2008 MERCEDES-BENZ G-CLASS SUV remove seats

Seats
60 Seats
Points to remember
For information about folding the rear bench
seat forward, see the "Luggage compartment
enlargement" section (Y page 141).G
Risk of injury
The seats can still be adjusted when there
is no key in the ignition lock. For this rea-
son, children should never be left unsuper-
vised in the vehicle. They could become
trapped when adjusting a seat. G
Risk of accident
Only adjust the driver's seat when the vehi-
cle is stationary. You will otherwise be dis-
tracted from the road and traffic conditions
and you could lose control of the vehicle as
a result of the seat moving. This could
cause an accident. G
Risk of injury
Make sure that nobody can become trap-
ped when you adjust the seat.
Observe the notes concerning the airbag
system.
Secure children as recommended; see
"Children in the vehicle" section. !
When you move the seats, make sure that
there are no objects in the footwell or
behind the seats. Otherwise, you could
damage the seats and the objects.
! Make sure that the sun visor is folded up
before setting the backrest angle and head
restraint height. Otherwise, the head
restraint and sun visor could collide when
the head restraint is fully extended.
i If the front door is open, the seats can be
adjusted for up 30 minutes after the igni-
tion has been switched off.
i The rear-compartment head restraints
can be removed (Y page 62).
Please contact a Mercedes-Benz Service
Centre for more information. Adjusting the seat
The buttons are located on the door control
panel. 1
Head restraint height
2 Backrest angle
3 Seat fore-and-aft adjustment
4 Seat cushion angle
5 Seat height
X Turn the key to position 1or 2in the ignition
lock.
Seat fore-and-aft adjustment !
Make sure that the cup
holder* (Y page 138) on the centre con-
sole is folded down. Otherwise, you could
damage the seat or the cup holder*. Controls
* optional
463_AKB; 1; 8, en-GB
wobuchh,
Version: 2.10.6 2008-07-17T15:19:41+02:00 - Seite 60Dateiname: 6515_4091_02_buchblock.pdf; preflight

Seats
61
X
Slide the button forwards or back in the
direction of arrow 3.
Backrest angle X
Slide the button forwards or back in the
direction of arrow 2.
Seat height X
Slide the button up or down in the direction
of arrow 5.
Seat cushion angle Adjust the angle so that your thighs are gently
supported.
X
Slide the button up or down in the direction
of arrow 4.
Head restraint height G
Risk of injury
Make sure that the central area of the head
restraint supports the back of your head at
about eye level. You could seriously injure
your neck if your head is not correctly sup-
ported by the head restraint in the event of
an accident. Never travel without a cor-
rectly adjusted and engaged head restraint. X
Slide the button up or down in the direction
of arrow 1.
Head restraint angle X
Sit on the seat.
X Using both hands, reach backwards and
grasp the sides of the head restraint.
X Adjust the head restraint angle. Pull the
bottom of the head restraint forwards or
push it back. Head restraints
G
Risk of injury
Occupants should only travel sitting on
seats which have the head restraints instal-
led. This reduces the risk of injury to the
passengers in the rear in the event of an
accident. Fitting and removing the front head
restraints The buttons are located on the door control
panel.
1
Head restraint height
X Turn the key to position 1in the ignition
lock or open the door.
X Tilt the backrest back slightly, to make it
easier to remove and fit the headrests.
X To remove: slide button1upwards until
the head restraint is fully extended.
X Pull the head restraint up and remove it.
X To refit: slide button 1upwards for five
seconds. Controls
463_AKB; 1; 8, en-GB
wobuchh,
Version: 2.10.6 2008-07-17T15:19:41+02:00 - Seite 61 ZDateiname: 6515_4091_02_buchblock.pdf; preflight

Seats
62
X
Insert the head restraint so that the
notches on the bar are on the left when
viewed in the direction of travel.
X Push the head restraint down until you hear
it click into place.
Resetting the front seat head restraints
It is necessary to reset the front seat head
restraints after the voltage supply has been
interrupted, e. g. if the battery has been com-
pletely discharged or disconnected.
X Make sure that the cup holder* on the
centre console is folded down
(Y page 138).
X Move the seat as far forward as possible
and the head restraint in as far as possible.
Adjusting the head restraint height G
Risk of injury
Make sure that the central area of the head
restraint supports the back of your head at
about eye level. You could seriously injure
your neck if your head is not correctly sup-
ported by the head restraint in the event of
an accident. Never travel without a cor-
rectly adjusted and engaged head restraint. X
To raise: pull the head restraint up until the
desired height has been reached.
X To lower: push the head restraint down
until the desired height has been reached.
Adjusting the head restraint angle X
Pull the lower edge of the head restraint
forwards or push it back until it is in the
desired position.
Fitting and removing the rear-compart-
ment head restraints X
To remove: pull the head restraint up and
out.
X To refit: insert the head restraint so that
the arched side points in the direction of
travel.
X Push the head restraint down until you hear
it click into place. Multi-contour seat*
You can adjust the contour of the front seat
backrests individually to provide optimum
support for your back. 1
Thigh cushion
2 Lumbar region support
3 Upper back support
4 Backrest side cushions
X Make sure that the key is in position 1in
the ignition lock.
X Thigh cushion: use button1to adjust the
thigh cushion to the desired position.
X Lumbar region support: use button2to
adjust the lumbar region support to the
desired position. Controls
* optional
463_AKB; 1; 8, en-GB
wobuchh,
Version: 2.10.6 2008-07-17T15:19:41+02:00 - Seite 62Dateiname: 6515_4091_02_buchblock.pdf; preflight

