Flat tyre
245R
slip off the jack
R injure you or others
R be damaged
Thus, it is important to make sure that the
jack is positioned correctly in the respec-
tive jacking points. Before positioning the
jack, remove any dirt that may have collec-
ted in the jacking points. Wheel wrench
X
By using the wheel wrench, loosen the
wheel bolts on the wheel you wish to
change by about one full turn. Do not
unscrew the bolts completely. Pump lever
1
Notch
X Assemble the pump lever for the jack. It can
be found with the vehicle tool kit. 2
Pressure release screw X
Turn pressure release screw 2using
notch 1on the pump lever clockwise as
far as it will go.
Pressure release screw 2is closed.
i Never turn pressure release screw 2by
more than one to two revolutions. Other-
wise, hydraulic fluid could escape. X
Position the jack at the front and rear axle
carrier tubes The jack must always stand
vertically, even on slopes.
X Raise the vehicle by pumping (arrow) until
the tyre is three centimetres off the ground
at the most.
X Unscrew the wheel bolts. Practical advice
463_AKB; 1; 8, en-GB
wobuchh,
Version: 2.10.6
2008-07-17T15:19:41+02:00 - Seite 245 ZDateiname: 6515_4091_02_buchblock.pdf; preflight
