2008 MERCEDES-BENZ SL55AMG adding oil

285 Operation
Engine compartment
If necessary, add engine oil.
For information on adding engine oil, see
(
page 286).
For more information on engine oil, see the
“Technical data” section (
page 457) and
(
page 460).
Other display messages
If the SmartKey or the KEYLESS-GO*
start/stop button is not in position2, the
following message will appear:
Turn ignition on
to measure
engine oil level
.
Switch on the ignition (page 40).If you see the message:
Observe
Waiting Time
If the engine is at operating tempera-
ture, wait 5 minutes before repeating
the check procedure.
If the engine is not at operating temper-
ature yet, wait 30 minutes before re-
peating the check procedure.
If you see the message:
Engine Oil Level
Not With
Engine Running
Turn off the engine.
If the engine is at operating tempera-
ture, wait 5 minutes before checking
oil.
If the engine is at operating tempera-
ture yet, you must wait 30 minutes be-
fore checking oil.If there is excess engine oil with the engine
at normal operating temperature, the
following message will appear:
Engine Oil Level
Reduce Oil Level
Have excess oil siphoned or drained
off. Contact an authorized
Mercedes-Benz Center.
For more information on messages in the
display concerning engine oil, see the
“Practical hints” section (
page 388).
!Excess oil must be siphoned or drained off.
It could cause damage to the engine and
emission control system not covered by the
Mercedes-Benz Limited Warranty.

286 Operation
Engine compartment
Checking engine oil level with the oil
dipstick (SL 550 only)
When checking the oil level

the vehicle must be parked on level
ground

the vehicle must have been stationary
for at least 5 minutes with the engine
turned off
1Oil dipstick
2Upper mark
3Lower mark
Open the hood (page 282).
Pull out oil dipstick 1.
Wipe oil dipstick 1 clean.
Fully insert oil dipstick 1 into the dip-
stick guide tube.
Pull out oil dipstick 1 again after ap-
proximately 3 seconds to obtain accu-
rate reading.
The oil level is correct when it is be-
tween lower mark 3 (min.) and upper
mark 2 (max.) of the oil dipstick.
If necessary, add engine
oil (
page 286).
For more information on engine oil, see
“Technical data” section (
page 457) and
(
page 460).
For information on messages in the multi-
function display concerning engine oil, see
the “Practical hints” section (
page 388).Adding engine oil
iIn vehicles without an oil dipstick, the engine
oil level is measured via the control
system (
page 284).
iThe filling quantity between the upper and
lower marks on the oil dipstick is approximately
2.1 US qt. (2.0 l).
!Only use approved engine oils and oil filters
required for vehicles with Maintenance System.
For a listing of approved engine oils and oil fil-
ters, refer to the Factory Approved Service
Products pamphlet (USA only) in your vehicle
literature portfolio, or contact an authorized
Mercedes-Benz Center.
Using engine oils and oil filters of specification
other than those expressly required for the
Maintenance System, or changing of oil and oil
filter at change intervals longer than those called
for by the Maintenance System will result in
engine or emission control system damage not
covered by the Mercedes-Benz Limited
Warranty.

287 Operation
Engine compartment
Example illustration SL 550
1Filler cap
Example illustration SL 55 AMG
1Filler cap
Unscrew filler cap1 from filler neck.
Add engine oil as required. Be careful
not to overfill with oil.
Be careful not to spill any oil when adding.
Avoid environmental damage caused by oil
entering the ground or water.
Screw filler cap1 back on filler neck.
For more information on engine oil, see the
“Technical data” section (
page 457) and
(
page 460).
Transmission fluid level
The transmission fluid level does not need
to be checked. If you notice transmission
fluid loss or gear shifting malfunctions,
have an authorized Mercedes-Benz Center
check the automatic transmission.
Oil level in the ABC system
The oil level in the ABC system does not
need to be checked. If there is visible oil
loss or if malfunction messages appear in
the display, have an authorized
Mercedes-Benz Center check the ABC
system.!Excess oil must be siphoned or drained off.
It could cause damage to the engine and
emission control system not covered by the
Mercedes-Benz Limited Warranty.