Seat belts
74
X
To fasten the seat belt: remove belt
tongues 7from retainer 1.
X Pull the seat belt smoothly from the belt
reel.
X Engage fixed belt tongue 4in buckle 2.
X Pull removable belt tongue 7and route
the seat belt across your body.
X Engage removable belt tongue 7in
buckle 5.
X If necessary, pull upwards on the shoulder
section of the seat belt to tighten the belt
across your body.
X To release the seat belt: press release
button 6on belt buckle 5.
X Open belt buckle 2with a screwdriver
3 or similar.
X Let the seat belt roll up to the stop.
X Insert both belt tongues into retainer 1,
one on top of the other. Driver seat belt warning
The < seat belt warning lamp in the instru-
ment cluster reminds you that all occupants
should fasten their seat belts. The belt warning lamp may light up continuously
or it may flash. Additionally, there may be a
warning tone.
The < seat belt warning lamp goes out and
the warning tone ceases when the driver's
seat belt is fastened.
i Further information about the belt warning lamp (Y page 212). Belt height adjustment
You can adjust the seat belt height on the fol-
lowing seats:
R driver's seat
R front-passenger seat
R outer rear seats
Adjust the belt to a height that allows it to be
routed across the middle of your shoulder. 1
Release catch
X To raise: slide the belt sash guide upwards.
The belt sash guide engages in various posi-
tions.
X To lower: draw release button 1forwards
and hold it.
X Slide the belt sash guide downwards.
X Let go of release button 1and make sure
that the belt sash guide has engaged. Controls
463_AKB; 1; 8, en-GB
wobuchh,
Version: 2.10.6 2008-07-17T15:19:41+02:00 - Seite 74Dateiname: 6515_4091_02_buchblock.pdf; preflight

Loading and stowing
141
Short-wheelbase station wagon and cab-
riolet
There are two further lashing eyelets moun-
ted at the sides in the luggage compartment
and under the rear bench seat. Guide the load restraints in a cross pattern
over the load, as shown in the illustration. Enlarging the luggage compartment
Short-wheelbase station wagon and cabrio-
let: the rear bench seat is split 50/50.
Long-wheelbase station wagon: the rear
bench seat is split 50/50.
The left-hand and right-hand rear seats can
be folded down to increase the luggage com-
partment capacity. You can:
R fold the seat backrests forward
R fold the rear bench seat back fully. G
Risk of injury
Do not carry heavy or hard objects inside
the vehicle or in the luggage compartment
unless they are secured.
Otherwise, you and other vehicle occu-
pants could be injured by objects being
thrown around the vehicle in the event of
sharp braking, a sudden change in direction
or an accident.
When using the luggage compartment
enlargement, you should always clip in the
safety net*, if at hand. G
Risk of poisoning
Keep the boot lid/tailgate closed when the
engine is running. Otherwise, you could be poisoned by exhaust fumes entering the
vehicle.
Folding the seat backrest forwards Example; long-wheelbase station wagon
1
Seat backrest release lever
2 Rear bench seat release lever
X Remove the centre head restraint
(Y page 61).
X Pull release lever 1.
The corresponding seat backrest is
released.
X Fold the seat backrest forward, until it
engages. Controls
* optional
463_AKB; 1; 8, en-GB
wobuchh, Version: 2.10.6 2008-07-17T15:19:41+02:00 - Seite 141 ZDateiname: 6515_4091_02_buchblock.pdf; preflight

Loading and stowing
144cover
1from the left-hand and right-hand
retainers 2.
X Remove luggage compartment cover 1.Safety net*
G
Risk of injury
You must make sure that the safety net is
correctly secured at the top and bottom.
Do not use a damaged safety net.
The safety net cannot restrain heavy loads.
For this reason, you should always secure
the load.
Otherwise, objects that have not been
secured sufficiently might be thrown
around if you brake suddenly, change direc-
tion suddenly or are involved in an accident,
and could cause you an injury.
If the safety net is fitted the row of seats
behind it must not be occupied. Safety net without luggage compart-
ment enlargement X
Fold the rear bench seat forward, without
folding the seat backrest forward before-
hand (Y page 141).
i Long-wheelbase station wagon: open the
rear doors. This allows you to hook in the
safety net more easily. 1
Safety net
2 Retainer 3
Tensioning buckle
4 Tensioning strap Controls
* optional
463_AKB; 1; 8, en-GB
wobuchh,
Version: 2.10.6 2008-07-17T15:19:41+02:00 - Seite 144Dateiname: 6515_4091_02_buchblock.pdf; preflight