2008 MERCEDES-BENZ G55AMG center console

80 Safety and Security
Occupant safety
BabySmartTM air bag deactivation
system
The 56 indicator lamp is located on
the upper part of the center console.
1 Front passenger front air bag off
indicator lampInfants and small children should never
share a seat belt with another occupant.
During an accident, th ey could be crushed
between the occupant and seat belt.
A child’s risk of serious or fatal injuries is
significantly increased if the child restraints
are not properly secured in the vehicle and
the child is not properly secured in the child
restraint.
Children too big for ch ild restraint systems
must ride in back seats using regular seat
belts. Position shoulder belt across chest
and shoulder, not face or neck.
A booster seat may be necessary to achieve
proper seat belt positioning for children
from 41 lbs until they reach a height where
a lap/shoulder belt fits properly without a
booster.When the child restraint is not in use,
remove it from the vehicle or secure it with
the seat belt to prevent the child restraint
from becoming a projectile in the event of
an accident.
Do not leave children unattended in the
vehicle; even if the ch ildren are secured in a
child restraint system. Unsupervised
children in a child rest raint system may use
vehicle equipment and may cause an
accident and/or serious personal injury.
W463.boo Seite 80 Montag, 19. November 2007 8:41 08

93
Safety and Security
Driving safety systems
Switching off the ESP®
To improve the vehicle’s traction, switch
off the ESP® in driving situations where it
would be advantageous to have the drive
wheels spin and thus cut into surfaces for
better grip such as:

when driving with snow chains

in deep snow

sand or gravel

when driving off-road When you switch off the ESP
®

the ESP® does not stabilize the vehicle

the engine output is not limited, which
allows the drive wheels to spin and
thus cut into surfaces for better grip

the 4-ETS will still apply the brake to a
spinning wheel

the ESP® continues to operate when
you are braking

you cannot activate the cruise control
system

the cruise control system switches off
if currently activated The ESP
® switch is located on the upper
part of the center console.
1 ESP
® switch
With the engine running, press
switch 1.
The ESP
® warning lamp v in the
instrument cluster comes on.
The ESP
® is deactivated.
Warning!G
The ESP® should not be switched off during
normal driving other than in the circum-
stances described below. Disabling of the
system will reduce vehicle stability in stan-
dard driving maneuvers.
Warning!G
Switch on the ESP® immediately if the afore-
mentioned circumstances do not apply any-
more. Otherwise the ESP
® will not stabilize
the vehicle when it is starting to skid or a
wheel is spinning.
iWhen the ESP® is switched off and one or
more drive wheels are spinning, the ESP® warn-
ing lamp v in the instrument cluster flashes.
However, the ESP
® will then not stabilize the
vehicle.
W463.boo Seite 93 Montag, 19. November 2007 8:41 08

96 Safety and Security
Anti-theft systems
Arming the alarm system
The alarm system is armed after you have
locked the vehicle with the SmartKey.
The alarm system indicator lamp is located
in the tow-away alarm switch on the upper
part of the center console.
1 Alarm system indicator lampMake sure all doors and the tailgate are
closed.
Lock the vehicle with the SmartKey
(
page 65).
The turn signal lamps flash three times
to indicate that the vehicle is locked.
The alarm system is armed within
approximately 15 seconds. Alarm
system indicator lamp 1 flashes. Disarming the alarm system
Unlock the vehicle with the SmartKey
(
page 38).
The turn signal lamps flash once to
indicate that the alarm system is
disarmed. Alarm system indicator
lamp 1 goes out.
Canceling the alarm
Insert the SmartKey in the starter
switch.
or
Press button Œ or‹ on the
SmartKey.
iIf the turn signal lamps do not blink three
times, one of the followi ng elements may not be
properly closed:

a door

the tailgate
Close the respective element and lock the
vehicle again.
iThe alarm system will rearm automatically
after approximately 40 seconds if neither a door
nor the tailgate is opened.
W463.boo Seite 96 Montag, 19. November 2007 8:41 08

97
Safety and Security
Anti-theft systems
Tow-away alarm
Once the tow-away alarm is armed, a visual
and audible alarm will be triggered when
someone attempts to raise the vehicle.
Arming tow-away alarm
Lock the vehicle with the SmartKey
(
page 65).
The tow-away alarm is automatically
armed after approximately
30 seconds. Disarming tow-away alarm
To prevent triggering the tow-away alarm
feature, switch off the tow-away alarm
before towing the vehicle, or when parking
on a surface subject to movement, such as
a ferry or auto train.
The tow-away alarm off switch is located
on the upper part of the center console.
1 Tow-away alarm off switch
2 Indicator lamp
Switch off the ignition and remove the
SmartKey from the starter switch.
Press switch 1.
Indicator lamp 2 comes on briefly.
Exit and lock the vehicle with the
SmartKey (
page 65).
Canceling the tow-away alarm
Press the Œ or‹ button on the
SmartKey.
or
Insert the SmartKey in the starter
switch.
iYou cannot disarm the tow-away alarm
when the ignition is switched on.
iWhen you unlock the vehicle, the tow-away
protection disarms automatically.
The tow-away alarm remains disarmed until you
lock your vehicle again.
W463.boo Seite 97 Montag, 19. November 2007 8:41 08

