196 Controls in detail
Power tilt/sliding sunroof
Switch on the ignition (page 39).Opening and closing the tilt/sliding
sunroof
To open, close, raise, or lower the
tilt/sliding sunroof, move the sunroof
switch to the resistance point in the
required direction of arrows
1 to 4
(
page 195).
Release the sunroof switch when the
tilt/sliding sunroof has reached the
desired position.
Fully opening the tilt/sliding sunroof
(Express-open)
Move the sunroof switch past the
resistance point in direction of
arrow 4 (
page 195) and release.
The tilt/sliding sunroof opens
completely. Stopping the tilt/slid
ing sunroof during
Express-operation
Move the sunroof switch in any
direction.
The movement of the tilt/sliding
sunroof stops.
!Please keep in mind that weather conditions
can sometime change rapidly. Make sure to
close the tilt/sliding sunroof when leaving the
vehicle. If water enters the vehicle interior,
vehicle electronics could be damaged which is
not covered by the Mercedes-Benz Limited
Warranty.
iWhen the tilt/sliding sunroof is open,
resonance noises may result in addition to the
usual wind noises. They are caused by minimal
pressure changes in the passenger compart-
ment. To reduce or eliminate these noises,
change the position of the tilt/sliding sunroof or
open a side window slightly.
iYou can also open or close the tilt/sliding
sunroof using the SmartKey, see “Summer open-
ing feature” (
page 193) and see “Convenience
closing feature” (
page 194).
Warning!G
The opening procedure of the tilt/sliding
sunroof can be immediately halted by
releasing the switch or , if the switch was
moved past the resistance point and
released, by moving the switch in any
direction.
The closing procedure of the tilt/sliding sun-
roof can be immediately halted by releasing
the switch.
The closing procedure of the tilt/sliding sun-
roof can be immediately reversed by moving
the switch in direction 1 or4.
W463.boo Seite 196 Montag, 19 . November 2007 8:41 08
215
Controls in detail
Useful features
Useful features
Storage compartments
Glove box
1 Glove box lid release
2 Glove box lid Opening the glove box
Pull glove box lid release
1 in
direction of arrow.
Glove box lid 2 opens downward.
Closing the glove box
Push glove box lid 2 up to close.
Warning!G
To help avoid personal injury during a colli-
sion or sudden maneuver, exercise care
when storing objects in the vehicle. Put
luggage or cargo in the cargo compartment
if possible. Do not pile luggage or cargo
higher than the seat backrests.
Always use partition net* when transporting
cargo. Partition net* cannot secure hard or
heavy objects.
Parcel nets cannot secure hard or heavy
objects.
Keep compartment lids closed. This will help
to prevent stored objects from being thrown
about and injuring vehicle occupants during
braking
vehicle maneuvers
an accident
Warning!G
Do not load items on the roof. It may cause
instability during some maneuvers which
could result in an accident.
iThe glove box is illuminated with SmartKey
in starter switch position 1 or2 when opening
the lid.
W463.boo Seite 215 Montag, 19 . November 2007 8:41 08
216 Controls in detail
Useful features
Locking and unlocking the glove box
separately
You can lock the glove box separately, e.g.
when the vehicle is in the shop for service.
Take the mechanical key out of the
SmartKey (
page 368).
Insert the mechanical key into the
glove box lock.
Turn the mechanical key to position2
to lock the glove box.
Turn the mechanical key to position 1
to unlock the glove box.
Storage compartments/telephone*
tray below armrest
A flat storage/telephone* tray with a
deeper storage compartment underneath
is located below the armrest cover. Both
can be opened separately. 1
Button to open storage/telephone*
tray
2 Button to open storage compartment
1Unlocking the glove box
2Locking the glove box
iThe glove box can only be locked or
unlocked with the mechanical key.
iThe contact plate for various mobile phone
cradles* (
page 228), the Roadside Assistance
button • (
page 232) and the Information
button ¡ (
page 233) are located in the
storage/telephone* tray.
W463.boo Seite 216 Montag, 19 . November 2007 8:41 08
222 Controls in detail
Useful features
Opening the ashtray
Pull at top of cover1.
Removing the ashtray insert
Push down on catch 2.
Pull out ashtray insert 3.
Reinstalling the ashtray insert
Position ashtray insert 3.
Push at top of cover 1 to close the
ashtray.
Cigarette lighter
Switch on the ignition (page 39). 1
Cigarette lighter
Briefly touch at top of the cover plate.
The ashtray opens automatically.
Push in cigarette lighter 1.
The cigarette lighter will pop out
automatically when hot.
Warning!G
Never touch the heating element or sides of
the cigarette lighter; they are extremely hot.
Hold the knob only.
Make sure that any children traveling with
you do not injure themselves or start a fire
with the hot cigarette lighter.
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. Unsuper-
vised use of vehicle equipment may cause
an accident and/or se rious personal injury.
W463.boo Seite 222 Montag, 19 . November 2007 8:41 08
225
Controls in detail
Useful features
Heated steering wheel
The steering wheel heating warms up the
leather area of the steering wheel.
The stalk is located on the lower left-hand
side of the steering wheel.
1 Switching on
2 Switching off
3 Indicator lamp Switching on
Switch on the ignition (page 39).
Turn switch at the tip of stalk in
direction of arrow
1.
The steering wheel is heated.
Indicator lamp 3 comes on. Switching off
Turn switch at the tip of stalk in
direction of arrow
2.
The heated steering wheel is switched
off.
Indicator lamp 3 goes out.
