2008 MERCEDES-BENZ C300 4MATIC window

100 Controls in detail
Mirrors
Auto-dimming rear view mirrors*
The reflection brightness of the exterior
rear view mirror on the driver’s side and
the interior rear view mirror will respond
automatically to glare when

the ignition is switched on
and

incoming light from headlamps falls on
the sensor in the interior rear view
mirror
The interior rear view mirror will not react if

reverse gearR is engaged

the interior lighting is turned on
Warning!G
The auto-dimming function does not react if
incoming light is not aimed directly at the
sensors in the interior rear view mirror.
The interior rear view mirror and the exterior
rear view mirror on the driver’s side do not
react, for example, if the rear window
sunshade* is in raised position.
Light hitting the mirror(s) at certain angles
(incident light) could blind you. As a result,
you may not be able to observe traffic con-
ditions and could cause an accident.
Warning!G
Exercise care when using the passen-
ger-side exterior rear view mirror. The mirror
surface is convex (outwardly curved surface
for a wider field of view). Objects in mirror
are closer than they appear. Check your
interior rear view mirror or glance over your
shoulder before changing lanes.

118 Controls in detail
Windshield wipers
Switching on/off windshield wipers
Turn the combination switch to the
desired position depending on the
intensity of the rain.
MWindshield wipers off
USlow intermittent wiping
(rain sensor* operation with low
sensitivity)
VFast intermittent wiping
(rain sensor* operation with
high sensitivity)
uSlow continuous wiping
tFast continuous wiping
Single wipe
Press the combination switch briefly in
the direction of arrow2 (
page 117)
to the resistance point.
The windshield wipers wipe one time
without washer fluid.
Intermittent wiping
Only switch on intermittent wiping under
wet weather conditions or in the presence
of precipitation.
iWhen the windshield wipers are switched on
and you brake the vehicle to a stop, the wipers
operate more slowly.
!Vehicles with rain sensor*:
Do not leave windshield wipers in intermittent
setting when the vehicle is taken to an automatic
car wash or during windshield cleaning. Wipers
will operate in the presence of water sprayed on
the windshield, and the windshield wipers may
be damaged as a result.
!Vehicles with rain sensor*:
If you have set intermittent wiping, dirt on the
surface of the rain sensor or optical effects may
cause the windshield wipers to wipe in an undes-
ired fashion. This could then damage the wind-
shield wiper blades or scratch the windows. You
should therefore switch off the windshield wip-
ers when weather conditions are dry.

120 Controls in detail
Power windows
Opening and closing power windows
The door windows are opened and closed
electrically. The switches

for all door windows are on the driver’s
door

for the front passenger door window
are on the front passenger door

for each rear door window are on the
respective rear door
1Left front door window
2Right front door window
3Right rear door window
4Override switch
5Left rear door window
Warning!G
Do not keep any part of your body up against
the side window pane when opening a win-
dow. The downward motion of the pane may
pull that part of your body down between
the window pane and the door frame and
trap it there. If there is a risk of entrapment,
release the switch and press it again to
close the window.
Warning!G
When closing the windows, make sure there
is no danger of anyone being harmed by the
closing procedure.
Activate the override switch (
page 57)
when children are riding in the back seats of
the vehicle. The children may otherwise in-
jure themselves, e.g. by becoming trapped
in the window opening.
The closing of the door windows can be im-
mediately halted by releasing the switch or,
if the switch was pressed past the resis-
tance point and released, by pressing the
lower part of the respective switch again.
The door windows are equipped with the ex-
press-close and automatic reversal func-
tion. If the window encounters an
obstruction that blocks its path in a circum-
stance where you pressed the switch past
the resistance point and released it to close
the window, the automatic reversal function
will stop the window and open it slightly.

121 Controls in detail
Power windows
Switch on the ignition (page 82).
Opening: Press the desired switch1
to 4 (
page 120) to the resistance
point.
The corresponding window will move
down until you release the switch.
Closing: Pull the desired switch1 to
4 (
page 120) to the resistance
point.
The corresponding window will move
up until you release the switch.
If the window encounters an obstruction
that blocks its path in a circumstance where
you are closing the window by pressing and
holding the switch, by pressing and holding
button ‹ on the SmartKey or SmartKey
with KEYLESS-GO*, by pressing and holding
the sensor surface (vehicles with
KEYLESS-GO*) on an outside door handle,
or by pressing and holding button, on
the climate control panel (Canada only), the
automatic reversal function will not operate.
When leaving the vehicle, always remove the
SmartKey or SmartKey with KEYLESS-GO*
from the starter switch, take it with you, and
lock the vehicle. Do not leave children unat-
tended in the vehicle, or with access to an
unlocked vehicle. A child’s unsupervised ac-
cess to a vehicle could result in an accident
and/or serious personal injury.iYou can also open or close the windows us-
ing the SmartKey, see “Summer opening fea-
ture” (
page 123) and “Convenience closing
feature” (
page 124).
iOperating the windows from the rear is not
possible if you activate the override switch
(
page 57).
iWith the SmartKey in starter switch
position0 or removed from the starter switch,
the power windows can be operated:

until you open the driver’s or front passenger
door

for approximately 5 minutes if no door was
openedWarning!G
If you press and hold the switch up when
closing the window, and upward movement
of the window is blocked by some obstruc-
tion including but not limited to arms, hands,
fingers, etc., the automatic reversal will not
operate.