107
Controls in detail
Locking and unlocking
Locking and unlocking from the inside
You can lock or unlock the doors and the
tailgate from inside using the central lock-
ing or unlocking switch. This can be useful,
for example, if you want to lock the vehicle
before starting to drive.
The fuel filler flap cannot be locked or
unlocked with the central locking or
unlocking switch.
The switches are located on the upper part
of the center console.
1 Central unlocking switch
2 Central locking switch
Locking
Press central locking switch 2.
If all doors and the tailgate are closed,
the vehicle locks. Unlocking
Press central unlocking switch
1.
The vehicle unlocks.
Warning!G
When leaving the vehicl e, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. Unsuper-
vised use of vehicle equipment may cause
an accident and/or serious personal injury.
iYou can open a locked door from inside at
any time. Open door only when conditions are
safe to do so.
If the vehicle was previously centrally locked
with the SmartKey, it will not unlock using
central unlocking switch 1.
If the vehicle was previously locked with central
locking switch 2:

and the SmartKey is set to factory settings,
the complete vehicle is unlocked when a
front door is opened from the inside.

and the SmartKey is set to selective settings,
only the front door opened from the inside is
unlocked.
W463.boo Seite 107 Montag, 19 . November 2007 8:41 08

112 Controls in detail
Seats
Seat heating
The switches for front seat heating are
located on the upper part of the center
console.
The switches for rear seat heating (rear
outer seats) are located on the B-pillars
(
page 113).
Front seat heating
1 Seat heating switch
2 Indicator lamps The red indicator lamps in the switch come
on to show which heating level you have
selected.
Switch on the ignition (page 39).Switching on seat heating
Press switch
1 once.
Three red indicator lamps 2 in the
switch come on.
Continue pressing switch 1 until
desired seat heating level is reached.
Switching off seat heating
Press switch 1 repeatedly until all
indicator lamps 2 in the switch go
out.
Level
3Three indicator lamps on
(highest level)
The seat heating automatically
switches to level 2 after
approximately 5 minutes.
2Two indicator lamps on
The seat heating automatically
switches to level 1 after
approximately 10 minutes.
1One indicator lamp on
(lowest level)
The seat heating automatically
switches off after approximately
20 minutes.
offNo indicator lamp on
iIf one or more of indicator lamps 2 in seat
heating switch 1 are flashing, there is insuffi-
cient voltage available due to too many electrical
consumers are switched on. The seat heating
switches off automatically.
The seat heating will switch back on again
automatically as soon as sufficient voltage is
available.
W463.boo Seite 112 Montag, 19 . November 2007 8:41 08

124 Controls in detail
Lighting
Driving in reverse
Switching on corner-illuminating front
fog lamps
Place the gear selector lever in reverse
gearR (
page 162).
The front fog lamp opposite to your
steering direction comes on.
Switching off corner-illuminating front
fog lamps
Place the gear selector lever to a
position other than reverse gear R
(
page 162).
The respective corner-illuminating
front fog lamp goes out.
Hazard warning flasher
The hazard warning flasher can be
switched on at all times, even with the
SmartKey removed from the starter
switch.
The hazard warning flasher switches on
automatically when an air bag deploys.
The hazard warning flasher switch is
located on the upper part of the center
console.
1 Hazard warning flasher switch Switching on hazard warning flasher
Press hazard warning flasher
switch
1.
All turn signals are flashing.
Switching off hazard warning flasher
Press hazard warning flasher switch 1
once more.
All turn signals go out.
iWith the hazard warning flasher activated
and the combination switch set for either left or
right turn, only the respective turn signals will
operate when the ignition is switched on.
iIf the hazard warning flasher has been
activated automatically, press hazard warning
flasher switch 1 once to switch it off.
W463.boo Seite 124 Montag, 19 . November 2007 8:41 08

143
Controls in detail
Control system
Operating the CD player
Selecting CD track
Turn on the COMAND system and
select CD. Refer to separate COMAND
system operating instructions.
Press button
è orÿ repeatedly
until the settings for the CD currently
being played appear in the multifunc-
tion display. 1
Current CD (CD0 for CD in head unit,
CD1throughCD6 for CD in CD changer)
2 Current track
Press button k orj repeatedly
until the desired track is selected. Selecting MP3-CD track
Turn on the COMAND system and
select MP3. Refer to separate
COMAND system operating instruc-
tions.
Press button
è orÿ repeatedly
until the settings for the MP3-CD
currently being played appear in the
multifunction display.
iThe COMAND system and the CD changer
can play CDs as well as MP3-CDs.
iTo select a CD from the CD changer
magazine, press a number on the COMAND
system key pad located in the center console.
iA MP3-CD inserted in the CD changer is
handled by the COMAND system like an
audio CD. Information contained on a MP3-CD
will not appear in the multifunction display or in
the COMAND system display.

W463.boo Seite 143 Montag, 19 . November 2007 8:41 08