2008 MERCEDES-BENZ ML350 tow

497 Practical hints
Jump starting
Jump starting
If the battery is discharged, the engine can
be started with jumper cables and the bat-
tery of another vehicle. Observe the follow-
ing:

Jump starting should only be performed
using the jump-start contacts located
in the engine compartment
(
page 498).

Jump starting should only be performed
when the engine and catalytic
converter
1 are cold.

Do not start the engine if the battery is
frozen. Let the battery thaw out first.

Only jump start from batteries with the
same voltage rating (12 V). Jump start-
ing with a higher voltage battery could
damage the vehicle’s electrical system,
which will not be covered by the
Mercedes-Benz Limited Warranty.

Only use jumper cables with sufficient
cross-section and insulated terminal
clamps.

Always make sure the jumper cables
are not on or near pulleys, fans or other
parts that move when the engine is
started or running.
Warning!G
Failure to follow these directions will cause
damage to the electronic components, and
can lead to a battery explosion and severe
injury or death.
Never lean over batteries while connecting
or jump starting, you might get injured.
Battery fluid contains sulfuric acid. Do not
allow this fluid to come in contact with eyes,
skin or clothing. In case it does, immediately
flush affected area with water, and seek
medical help if necessary.
A battery will also produce hydrogen gas,
which is flammable and very explosive. Keep
flames or sparks away from battery, avoid
improper connection of jumper cables,
smoking, etc.
Attempting to jump start a frozen battery
can result in it exploding, causing personal
injury.
Read all instructions before proceeding.
1Vehicles with gasoline engine only.
!Do not tow-start the vehicle.
!Avoid repeated and lengthy starting
attempts.
Do not attempt to start the engine using a
battery quick charge unit.
If the engine does not run after several unsuc-
cessful starting attempts, have it checked at the
nearest authorized Mercedes-Benz Light Truck
Center.
Excessive unburned fuel generated by repeated
failed starting attempts may damage the catalyt-
ic converter
1.
Make sure the jumper cables do not have loose
or missing insulation.
Make sure the cable clamps do not touch any
other metal part while the other end is still at-
tached to a battery.

499 Practical hints
Towing the vehicle
Towing the vehicle
Mercedes-Benz recommends that the
vehicle be transported with all wheels off
the ground using flatbed or appropriate
wheel lift/dolly equipment. This method is
preferable to other types of towing.If circumstances do not permit the recom-
mended towing methods, the vehicle may
be towed with all wheels on the ground
only so far as necessary to have the vehicle
moved to a safe location where the recom-
mended towing methods can be employed.
When towing the vehicle with all wheels on
the ground, the vehicle may be towed only
for distances up to 30 miles (50 km) and at
a speed not to exceed 30 mph (50 km/h).
!Do not tow-start the vehicle.
!Use flatbed or wheel lift/dolly equipment,
with the SmartKey in starter switch turned to
position0.
Do not tow with sling-type equipment. Towing
with sling-type equipment over bumpy roads will
damage radiator and supports.
To prevent damage during transport, do not tie
down vehicle by its chassis or suspension parts.
Use the towing eyes.
Switch off the ESP
® (page 102) and the
automatic central locking (
page 125).
!Do not tow with one axle raised. Doing so
could damage the transfer case, which is not
covered by the Mercedes-Benz Limited
Warranty.
All wheels must be on or off the ground. Observe
instructions for towing the vehicle with all
wheels on the ground.
Warning!G
If circumstances require towing the vehicle
with all wheels on the ground, always tow
with a tow bar if

the engine will not run

there is a malfunction in the brake
system

there is a malfunction in the power
supply or in the vehicle’s electrical
system
This is necessary to adequately control the
towed vehicle.
Prior to towing the vehicle with all wheels on
the ground, make sure the automatic trans-
mission is in neutral positionN.

