511 Practical hints
Jump starting
Jump starting
If the battery is discharged, the engine can
be started with jumper cables and the bat-
tery of another vehicle. Observe the follow-
ing:
Jump starting should only be performed
using the jump-start contacts in the en-
gine compartment (
page 512).
Jump starting should only be performed
when the engine and catalytic
converter
1 are cold.
Do not start the engine if the battery is
frozen. Let the battery thaw out first.
Only jump start from batteries with the
same voltage rating (12 V). Jump start-
ing with a more powerful battery could
damage the vehicle’s electrical system,
which will not be covered by the
Mercedes-Benz Limited Warranty.
Only use jumper cables with sufficient
cross-section and insulated terminal
clamps.
Always make sure the jumper cables
are not on or near pulleys, fans or other
parts that move when the engine is
started or running.
Warning!G
Failure to follow these directions will cause
damage to the electronic components, and
can lead to a battery explosion and severe
injury or death.
Never lean over batteries while connecting
or jump starting, you might get injured.
Battery fluid contains sulfuric acid. Do not
allow this fluid to come in contact with eyes,
skin or clothing. In case it does, immediately
flush affected area with water, and seek
medical help if necessary.
A battery will also produce hydrogen gas,
which is flammable and very explosive. Keep
flames or sparks away from battery, avoid
improper connection of jumper cables,
smoking, etc.
Attempting to jump start a frozen battery
can result in it exploding, causing personal
injury.
Read all instructions before proceeding.
1Vehicles with gasoline engine only.
!Do not tow-start the vehicle.
!Avoid repeated and lengthy starting
attempts.
Do not attempt to start the engine using a
battery quick charge unit.
If the engine does not run after several unsuc-
cessful starting attempts, have it checked at the
nearest authorized Mercedes-Benz Light Truck
Center.
Excessive unburned fuel generated by repeated
failed starting attempts may damage the cata-
lytic converter
1.
Make sure the jumper cables do not have loose
or missing insulation.
Make sure the cable clamps do not touch any
other metal part while the other end is still at-
tached to a battery.
512 Practical hints
Jump starting
The jump-start contacts are located in the
engine compartment.
1Negative (-) terminal
2Positive (+) terminal
3Positive terminal cover
Make sure the two vehicles do not
touch.
Turn off all electrical consumers.
Apply the parking brake (page 65).
Set automatic transmission to
positionP (
page 192).
Open the hood (page 356).
Remove cover from negative
terminal1.
Flip up cover 3 of positive terminal 2
in direction of arrow.
1Negative terminal of discharged
battery
2Positive terminal of discharged battery
4Positive terminal of charged battery
5Negative terminal of charged battery
Connect positive terminals2 and 4
with the jumper cable. Clamp cable to
charged battery 4 first.
Start engine of the vehicle with the
charged battery and run at idle speed.
Connect negative terminals1 and 5
of the batteries with the jumper cable.
Clamp cable to charged battery 5
first.
Start the engine of the disabled vehi-
cle.
You can now turn on the electrical con-
sumers. Do not switch on the headlamps
under any circumstances.
Remove the jumper cables first from
negative terminals1 and 5 and then
from positive terminals2 and 4.
You can now switch on the headlamps.
Have the battery checked at the
nearest authorized Mercedes-Benz
Light Truck Center.
Warning!G
Keep flames or sparks away from battery.
Do not smoke.
Observe all safety instructions and precau-
tions when handling automotive batteries.
!Never invert the terminal connections!
519 Practical hints
Fuses
Fuse box in engine compartment
The main fuse box is located on the pas-
senger side of the engine compartment.
Open the hood (page 356).
1Clamp
2Main fuse box cover
Release clamp1.
Lift fuse box cover2 up.
Install fuse box cover in reverse order.
Close the hood after checking or re-
placing fuses (
page 358).
Fuse box in cargo compartment
The fuse box is located under the cargo
compartment cover on the right-hand side
of the spare wheel well.
Open the tailgate (page 119).
Lift the cargo compartment cover
(
page 467).
Secure cargo compartment cover with
securing hook (
page 468).