122 Controls in detail
Power windows
Express-opening: Press the switch1
to4 (
page 120) past the resistance
point and release.
The corresponding window opens com-
pletely.
Express-closing: Pull the switch1
to4 (
page 120) past the resistance
point and release.
The corresponding window closes com-
pletely.
Stopping during Express-operation:
Briefly press the respective power win-
dow switch again.
Warning!G
Driver’s door only:
If within 5 seconds you again press the
switch past the resistance point and re-
lease, the automatic reversal will not oper-
ate.
Warning!G
If a window is blocked while closing and re-
opens, it can be closed with greater force if
you pull the switch to the resistance point
within 2 seconds.
If the window is blocked again and reopens,
you can close it with deactivated anti-trap
protection by pulling the switch again to the
resistance point within 2 seconds.
When closing windows with the anti-trap
protection deactivated, make sure no one
can become trapped, as this could result in
serious or fatal injuries.
!If the upward movement of the window is
blocked during the closing procedure, the win-
dow will stop and open slightly. Remove the ob-
struction, press the respective power window
switch again past the resistance point and re-
lease. If the window still does not close when
there is no obstruction, press and hold the re-
spective power window switch. The side window
will then close without the protection of the au-
tomatic reversal feature.


123 Controls in detail
Power windows
Summer opening feature
If the weather is warm, you can ventilate
the vehicle before driving off by simulta-
neously:

opening the side windows

opening the tilt/sliding sunroof or pan-
orama roof with power tilt/sliding pan-
el* and roller sunblinds
Aim transmitter eye of the SmartKey
towards the sensor in the driver’s out-
side door handle. The SmartKey must
be in close proximity to the driver’s
door handle.
Press button Πto unlock the
vehicle.
Vehicles with tilt/sliding sunroof
Press and hold button Πuntil the
side windows and tilt/sliding sunroof
have reached the desired position.
Release button Πto interrupt pro-
cedure.Vehicles with panorama roof*
If roller sunblinds are retracted:
Press and hold button Œ. The side
windows and roller sunblinds begin to
open/extend after approximately
1 second.
With the side windows and roller blinds
fully opened/extended, press and hold
button
Πagain. The tilt/sliding pan-
el tilts and opens.
If roller sunblinds are extended:
Press and hold button Œ. The side
windows move down and the tilt/slid-
ing panel tilts and opens after approxi-
mately 1 second.
Release button Πto interrupt proce-
dure.
iThe “Summer opening” function can only be
activated via the remote control of the SmartKey
or SmartKey with KEYLESS-GO*.

124 Controls in detail
Power windows
Convenience closing feature
When you lock the vehicle, you can close
the side windows and tilt/sliding sunroof
or panorama roof with tilt/sliding panel*
simultaneously.
Afterward, you can close the roller sun-
blinds* of the panorama tilt/sliding sun-
roof*.Vehicles with SmartKey
Aim transmitter eye of the SmartKey
towards the sensor in the driver’s out-
side door handle. The SmartKey must
be in close proximity to the driver’s
door handle.
Press button ‹ to lock the vehicle.
Vehicles with tilt/sliding sunroof
Press and hold button ‹ until the
side windows and the tilt/sliding sun-
roof are completely closed.
Release button ‹ to interrupt pro-
cedure.
iThe function of the SmartKey overrules the
KEYLESS-GO function.
Warning!G
When closing the windows and the tilt/slid-
ing sunroof or panorama roof with tilt/slid-
ing panel*, make sure there is no danger of
anyone being harmed by the closing proce-
dure.
If potential danger exists, proceed as fol-
lows:

Release button ‹ to stop the closing
procedure. To open, press and hold but-
ton Œ. To continue the closing after
making sure that there is no danger of
anyone being harmed by the closing pro-
cedure, press and hold button‹.
Vehicles with KEYLESS-GO* (Canada only):

Release the sensor surface on the out-
side door handle (
page 125) to stop
the closing procedure.

Immediately pull on the same outside
door handle and hold firmly. The side
windows and the tilt/sliding sunroof or
panorama roof with tilt/sliding panel*
will open for as long as the outside door
handle is held but the door is not
opened.

125 Controls in detail
Power windows
Vehicles with panorama roof*
Press and hold button ‹ until the
side windows and the tilt/sliding panel
are completely closed.
Press and hold button ‹ again.
The roller sunblinds close.
Release button ‹ to interrupt pro-
cedure.
Vehicles with KEYLESS-GO*
(Canada only)
1Sensor surface on door handleThe SmartKey with KEYLESS-GO must be
located outside the vehicle within approxi-
mately 3 ft (1 m) of a door.
Close all doors.
Vehicles with tilt/sliding sunroof
Touch and hold sensor surface1 until
the windows and the tilt/sliding sun-
roof are completely closed.
Release sensor surface1 to interrupt
procedure.Vehicles with panorama roof*
Touch and hold sensor surface1 until
the side windows and the tilt/sliding
panel are completely closed.
Touch and hold sensor surface1
again.
The roller sunblinds close.
Release sensor surface1 to interrupt
procedure.iMake sure you are only touching the sensor
surface.
iMake sure you are only touching the sensor
surface.