500 Practical hints
Towing the vehicle
If you want the gear position to remain in
neutral positionN, observe the following
instructions.Vehicles with SmartKey:
With the vehicle at a standstill and the
ignition switched on shift the automatic
transmission to neutral positionN.
If engaged, release the parking brake
(
page 57).
Switch off the ignition and leave the
SmartKey in the starter switch.
Vehicles with KEYLESS-GO*:
With the vehicle at a standstill, depress
the brake pedal and keep it pressed.
With the ignition switched on shift the
automatic transmission to park
positionP.
Release the brake pedal.
Warning!G
With the engine not running, there is no
power assistance for the brake and steering
systems. In this case, it is important to keep
in mind that a considerably higher degree of
effort is necessary to brake and steer the
vehicle. Adapt your driving accordingly.
!When towing the vehicle with all wheels on
the ground, the automatic transmission must be
in neutral positionN.
If you turn off the engine

using the SmartKey and

remove the SmartKey from the starter
switch
or

open a front door

or when using the KEYLESS-GO* start/stop
button and open a front door
the automatic transmission will shift to park
positionP automatically.
Warning!G
When leaving the SmartKey or SmartKey
with KEYLESS-GO* in the starter switch, do
not leave children unattended in the vehicle.
It is possible for children to switch on the
ignition which could result in unsupervised
use of vehicle equipment.
A child’s unsupervised access to a vehicle
could result in an accident and/or serious
personal injury.

501 Practical hints
Towing the vehicle
Remove the KEYLESS-GO* start/stop
button from the starter switch
(
page 41).
Insert the SmartKey with
KEYLESS-GO* into the starter switch.
Switch on the ignition.
Depress the brake pedal.
Shift the automatic transmission to
neutral positionN.
Release the brake pedal.
If engaged, release the parking brake
(
page 57).
Switch off the ignition and leave the
SmartKey with KEYLESS-GO* in the
starter switch.
Installing towing eye bolt
Depending on whether you are towing a
vehicle or you are being towed, the towing
eye bolt can be screwed into threaded
holes which are located behind covers on
the right-hand side of each bumper.
1Cover!Towing of the vehicle should only be done
using the properly installed towing eye bolt.
Never attach a tow cable, tow rope or tow rod to
the vehicle chassis, frame or suspension parts.
iTo signal turns while being towed with
hazard warning flasher in use, set the starter
switch to position2 and activate combination
switch for left or right turn signal in usual manner
– only the selected turn signal will operate.
Upon canceling the turn signal, the hazard warn-
ing flasher will operate again.

502 Practical hints
Towing the vehicle
1Cover
Vehicles with Sport Package*
1Cover
Example illustration front bumper
2Towing eye boltRemoving cover
Press mark on cover1 as indicated by
the arrow.
Vehicles with Sport Package*:
Pry cover1 with a screwdriver or
similar tool at point indicated by the
arrow.
Lift off cover1 to reveal the threaded
hole for towing eye bolt.
Installing towing eye bolt
Take the towing eye bolt and wheel
wrench from the vehicle tool kit
(
page 448).
Screw towing eye bolt2 in clockwise
to its stop and tighten with wheel
wrench.
Warning!G
In order to avoid possible serious burns or
injury, use extreme caution when removing
the rear cover, because the rear exhaust
pipe is extremely hot.
iThe cover1 is secured to the bumper by a
plastic cord.

503 Practical hints
Towing the vehicle
Removing towing eye bolt
Loosen towing eye bolt2 counter-
clockwise with wheel wrench.
Unscrew towing eye bolt2.
Store the towing eye bolt and wheel
wrench back into the vehicle tool kit
(
page 448).
Installing cover
Engage cover1 at top and press at
bottom.
Stranded vehicle
Freeing a stranded vehicle, on which the
wheels are dug into sand or mud, should
be done with the greatest of care, especial-
ly if the vehicle is heavily loaded.
Avoid pulling the vehicle abruptly or diago-
nally, since it could result in damage to the
chassis alignment.
Never try to free a vehicle that is still cou-
pled to a trailer.
If possible, a vehicle equipped with trailer
hitch receiver should be pulled backward
in its own previously made tracks.

