Page 320 of 487
318
4-3. Do-it-yourself maintenance
RX400h_U■
Installing the clips
Open
Insert
Press
Engine oil
With the engine at operating temperature and turned off, check the oil
level on the dipstick.
■ Checking the engine oil
Park the vehicle on level ground. After turning off the hybrid sys-
tem, wait more than five minutes for the oil to drain back into the
bottom of the engine.
Hold a rag under the end and pull
the dipstick out.
Wipe the dipstick clean.
Reinsert the dipstick fully.
Holding a rag under the end, pull the dipstick out and check the
oil level.
STEP1
STEP2
STEP3
STEP4
STEP5
Page 326 of 487

324
4-3. Do-it-yourself maintenance
RX400h_U
■If the coolant level drops within a short time after replenishing
Visually check the radiator, hoses, reservoir cap, radiator cap, drain cock and water
pump.
If you cannot find a leak, have your Lexus dealer pressure test the cap and check for
leaks in the cooling system.
■Coolant selection
Only use Toyota Super Long Life Coolant or similar high quality ethylene glycol
based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life
hybrid organic acid technology.U.S.A.: Toyota Super Long Life Coolant is a mixture of 50% coolant and 50% deionized water. (Enabled: -31 °F [-35 °C])
Canada: Toyota Super Long Life Coolant is a mixture of 55% coolant and 45% deionized water. (Enabled: -44 °F [-42 °C])
For more details about coolant, contact your Lexus dealer.
CAUTION
■When the coolant may be hot
Do not remove the radiator cap.
The cooling system may be under pressure and may spray hot coolant if the cap is
removed, causing burns or other injuries.
NOTICE
■When adding the coolant
Coolant is neither plain water not straight antifreeze. The correct mixture of water
and antifreeze must be used to provide proper lubrication, corrosion protection
and cooling. Be sure to read the antifreeze or coolant label.
■If you spill coolant
Be sure to wash it off with water to prevent it damaging parts or paint.
Page 436 of 487
434
6-1. Specifications
RX400h_U
Lubrication system
Oil viscosity
● The 0W portion of the oil viscosity rating indicates the characteristic of
the oil which allows cold startability. Oils with a lower value before the W
allow for easier starting of the engine in cold weather.
● The 20 in 0W-20 indicates the oil viscosity when the oil is at its operating
temperature. An oil with a higher viscosity may be better suited if the
vehicle is operated at high speeds, or under extreme load condition.
Oil capacity
drain and refill
(reference)
Wi th f il ter5.0 qt. (4.7 L, 4.1 lmp.qt.)
Without filter4.8 qt. (4.5 L, 4.0 lmp.qt.)
Oil gradeILSAC multi-grade engine oil
Recommended oil
viscosity
Use Lexus approved “Toyota Genuine Motor Oil” or
equivalent to satisfy the grade and viscosity shown
below.
0W-20 is an oil that provides optimal levels of fuel
efficiency.
Outside temperature
Page 439 of 487
437
6-1. Specifications
6
Vehicle specifications
RX400h_U
Tr a n s a x l e
Fluid capacity
Drain and refill
Front
Without towing package
With towing package
Rear (AWD models only)
3.9 qt. (3.7L, 3.2 Imp. qt.)
4.1 qt. (3.9 L, 3.4 Imp. qt.)
1.8 qt. (1.7 L, 1.5 Imp. qt.)
The fluid capacity is a reference quantity. If
replacement is necessary, contact your Lexus
dealer.
Fluid typeTo y o t a G e n u i n e AT F W S
NOTICE
■Transaxle fluid type
Using transmission fluid other than “Toyota Genuine ATF WS” may cause deterio-
ration in shift quality, locking up of your transmission accompanied by vibration, and
ultimately damage the transmission of your vehicle.
Page 486 of 487
484
RX400h_U
GAS STATION INFORMATION
Auxiliary catch leverP. 3 1 3Back door openerP. 4 4Fuel filler doorP. 7 8
Hood lock release lever
P. 3 1 3Fuel filler door openerP. 7 8Tire inflation pressureP. 4 3 9
Fuel tank capacity17.2 gal. (65 L, 14.3 lmp.gal.)
Fuel typeUnleaded gasoline only P. 80, 433
Cold tire inflation
pressureP. 4 3 9
Engine oil capacity
(Drain and refill)qt. (L, Imp.qt.)
With filter 5.0 (4.7, 4.1)
Without filter 4.8 (4.5, 4.0)
Engine oil typeToyota Genuine Motor Oil or equivalent
Oil grade: ILSAC multigrade engine oil P. 434
Recommended oil viscosity: SAE-0W-20