2008 MERCEDES-BENZ G-CLASS SUV cooling

Trailer coupling*
274 Trailer coupling*
Mounting dimensions
G
Risk of accident
Only have a trailer coupling retrofitted at a
qualified specialist workshop which has the
necessary specialist knowledge and tools
to carry out the work required. Mercedes-
Benz recommends that you use a
Mercedes-Benz Service Centre for this pur-
pose. In particular, work relevant to safety
or on safety-related systems must be car-
ried out at a qualified specialist workshop.
! If you have a trailer tow hitch retrofitted,
changes to the cooling system may be nec-
essary, depending on the vehicle type.
If you have a trailer tow hitch retrofitted,
observe the anchorage points on the chas-
sis frame. Anchorage points for the trailer coupling
1
Anchorage points
2 Overhang dimension For trailer couplings fitted at the factory, the
overhang dimension is 895 mm.Techni
cal data
* optional
463_AKB; 1; 8, en-GB
wobuchh
,V ersion: 2.10.6
2008-07-17T15:19:41+02:00 - Seite 274 Dateiname: 6515_4091_02_buchblock.pdf; preflight

Service products and capacities
280
Capacities The following values refer to an oil change including the oil filter.
Engine with oil filter G 500 G 320 CDI G 55 AMG
Replacement amount
9.0 l 8.0 l 8.5 l
Coolant
The coolant is a mixture of water and anti-
freeze/corrosion inhibitor. It performs the
following tasks:
R anti-corrosion protection
R antifreeze protection
R raising the boiling point
i When the vehicle is first delivered, it is
topped up with a coolant that will ensure
adequate antifreeze and corrosion protec-
tion.
! Only top up with coolant that has been
premixed with the desired antifreeze pro-
tection. You could otherwise damage the
engine.
There is more information about coolant
and topping it up on Mercedes-Benz Spec- ifications for Service Products Sheet
310.1.
! Always use a suitable coolant mixture,
even in countries where high temperatures
prevail.
Otherwise, the cooling system will not be
sufficiently protected from corrosion, and
the boiling point will be too low.
If antifreeze/corrosion inhibitor is present in
the correct concentration, the boiling point of
the coolant will be around 130 °C.
The antifreeze/corrosion inhibitor concentra-
tion in the cooling system should:
R be at least 50%. This will protect the cooling
system against freezing down to around
–37 °C.
R not exceed 55% concentration (antifreeze
protection down to –45 °C), otherwise heat
will not be effectively dissipated. If the vehicle has lost coolant, top it up with
equal amounts of water and antifreeze/cor-
rosion inhibitor. Mercedes-Benz recom-
mends using an antifreeze/corrosion inhibi-
tor which has been approved for Mercedes-
Benz vehicles.
! The cooling system contains a filling
which must be renewed after 15 years, or
after 250,000 km at the latest. Have the
renewal confirmed in the Service Booklet.
The warranty is only valid if you top up with
an antifreeze/corrosion inhibitor which
has been approved by Mercedes-Benz, and
observe the recommended mixing ratios. Technical data
463_AKB; 1; 8, en-GB
wobuchh,
Version: 2.10.6 2008-07-17T15:19:41+02:00 - Seite 280Dateiname: 6515_4091_02_buchblock.pdf; preflight

Service products and capacities
281
Capacities The following values indicate the total cooling system capacities.
G 500 G 320 CDI G 55 AMG
Coolant
12.1 l 11.6 l 12.7 l
Coolant: vehicles with auxiliary heat-
ing*
12.7 l 12.2 l 13.2 l
Amount of antifreeze/corrosion inhibitor required for antifreeze protection
Down to –37 °C(approx. 50%)
6.05 l 5.8 l 6.4 l
Down to –45 °C(approximately 55%)
6.65 l 6.4 l 7.0 l
Brake fluid
Over a period of time, the brake fluid absorbs
moisture from the air; this lowers its boiling
point. G
Risk of accident
If the boiling point of the brake fluid is too
low, vapour pockets may form in the brake
system when the brakes are applied hard
(e.g. when driving downhill). This would
impair braking efficiency.
Have the brake fluid renewed annually with
brake fluid that has been approved by Mercedes-Benz and have this confirmed in
the Service Booklet.
i There is usually a notice in the engine
compartment to remind you when the next
brake fluid change is due. Windscreen washer system
The washer fluid reservoir holds approxi-
mately 7.5 litres.
The headlamp cleaning system and the wind-
screen washer system are both supplied from
the washer fluid reservoir.
X At temperatures above freezing point:
top up the washer fluid reservoir with a
mixture of water and windscreen washer
concentrate (Y page 162).
X At temperatures below freezing point:
top up the washer fluid reservoir with a
mixture of water, antifreeze and wind-
screen washer concentrate (Y page 162). Technical data
* optional
463_AKB; 1; 8, en-GB
wobuchh,
Version: 2.10.6 2008-07-17T15:19:41+02:00 - Seite 281 ZDateiname: 6515_4091_02_buchblock.pdf; preflight