battery
Jump starting
Towing the vehicle
Fuses

406 Practical hints
Replacing wiper blades
Placing wiper arms in vertical position
1Wiper arms
Turn the SmartKey in the starter switch
to position1 (
page 37).
Turn combination switch to wiper
settingII (
page 56).
With wiper arms 1 in vertical position,
turn the SmartKey in the starter switch
to position0.
Remover the SmartKey from the starter
switch.
Warning!G
For safety reasons, switch off wipers and
remove the SmartKey from the starter
switch before replacing a wiper blade.
Otherwise, the motor could suddenly turn
on and cause injury.
Warning!G
Wiper blades are components that are
subject to wear and tear. Replace the wiper
blades twice a year, preferably in the spring
and fall. Otherwise the windows will not be
properly wiped. As a result, you may not
be able to observe surrounding traffic condi-
tions and could cause an accident.
!To avoid damage to the hood:

The wiper arms should only be folded for-
ward when in the vertical position.

Never open the hood when a wiper arm is
folded forward.
!Hold on to the wiper when folding the wiper
arm back. If released, the force of the impact
from the tensioning spring could crack the wind-
shield.
Do not allow the wiper arms to contact the wind-
shield glass without a wiper blade inserted.
For your convenience, we recommend that you
have this work carried out by an authorized
Mercedes-Benz Center.