1Cover
Fold cover1 to the left as indicated by
the arrow.
!The fuse box cover must be installed
properly to prevent moisture and/or dirt from
entering the fuse box and possibly impairing fuse
operation.
540 Technical data
Fuels, coolants, lubricants, etc.
Fuel requirements
Gasoline engine
Only use premium unleaded fuel.
The octane number (posted at the
pump) must be 91 min. It is an
average of both the Research Octane
Number (RON) and the Motor Octane
Number (MON): (RON+MON) /2.
This is also known as the ANTI-KNOCK
INDEX.
Unleaded gasoline containing oxygenates
such as ethanol, IPA, IBA and TBA can be
used provided the ratio of any one of these
oxygenates to gasoline does not
exceed 10%; MTBE must not exceed 15%.
The ratio of methanol to gasoline must not
exceed 3% plus additional cosolvents.
Using mixtures of ethanol and methanol is
not allowed. Gasohol, which contains
10% ethanol and 90% unleaded gasoline,
can be used.These blends must also meet all other fuel
requirements, such as resistance to spark
knock, boiling range, vapor pressure, etc.
Diesel engine
Only use commercially available vehicular
ULTRA-LOW SULFUR HIGHWAY DIESEL
FUEL (15 ppm SULFUR MAXIMUM).
To prevent malfunctions, diesel fuel with
improved cold flow characteristics is
offered in the winter months. Check with
your fuel retailer.
Gasoline additives (gasoline engine)
A major concern among engine
manufacturers is carbon build-up caused
by gasoline. Mercedes-Benz recommends
only the use of quality gasoline containing
additives that prevent the build-up of
carbon deposits.
After an extended period of using fuels
without such additives carbon deposits
can build up, especially on the intake
valves and in the combustion area, leading
to engine performance problems such as:
Warm-up hesitation
Unstable idle
Knocking/pinging
Misfire
Power loss
!Do not fill the tank with gasoline. Do not
blend diesel fuel with gasoline or kerosine.
The fuel system and engine will otherwise be
damaged, which is not covered by the
Mercedes-Benz Limited Warranty.
542 Technical data
Fuels, coolants, lubricants, etc.
Coolant system design and coolant used
determine the replacement interval. The
replacement interval published in the
Maintenance Booklet is only applicable if
MB 325.0 Anticorrosion/Antifreeze solu-
tion or other Mercedes-Benz approved
products of equal specification are used to
renew the coolant concentration or bring it
back up to the proper level.
For information on other Mercedes-Benz
approved products of equal specification,
refer to the Factory Approved Service
Products pamphlet (USA only) or contact
an authorized Mercedes-Benz Light Truck
Center.To provide important corrosion protection,
the solution must be at least
50% anticorrosion/antifreeze (equivalent
to freeze protection to approximately
-35°F [-37°C]). If you use a solution that is
more than 55% anticorrosion/antifreeze
(freeze protection to approximately
-49°F [-45°C]), the engine temperature
will increase due to the lower heat transfer
capability of the solution.
Therefore, do not use more than this
amount of anticorrosion/antifreeze.
If the coolant level is low, water and
MB 325.0 Anticorrosion/Antifreeze
should be used to bring it up to the proper
level (have cooling system checked for
signs of leakage). Please make sure the
mixture is in accordance with label
instructions.The water in the cooling system must meet
minimum requirements, which are usually
satisfied by normal drinking water. If you
are not sure about the water quality,
consult an authorized Mercedes-Benz
Light Truck Center.
543 Technical data
Fuels, coolants, lubricants, etc.
Anticorrosion/antifreeze
Your vehicle contains a number of
aluminum parts. The use of aluminum
components in motor vehicle engines
necessitates that anticorrosion/antifreeze
coolant used in such engines be
specifically formulated to protect the aluminum parts. Failure to use such anti-
corrosion/antifreeze coolant will result in
a significantly shortened service life.
Therefore, the following product is strongly
recommended for use in your vehicle:
MB 325.0 Anticorrosion/Antifreeze agent.Before the start of the winter season (or
once a year in hot southern regions), you
should have the anticorrosion/antifreeze
concentration checked. The coolant is also
regularly checked each time you bring your
vehicle to an authorized Mercedes-Benz
Light Truck Center for service.
