2008 MERCEDES-BENZ C300 4MATIC Garage

Contents
3-zone automatic climate control*
(Canada only) ..................................... 259
Deactivating
climate control system ................. 261
Operating climate control
system in automatic mode ........... 261
Setting the temperature ............... 262
Adjusting air distribution .............. 263
Adjusting air volume..................... 263
Using driver-side settings for
all temperature zones................... 263
Front defroster ............................. 264
Rear window defroster ................. 265
Air recirculation mode .................. 265
Residual engine heat
and ventilation.............................. 266
Air conditioning ............................ 267
Rear climate control ..................... 268
Trunk ................................................. 269
Opening trunk .............................. 269
Closing trunk ................................ 270
Trunk emergency release ............. 271
Valet locking ................................ 272
Power tilt/sliding sunroof .................. 273
Opening and closing
power tilt/sliding sunroof............. 273Synchronizing............................... 275
Panorama roof with
power tilt/sliding panel* ................... 276
Roller sunblinds............................ 276
Opening and closing panorama
roof with power tilt/sliding panel . 277
Synchronizing............................... 278
Loading and storing ........................... 280
Roof rack*.................................... 280
Split rear bench seat* .................. 281
Loading instructions..................... 282
Storage compartments ................ 283
Cup holders.................................. 287
Trunk ............................................ 288
Useful features .................................. 289
Sun visors .................................... 289
Rear window sunshade* .............. 290
Ashtrays ....................................... 291
Cigarette lighter ........................... 292
Power outlet in the glove box ....... 293
Power outlet in the
rear passenger compartment ....... 293
Floormats* ................................... 294
lTele Aid* ..................................... 295
Garage door opener* ................... 303
Operation......................................... 309
The first 1000 miles (1500 km) ......... 310
Driving instructions ........................... 311
Drive sensibly – save fuel............. 311
Drinking and driving ..................... 311
Pedals .......................................... 311
Power assistance ......................... 311
Brakes.......................................... 312
Driving off .................................... 314
Parking......................................... 314
Tires ............................................. 315
Hydroplaning................................ 315
Tire traction ................................. 316
Tire speed rating .......................... 316
Winter driving instructions ........... 317
Standing water............................. 318
Passenger compartment .............. 318
Driving abroad ............................. 318
Control and operation
of radio transmitters .................... 319
Catalytic converter....................... 319
Emission control .......................... 320
Coolant temperature.................... 321

31 At a glance
Overhead control panel
Overhead control panel
ItemPage
1Rear interior lighting on/off116
2Interior lighting control115
3Right reading lamp on/off115
4Power tilt/sliding sunroof
or
Panorama roof with power
tilt/sliding panel*273
276
5Information button*300
6Tele Aid* (emergency call
system) button295
ItemPage
7Rear view mirror 97
8Garage door opener*303
9Hands-free microphone for

Tele Aid* (emergency call
system)

Telephone*

Voice Control*1
295
160
aRoadside Assistance button*299
bLeft reading lamp on/off115
cFront interior lighting on/off114
1Voice Control* is only available with COMAND*.
Refer to separate operating instructions.

126 Controls in detail
Driving and parking
Starting the engine Manual transmission
Gearshift pattern for manual transmission
For more information, see “Manual trans-
mission” (
page 136).
Warning!G
Make sure absolutely no objects are ob-
structing the pedals’ range of movement.
Keep the driver’s footwell clear of all obsta-
cles. If there are any floormats or carpets in
the footwell, make sure the pedals still have
sufficient clearance.
During sudden driving or braking maneuvers
the objects could get caught between the
pedals. You could then no longer brake or
accelerate. This could lead to accidents and
injury.Warning!G
Inhalation of exhaust gas is hazardous to
your health. All exhaust gas contains carbon
monoxide (CO), and inhaling it can cause un-
consciousness and possible death.
Do not run the engine in confined areas
(such as a garage) which are not properly
ventilated. If you think that exhaust gas
fumes are entering the vehicle while driving,
have the cause determined and corrected
immediately. If you must drive under these
conditions, drive with at least one window
fully open.

150 Controls in detail
Instrument cluster
The outside temperature sensor is located
in the front bumper area. Due to its loca-
tion, the sensor can be affected by road or
engine heat during idling or slow driving.
Therefore, the accuracy of the displayed
temperature can only be verified by com-
parison to a thermometer placed next to
the sensor, not by comparison to external
displays (e.g. bank signs, etc.).
When moving the vehicle into colder ambi-
ent temperatures (e.g. when leaving your
garage), you will notice a delay before the
lower temperature is displayed.
A delay also occurs when ambient temper-
atures rise. This prevents inaccurate tem-
perature indications caused by heat
radiated from the engine during idling or
slow driving.Fuel gauge
The fuel gauge is on the left-hand side of
the instrument cluster (
page 26). Once
the fuel level has fallen below the reserve
mark, the yellow fuel tank reserve warning
lamp 4 for the fuel reserve comes on
(
page 380).