For information on adjusting the steering
wheel, see “Steering wheel” (
page 44).
iThe steering wheel heating is temporarily
suspended while the indicator lamp 3 remains
on when
the temperature of the vehicle interior is
above 86°F (30°C)
the temperature of the steering wheel is
above 95°F (35°C)
When these conditions do not apply anymore,
steering wheel heating continues.
iIndicator lamp 3 flashes or goes out
in case of power surge or undervoltage
in case of a steering wheel heating
malfunction
iThe steering wheel heating switches off
automatically when you remove the SmartKey
from the starter switch.
W463.boo Seite 225 Montag, 19 . November 2007 8:41 08
226 Controls in detail
Useful features
Telephone*
Radio transmitters, such as a portable tele-
phone or a citizens band unit, should only
be used inside the vehicle if they are con-
nected to an antenna that is installed on
the outside of the vehicle.
The external antenna must be approved by
Mercedes-Benz. Please contact an autho-
rized Mercedes-Benz Light Truck Center
for information on the installation of an
approved external antenna. Refer to the
radio transmitter operation instructions
regarding use of an external antenna.When the mobile phone is inserted in the
cradle, you can operate the telephone
using the following devices:
mobile phone keypad
COMAND system (see separate
operating instructions)
buttons
s andt on the multi-
function steering wheel (
page 134)
Voice Control System* (see separate
operating instructions)
Warning!G
Never operate radio transmitters equipped
with a built-in or attached antenna (i.e. with-
out being connected to an external antenna)
from inside the vehicle while the engine is
running. Doing so coul d lead to a malfunc-
tion of the vehicle’s electronic system,
possibly resulting in an accident and/or
serious personal injury.
Warning!G
Please do not forget that your primary
responsibility is to drive the vehicle.
A driver’s attention to the road must always
be his/her primary focus when driving. For
your safety and the safety of others, we
recommend that you pull over to a safe
location and stop before placing or taking a
telephone call.
If you choose to use the telephone
1 while
driving, please use the hands-free device
and only use the telephone when road,
weather and traffic cond itions permit. Some
jurisdictions prohibit the driver from using a
mobile telephone while driving a vehicle.
Only operate the COMAND system
1 if road,
weather and traffic conditions permit.
Bear in mind that at a speed of just
30 mph (approximately 50 km/h), your
vehicle is covering a distance of 44 feet
(approximately 14 m) every second.
1Observe all legal requirements.
iVarious mobile phone cradles can be
installed in the front center armrest, see
separate installation instructions for the mobile
phone cradle. These mobile phone cradles can
be obtained from an authorized Mercedes-Benz
Light Truck Center.
The functions and services available to you while
using the mobile phone depend on your service
provider and the type of mobile phone you are
using. See also separate operating manual for
instructions on how to use the mobile phone.
W463.boo Seite 226 Montag, 19 . November 2007 8:41 08
227
Controls in detail
Useful features
Please note that these functions are only
available with Mercedes-Benz approved
mobile phones. Please contact an
authorized Mercedes-Benz Light Truck
Center for information on features avail-
able for your mobile phone of choice.
The cradle is located in the armrest.
Open the telephone tray (page 216).
Inserting mobile phone in mobile phone
cradle
Once the mobile phone has been inserted
in the mobile phone cradle, you have to
use the hands-free device to respond
during phone calls.
If applicable, remove the cover for the
external antenna connection from the
back of the mobile phone and store it in
a s a f e p l a c e . B e s u r e t o c o m p l y w i t h t h e
mobile phone’s operating instructions
as well.
Example illustration
1 Inserting the mobile phone
2 Connector contact
3 Mobile phone cradle
Slide the lower end of the mobile phone
into connector contact 2 on
cradle 3.
Push the top of the mobile phone in
direction of arrow 1, until the lug on
the mobile phone release button
engages.
The mobile phone is connected to the
network via the external antenna.
The mobile phone is linked to the
hands-free device and the multi-
function steering wheel.
The battery is charged depending on its
charge status and the position of the
SmartKey in the starter switch. The
charge procedure will be indicated in
the mobile phone’s display.
You can place or receive phone calls. You
can control other functions of the mobile
phone via the control system
(
page 159), the Voice Control System*
(see separate operating instructions), or
the COMAND system (see separate oper-
ating instructions).
!Do not try to remove the mobile phone along
with the cradle. You could otherwise damage the
mobile phone cradle.
W463.boo Seite 227 Montag, 19 . November 2007 8:41 08
228 Controls in detail
Useful features
Removing mobile phone from mobile
phone cradle
Example illustration
1Release catch for mobile phone
2 Mobile phone cradle
Press release catch in direction of
arrow 1 and take mobile phone out of
mobile phone cradle 2.
Changing mobile phone cradle
If you require a different cradle for your
mobile phone, remove the present cradle
before installing a new one.
Removing an existing mobile phone
cradle
Example illustration
1 To release the mobile phone cradle
2 To remove the mobile phone cradle
3 Mobile phone cradle
Press release button in direction of
arrow 1 and take mobile phone
cradle 3 out in direction of arrow 2.
Installing a different mobile phone
cradle
Example illustration
1 Contact plate
2 Recesses
3 Mobile phone cradle
Insert mobile phone cradle 3 into
recesses 2 of contact plate 1.
Push mobile phone cradle 3 forward
until it engages.
iWhen you take the SmartKey out of the
starter switch, the mobile phone remains
switched on for approximately 10 minutes. If you
place or receive a call during this time, the
mobile phone switches off 10 minutes after the
call has been completed.
iWhen using a flip-style mobile phone, open
flip top before removing from the cradle while
a call is connected. Otherwise, the call will be
disconnected.
W463.boo Seite 228 Montag, 19 . November 2007 8:41 08