2008 MERCEDES-BENZ CLK63AMG fold seats

43 Getting started
Adjusting
Seat backrest tilt
Press switch forward or backward in
the direction of arrow5.
Head restraint height
Press switch up or down in the direc-
tion of arrow1.Head restraint adjusting
Manually adjust the head restraint.
Push or pull the head restraint cushion
to the desired position.
For more information, see “Seats”
(
page 120).Folding front seat backrests forward
1Release lever
Folding backrests forward
Pull release lever1 forward and fold
the backrest forward.
The head restraint will automatically
move down.
Warning!G
For your protection, drive only with properly
positioned head restraints.
Adjust the head restraint so that it is as
close to the head as possible and the center
of the head restraint supports the back of
the head at eye level. This will reduce the po-
tential for injury to the head and neck in the
event of an accident or similar situation.

44 Getting started
Adjusting
Folding backrests back
Fold and press the backrest rearward
until it engages in driving position.
The head restraint returns to its previ-
ous position.
For information on additional convenience
features permitting easy entry and exit,
see “Easy-entry/exit feature” (
page 45).
Steering wheel
iIn addition to the front seat backrests, the
front seat cushions can also be shifted forward
to permit easy access to the rear whenever the
seat is located in the rear half of its adjustment
range. Pivot backrest forward by pulling the re-
lease lever until the seat moves in a combined
forward and upward movement.
!When moving the seat, make sure there are
no items in the footwell or behind the seats. Oth-
erwise you could damage the seats.
Warning!G
The seat belts provide protection only with
the backrest locked in place. Therefore, the
backrest must be locked in place with the
vehicle in motion. Do not drive the vehicle
when the backrest is not locked in place.
When leaving the vehicle, always remove the
SmartKey or SmartKey with KEYLESS-GO*
from the starter switch, take it with you, and
lock the vehicle.
The power seats can also be operated with
the driver’s or passenger door open. Do not
leave children unattended in the vehicle or
with access to an unlocked vehicle. Unsu-
pervised use of vehicle equipment may
cause an accident and/or serious personal
injury.
Never place hands under seat or near any
moving parts during a seat adjustment
procedure.
Warning!G
Do not adjust the steering wheel while driv-
ing. Adjusting the steering wheel while driv-
ing could cause the driver to lose control of
the vehicle.
When leaving the vehicle, always remove the
SmartKey or SmartKey with KEYLESS-GO*
from the starter switch, take it with you, and
lock the vehicle.
Even with the SmartKey or SmartKey with
KEYLESS-GO* removed from the starter
switch, or the SmartKey with KEYLESS-GO*
removed from the vehicle, the steering
wheel adjustment feature can be operated
when the driver’s door is open. Therefore,
do not leave children unattended in the ve-
hicle, or with access to an unlocked vehicle.
Unsupervised use of vehicle equipment may
cause an accident and/or serious personal
injury.

86 Safety and Security
Occupant safety
Installation of infant and child restraint
systems
The CLK coupe is equipped with tether
anchorages for a top tether strap at each
of the rear seating positions.1Anchorage ring
2HookOpen the trunk and release the rear
seat backrest (
page 281).
Fold rear seat backrest slightly for-
ward.
Guide top tether strap between head
restraint and top of seat back.
Head restraint must be installed and
positioned such that the top tether
strap can pass freely between the head
restraint and the top of seat back.
Make sure the tether strap is not
twisted.1Anchorage ring
2Hook
Fold up anchorage ring1.
Securely fasten hook2, which is part
of the tether strap, to anchorage
ring1.
S w i n g r e a r s e a t b a c k r e s t t o t h e r e a r u n -
til it engages.
Check the rear seat backrest to be
locked in its upright position
(
page 282).
When the child restraint is not in use,
remove it from the vehicle or secure it with
the seat belt to prevent the child restraint
from becoming a projectile in the event of
an accident.
Do not leave children unattended in the
vehicle, even if the children are secured in a
child restraint system. Unsupervised
children in a child restraint system may use
vehicle equipment and may cause an
accident and/or serious personal injury.
iYour CLK cabriolet does not have and is not
required to have anchorage rings for a child
seat’s top tether strap in the rear seating posi-
tions. Child seats can be used with the seat belt,
or lower anchor system and seat belt, fully in ac-
cordance with the child seat manufacturer’s in-
structions.
iFor safety, make sure the hook2 has at-
tached to the anchorage ring1 beyond the
safety catch, as illustrated.


120 Controls in detail
Seats
For information on seat adjustment, see
“Adjusting” (
page 41).
Front seat active head restraints
You cannot remove the active head re-
straints on the driver’s and front passen-
ger’s seat.
For removal of the active head restraints
we recommend that you contact an
authorized Mercedes-Benz Center.
For information on head restraint adjust-
ment, see “Seats” (
page 41).For information on active head restraints,
see “Active head restraints” (
page 81).
Rear seat head restraints (CLK coupe)Head restraint height
1Release button
Warning!G
For your protection, drive only with properly
positioned head restraints.
Adjust the head restraint so that it is as
close to the head as possible and the center
of the head restraint supports the back of
the head at eye level. This will reduce the po-
tential for injury to the head and neck in the
event of an accident or similar situation.
Warning!G
For safety reasons, always drive with the
rear head restraints in the upright position
when the rear seats are occupied.
Keep the area around head restraints clear
of articles (e.g. clothing) to not obstruct the
folding operation of the head restraints.
iAdjust the head restraint in such a way that
it is as close to the head as possible.
Warning!G
For your protection, drive only with properly
positioned head restraints.
Adjust the head restraint so that it is as
close to the head as possible and the center
of the head restraint supports the back of
the head at eye level. This will reduce the po-
tential for injury to the head and neck in the
event of an accident or similar situation.