201 Controls in detail
Audio system
Satellite radio
SIRIUS Satellite Radio provides over
130 channels of digital-quality radio, in-
cluding 100% commercial-free music,
sports, news and entertainment. SIRIUS
Satellite Radio uses a fleet of high-orbit
satellites to broadcast 24 hours per day,
coast to coast, in the contiguous U.S. and
Canada.
This diverse, satellite-delivered program-
ming is available for a monthly subscrip-
tion fee.
For more information and service availabil-
ity call the SIRIUS Service Center
(
page 207) (1-888-539-7474), or con-
tact

www.sirius.com (USA)

www.siriuscanada.com (Canada)Subscribing to satellite radio
Press buttonb on audio control
unit repeatedly until satellite radio Sat
is selected.
The following options are possible:

Satellite radio service is not
activated

Satellite radio service is fully
activated
iAdditional satellite radio equipment and a
subscription to SIRIUS Satellite Radio service
provider are required for the satellite radio oper-
ation described in this chapter.
Contact an authorized Mercedes-Benz Center
for details and availability for your vehicle.
iNote that categories and channels shown in
illustrations are dependent on programming con-
tent delivered by the service provider. Program-
ming content is subject to change. Therefore,
channels and categories shown in illustrations
and descriptions contained in this manual may
differ from the channels and categories
delivered by the service provider.
iSatellite radio service may be unavailable or
interrupted from time to time for a variety of rea-
sons, such as environmental or topographic con-
ditions and other things we can’t control. Service
might also not be available in certain places
(e.g., in tunnels, parking garages, or within or
next to buildings) or near other technologies. In
such situations, the satellite radio’s main menu
shows the “Acquiring signal...” screen. At this
point, the radio’s functions are restricted and the
service info display (
page 207) appears.
iIf a satellite receiver is not installed or not
properly installed:
The message
Device unavailable will ap-
pear.
If the satellite radio service is not activated, the
“SIRIUS Preview” display appears.

202 Controls in detail
Audio system
Satellite radio service is not activated
The telephone number of the SIRIUS Ser-
vice Center and the twelve-digit electronic
serial number (SIRIUS-ID) of the particular
receiver are required when calling the
SIRIUS Service Center for an activation re-
quest.
b
Sat
Service.
Closing screen: Press n.
To activate satellite radio service:
Contact satellite radio service provider
at the telephone number displayed in
the service display.
After the connection is made:
Follow the instructions given by the op-
erator.The activation process may take up to
10 minutes. If it is successful, you will
see the display with the message
Acquiring Signal... followed by the
satellite radio basic menu.Satellite radio service is activated
The basic satellite radio menu appears.
You will hear the channel last tuned in, pro-
vided that it can be received.
Switching on
For important subscription information see
“Subscribing to satellite radio”
(
page 201).
Press buttonb on audio control
unit repeatedly until satellite radio Sat
is selected.
The message
Acquiring Signal... will
appear when the signal is not available.
After the audio system acquires the
signal, the satellite radio basic menu
will appear. The station last tuned to
will begin to play.
iActivating the satellite radio service might
not be available in certain places (e.g., in tun-
nels, parking garages, or within or next to build-
ings). If a subscription is not included with
system purchase, credit card information is re-
quired to activate your account.
The activation process takes approximately 5 to
10 minutes after calling the SIRIUS Service Cen-
ter.
If a satellite receiver is not installed or not prop-
erly installed:
The message
Device unavailable will ap-
pear.
iIt is also possible to activate the satellite ra-
dio service online. To do so please visit SIRIUS
Satellite Radio's website at www.sirius.com
(USA) or www.siriuscanada.com (Canada).

303 Controls in detail
Useful features
Garage door opener*
The integrated remote control is capable of
operating up to three separately controlled
devices. It provides a convenient way to re-
place up to three hand-held remote con-
trols used to operate devices such as
garage door openers, gate openers, or oth-
er devices compatible with HomeLink
® or
some other systems.
Before the integrated remote control can
be used, it must be programmed to the ga-
rage door opener, gate operator or other
device you wish to operate. See the follow-
ing instructions for programming informa-
tion.
Interior rear view mirror with integrated
remote control
1Indicator lamp
2 3 4Signal transmitter button
Needed for programming (not part of vehi-
cle equipment):
5Hand-held remote control of ga-
rage door opener, gate operator
or other device
6Hand-held remote control
button
Warning!G
Before programming the integrated remote
control to a garage door opener or gate
operator, make sure people and objects are
out of the way of the device to prevent po-
tential harm or damage. When programming
a garage door opener, the door moves up or
down. When programming a gate operator,
the gate opens or closes.
Do not use the integrated remote control
with any garage door opener that lacks
safety stop and reverse features as required
by U.S. federal safety standards (this
includes any garage door opener model
manufactured before April 1, 1982).
A garage door that cannot detect an object
– signaling the door to stop and reverse –
does not meet current U.S. federal safety
standards.
When programming a garage door opener,
park the vehicle outside the garage.


305 Controls in detail
Useful features
Step 7:
To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
Rolling code programming
To train a garage door opener (or other
rolling code devices) with the rolling code
feature, follow these instructions after
completing the “Programming” portion
(steps 1 through 6) of this text. (A second
person may make the following training
procedures quicker and easier.)
Step 8:
Locate “training” button on the garage
door opener motor head unit.
Exact location and color of the button
may vary by garage door opener brand.
Depending on manufacturer, the “training” button may also be referred
to as “learn”or “smart” button. If there
is difficulty locating the transmitting
button, refer to the garage door opener
operator’s manual.
Step 9:
Press the “training” button on the ga-
rage door opener motor head unit.
The “training light” is activated.
You have 30 seconds to initiate the follow-
ing two steps.
Step 10:
Return to the vehicle and firmly press,
hold for 2 seconds and release the pro-
grammed signal transmitter button
(2, 3 or4).
Step 11:
Press, hold for 2 seconds and release
same signal transmitter button a sec-
ond time to complete the training pro-
cess.Step 12:
Confirm the garage door operation by
pressing the programmed signal trans-
mitter button (2, 3 or4).
Step 13:
To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the
integrated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
iIf indicator lamp1 flashes rapidly for about
2 seconds and then turns to a constant light,
continue with programming steps 8 through 12
as your garage door opener may be equipped
with the “rolling code” feature.iSome garage door openers (or other rolling
code equipped devices) may require you to
press, hold for 2 seconds and release the same
signal transmitter button a third time to com-
plete the training process.