463 Technical data
Fuels, coolants, lubricants, etc.
Coolants
The engine coolant is a mixture of water
and anticorrosion/antifreeze, which
provides:

corrosion protection

freeze protection

boiling protection (by increasing the
boiling point)
The cooling system was filled at the factory
with a coolant providing freeze protection
to approximately -35°F (-37°C) and corro-
sion protection.If the antifreeze mixture is effective to
-35°F (-37°C), the boiling point of the cool-
ant in the pressurized cooling system is
reached at approximately 266°F (130°C).
The coolant solution must be used year
round to provide the necessary corrosion
protection and increase in the boil-over
protection. Refer to Maintenance Booklet
for replacement interval.
Coolant system design and coolant used
stipulate the replacement interval. The
replacement interval published in the
Maintenance Booklet is only applicable if
MB 325.0 Anticorrosion/Antifreeze solu-
tion or other Mercedes-Benz approved
products of equal specification are used to
renew the coolant concentration or bring it
back up to the proper level.
For information on other Mercedes-Benz
approved products of equal specification,
refer to the Factory Approved Service
Products pamphlet (USA only) or contact
an authorized Mercedes-Benz Center.To provide important corrosion protection,
the solution must be at least
50% anticorrosion/antifreeze (equivalent
to freeze protection to approximately
-35°F [-37°C]). If you use a solution that is
more than 55% anticorrosion/antifreeze
(freeze protection to approximately
-49°F [-45°C]), the engine temperature
will increase due to the lower heat transfer
capability of the solution. Therefore,
do not use more than this amount of
anticorrosion/antifreeze.
If the coolant level is low, water and
MB 325.0 Anticorrosion/Antifreeze
should be used to bring it up to the proper
level (have cooling system checked for
signs of leakage). Please make sure the
mixture is in accordance with label instruc-
tions.
The water in the cooling system must meet
minimum requirements, which are usually
satisfied by normal drinking water. If you
are not sure about the water quality, con-
tact an authorized Mercedes-Benz Center.
! Add premixed coolant solution only. Adding
water and MB 325.0 Anticorrosion/Antifreeze
separately from each other, could cause engine
damage not covered by the Mercedes-Benz
Limited Warranty.

472 Index
Emergency operations
Glove box, Unlocking 404
Load assist, Lowering 406
Locking/unlocking the
vehicle 403, 405
Remote door unlock, Tele Aid 256
Trunk lid, Releasing from the
inside 121
Trunk lid, Unlocking 404
Emergency Tensioning Device see ETD
Emission control 277
Information label 445
System warranties 10
Engine
Block heater (Canada only) 328
Break-in recommendations 266
Cleaning 335
Compartment 282
Malfunction indicator lamp 29, 346
Number 445
Poly-V-belt layout 446
Starting 53
Tachometer 29
Technical data 447
Turning off 64Engine coolant see Coolant
Engine oil 283, 460
Adding 286, 457
Additives 460
Checking level, With control
system* 284
Checking level, With oil dipstick 286
Consumption 283
Filler cap 287
Filler neck 286, 287
Messages in the multifunction
display 285, 388
Oil dipstick 286
ESP
®89, 91
Switch 32
Switching off 93
Switching on 94
Synchronizing 367
Warning lamp 27, 342
ETD 82
Safety guidelines 72
Warning and indictor lamps 354
Exterior lamp switch 131
Exterior rear view mirrors 49, 185F
Filler cap, Engine oil 287
Filler neck, Engine oil 286, 287
First aid kit 400
Flat tire 417
Mounting the spare wheel 417
Preparing the vehicle 417
Spare wheel 400
Floormat* 247
Fluids
Automatic climate control
system 457
Automatic transmission 287, 457
Brake system 281, 457, 460
Capacities 457
Engine coolant 288, 457, 463
Engine oil 283, 457, 460
Power steering 457
Retractable hardtop, Hydraulics 457
Windshield washer and headlamp
cleaning system 457
Fog lamps 134
Messages in the multifunction
display 393, 394
Replacing bulbs 410

477 Index
Mirrors 49, 185
Adjusting interior rear view mirror 49
Exterior rear view mirrors 49
Misfiring 60
MOE tires* see MOExtended system*
MOExtended system* 312, 425
MOExtended tires* 449
MON 280
Mph or km/h in speedometer 160
Multifunction display 143
Left display 27
Right display 29
Selecting language 160
Standard display 143
Multifunction display messages
ABC 361
ABS 363, 364
Battery 377
Brake pads 380
Brake system 382
Coolant 383
Coolant level 385
Display malfunction 386Doors 386
Easy-entry/exit feature 386
Electro-hydraulic brake
system 378, 379
Hood 390
Luggage cover 399
Passenger front air bag 370
Restraint systems 373
Roll bar 396
SmartKey 390
SmartKey with KEYLESS-GO* 391
SRS 373
Tele Aid 396
Telephone* 396
Tires 397
Trunk 399
Washer fluid 399
Multifunction steering wheel 30, 144
Buttons 144N
Navigation system
Operating 155
Neutral gear position, Automatic
transmission 172, 174
Night security illumination 164
Normal occupant weight 324
O
Occupant Classification System see OCS
Occupant distribution 324
Occupant safety
OCS 74
Passenger front air bag off indicator
lamp 78
SRS 68
OCS 74
Self-test 78
Odometer, main 27
Oil
Adding 286
Consumption 283
Oil dipstick 286
Oil see Engine oil