121 Controls in detail
Seats
Raising
Manually adjust the height of the head
restraint by pulling it upward.
If the head restraint is fully retracted,
push release button1 and pull the
head restraint up.
Lowering
To lower the head restraint, push
release button1 and push down on
the head restraint.Folding head restraints back with re-
lease button
1Release button
Push release button1.
The head restraints will fold backward.Folding head restraints back with
switch in the center console
1Rear head restraints folding switchStart the engine (page 51).
Press switch1 to release the head re-
straints.
The head restraints will fold backward.
Do not drive the vehicle without the seat
head restraints. Head restraints are
intended to help reduce injuries during an
accident.
iAdjust the head restraint in such a way that
it is as close to the head as possible.
iYou can also fold the head restraints back
using the switch in the center console.

122 Controls in detail
Seats
Placing rear head restraints upright
Pull the rear head restraint forward un-
til it locks into position.
Head restraint tilt
Two different head restraint angle
positions are available.
Press the release button (page 121)
and tilt the head restraint to the
desired position.
Removing and installing rear seats
head restraints
1Release button
Removing rear seat head restraints
Fold back head restraint (page 121).
Pull head restraint to its highest
position.
Push release button1 and pull out
head restraint.
Installing rear head restraints
Insert head restraint and push it down
until it engages.
Push release button1 and adjust
head restraint to desired position.
Warning!G
Make sure the head restraints engage when
placing them upright. Otherwise their pro-
tective function cannot be assured.
iAdjust the head restraint in such a way that
it is as close to the head as possible.
Warning!G
For your protection, drive only with properly
positioned head restraints.
Adjust the head restraint so that it is as
close to the head as possible and the center
of the head restraint supports the back of
the head at eye level. This will reduce the po-
tential for injury to the head and neck in the
event of an accident or similar situation.
Do not drive the vehicle without the seat
head restraints. Head restraints are intend-
ed to help reduce injuries during an
accident.
Do not interchange head restraints from
front and rear seat.

266 Controls in detail
Soft top (Cabriolet)
Fold retaining lugs6 out.
Slide pre-assembled wind screen into
mounting fixture on right side7 using
retaining pin on right side. Simulta-
neously, retaining lugs6 should slide
into seat belt passage in rear bench
seat.
Pull catch8 in position9 and guide
left retaining pin into mounting fixture
on left side.
Fold upper section of wind screen up
toward head restraints until it stops.Removing
Fold upper section of wind screen back
down.
Pull catch8 in position10 and pull
wind screen out toward front of vehi-
cle. Be careful not to damage interior
trim with guide tabs.
Fold retaining lugs6 back.
bCatch
Press catch b to the right and fold up-
per and lower sections back.
Place the wind screen back into the
bag.
6Retaining lugs
7Mounting fixture on right side
8Catch
9Locking
10Unlocking
Warning!G
Check for secure locking by pulling up on
the wind screen.
To prevent personal injury, remove wind
screen if rear seats are to be occupied by
passengers.


504 Index
G
Garage door opener 33, 301
Gasoline see Fuel
GAWR 358
Gear range
Automatic transmission 177
Limiting 177
Shifting into optimal 180, 182
Gear selector lever 51, 172
Cleaning 375
Gearshift pattern 172
Lock 52
Message in display 400
Position 173, 174
Position indicator 29, 141
Shifting procedure 173
Unlocking in an emergency 429
Gear selector lever one-touch gearshifting
Automatic transmission 179
Global locking/unlocking
see Key, SmartKey or KEYLESS-GO*
Glove box 285
Gloves 422
Good visibility 185
Gross Axle Weight Rating see GAWR
Gross Vehicle Weight Rating see GVWRGross Vehicle Weight see GVW
GVW 358
GVWR 359
H
Halogen headlamp see Headlamps
Hands-free microphone 33
Hard plastic trim items, cleaning 375
Hazard warning flasher 135
Head restraints 43, 120
Active head restraints 81
Front seat 120
Power seat, Adjusting 43
Rear seat 120, 123
Rear seat, Folding back 121
Rear seat, Lowering 123
Rear seat, Placing upright 122
Rear seat, Raising 123
Rear seat, Removing/installing 122
Headlamp
cleaning system* 185, 330, 496
Headlamp delayed shut-off see
Delayed shut-off, Exterior lampsHeadlamps
Automatic headlamp mode 130
Cleaning lenses 372
Daytime running lamp mode 131
Halogen 446
High beam see High beam flasher
High beam see High beam headlamps
Light sensor 411
Locator lighting 132
Low beam headlamps 130
Low beam see Low beam headlamps
Manual headlamp mode 130
Messages in display 411–415
Night security illumination 132
Replacing bulbs 444, 446
Switch 55, 129
Headliner and shelf below rear window,
Cleaning and care of 375
Head-thorax air bag 71
Heated seats* 125
High beam flasher 55, 133
Replacing bulbs (Bi-Xenon*) 444
Replacing bulbs (Halogen) 444