Anticorrosion/antifreeze quantity
Approximate freeze protection
Model-35°F (-37°C)-49°F (-45°C)
R 320 CDI 4MATIC5.0 US qt (4.75 l)5.5 US qt (5.2 l)
R 3501
1USA only.
5.0 US qt (4.75 l)5.5 US qt (5.2 l)
R 350 4MATIC5.0 US qt (4.75 l)5.5 US qt (5.2 l)
R 550 4MATIC2
2Canada only.
5.6 US qt (5.25 l)6.1 US qt (5.8 l)
546 Index
Automatic climate control (3-zone)* 222
Air conditioning, Cooling 233
Air conditioning refrigerant 538
Air distribution 228
Air recirculation mode 231
Air vents, Front 222, 228
Air vents, Rear 236, 239, 240
Air volume 229
Control panel, Front 224
Control panel, Rear 236
Deactivating system 226
Defogging 230
Defrosting 229
Maximum cooling, MAXCOOL 231
Rear passenger compartment 236
Residual heat utilization (REST) 235
Automatic headlamp mode 144
Automatic lighting control, Interior
lighting 151
Automatic locking when driving 126
Automatic shift program 200Automatic transmission 190
Accelerator position 197
Automatic shift program 200
Emergency operation (limp-home
mode) 202
Gear ranges 199
Gear selector lever 53, 190
Gear shifting malfunctions 202
Hill start assist system 198
Kickdown 197
Program mode selector switch 200
Shifting procedure 193
Starting the engine 53
Steering wheel gearshift control 201
Transmission fluid level 360
Transmission positions 194
Automatic transmission fluid see ATF
AUX-socket 304B
Backrest
Seat 44
Seat, Lumbar support 132
Seat, Multicontour* 132
Backup lamps
Messages in the multifunction
display 455–460
Replacing bulbs 480
Bar 394
BAS 101
Lamps in instrument cluster 414
Messages in the multifunction
display 429
Batteries, SmartKey
Check lamp 110, 113
Checking battery condition 118
Batteries, SmartKey with KEYLESS-GO*
Checking battery condition 118
Battery, Vehicle 503
Charging 510
Disconnecting and connecting 505
Jump starting 511
Removing and installing 505
Bead 394
Beverage holder see Cup holder
547 Index
Bleeding the fuel system (diesel
engine) 502
Bolts, Spare wheel 498
Bottle opener 309
Brake Assist System see BAS
Brake fluid 539
Checking 355
Messages in the multifunction
display 447
Brake lamp
Cleaning lenses 407
Messages in the multifunction
display 455–460
Replacing bulbs 480
Brake pads 340
Messages in the multifunction
display 445
Brakes 340
Warning lamp 415
Break-in the vehicle 338
Bulbs, replacing see Replacing bulbsC
CAC (Customer Assistance Center) 17
California retail buyers and lessees,
Important notice for 11
Call priority, Tele Aid* 328
Can holder see Cup holder
Capacities and recommended
fuel/lubricants 536
Card holder 32, 309
Cargo compartment
Tie-down rings 290
Cargo compartment cover blind 299
Cargo net* 301
Cargo tie-down rings 290
Carpets, Cleaning 411
Catalytic converter (gasoline
engine) 349
CD changer* 167, 304
CD player 167
Center console 31
Central locking 183
Automatic 126
Locking/unlocking from the
inside 126Central locking switch 126
Certification label 524, 525
CHECK ENGINE malfunction indicator
lamp 417, 418
Checking tire pressure electronically
Advanced Tire Pressure Monitoring
System (Advanced TPMS)*, (Canada
only) 379
Tire Pressure Monitoring System
(TPMS), (USA only) 376
Child safety
Infant and child restraint systems 88
Children in the vehicle 87
Air bags 73, 89
Blocking rear door window
operation 97
Indicator lamp, Front passenger front
air bag 81
Infant and child restraint
systems 91, 92
LATCH-type child seat anchors 91
Occupant Classification System
(OCS) 77
Cigarette lighter 313