532 Index
Automatic climate control (3-zone)* 218
Air conditioning, Cooling 229
Air distribution, Front 224
Air distribution, Rear 233
Air recirculation mode 227
Air vents, Front 224
Air volume 225
Control panel, Front 220
Control panel, Rear 231
Deactivating system 222
Defogging 225
Defrosting 225
Maximum cooling, MAXCOOL 226
Rear passenger compartment 231
Rear window defroster 203
Residual engine heat (REST) 230
Using driver-side settings for
all temperature zones 229
Automatic headlamp mode 136
Automatic lighting control, Interior
lighting 142
Automatic locking when driving 125
Automatic shift program
(ML 63 AMG only) 195Automatic transmission 54
Accelerator position 190
Automatic shift program
(ML 63 AMG only) 195
Emergency operation
(Limp-Home Mode) 197
Gear ranges 192
Gear selector lever 54, 183
Gear shifting malfunctions 197
Hill start assist system 191
Kickdown 190
Kickdown, manual shift program
(ML 63 AMG only) 196
Manual shift progam
(ML 63 AMG only) 195
Program mode selector switch
(ML 63 AMG only) 194
Shift program (ML 63 AMG only) 194
Shifting procedure 186
Starting the engine 54
Steering wheel gearshift control 193
Towing a trailer 191
Transmission fluid level 345
Transmission positions 187
Automatic Transmission Fluid see ATFB
Backrest
Seat 44
Seat, Lumbar support 129
Seat, Multicontour* 129
Backup lamps
Messages in the multifunction
display 438
Replacing bulbs 471
Bar 380
BAS 100
Lamps in instrument cluster 400
Messages in the multifunction
display 415
Basic carrier bars* 266
Batteries, SmartKey
Check lamp 110, 113
Messages in the multifunction
display 427
Replacing 461
Battery, Vehicle 489
Charging 496
Disconnecting and connecting 491
Jump starting 497
Removing and installing 491

536 Index
Driving 51, 311
Abroad 334
Hydroplaning 316
In winter 318, 384
Instructions 51, 311
Problems 63
Safety systems 98
Systems 244
Through standing water 319
Through water 324
Driving off 58
Driving safety systems
4-ETS 104
ABS 98
BAS 100
EBP 104
ESP
®100
Driving systems 244
Adaptive Damping System
(ADS)* 255
Air suspension program* 254
Cruise control 244
Downhill Speed Regulation
(DSR) 249
Off-road driving program 253
Parktronic system* 259Rear view camera* 264
Vehicle level control* 255
Driving tips 190
Accelerator position 190
Kickdown 190
E
Easy-entry/exit feature
Activating (driver’s seat)* 176
Easy-entry/exit feature* 46
EBP 104
Indicator and warning lamps 402,
429
Electrical connections
Trailer 329
Electrical fuses see Fuses
Electrical system, Technical data 519
Electronic Brake Proportioning see EBP
Electronic Stability Program see ESP
®
Electronic Traction System see 4-ETS
Emergency calls
Tele Aid 296
Emergency operation
Fuel filler flap 457
Locking/unlocking the vehicle 455,
456Emergency operation
(Limp-Home Mode) 197
Emergency operations
Remote door unlock, Tele Aid 301
Unlocking/opening the tailgate 456
Emergency Tensioning Device see ETD
Emergency, In case of
Battery, Jump starting 497
Engine shut-down 506
First aid kit 448
Flat tire 478
Fuses 504
Hazard warning flasher 141
Instrument cluster, Indicator
lamps 400, 401, 402, 403, 404,
405, 406, 407, 408, 410
Roadside Assistance 12, 298
Towing the vehicle 499
Emission control 335
Information label 511
System warranties 10