2008 Lancia Musa warning

36
SAFETY
DEVICES
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
New mission
The new mission begins after:
– “manual” resetting by the user, by
pressing the relevant button;
– “automatic” resetting, when the
“Trip distance” reaches 9999.9 km or
when the “Travel time” reaches 99.59
(99 hours and 59 minutes);
– disconnection/reconnection of the
battery.
IMPORTANT The reset operations
performed after the “General Trip”
message appears are used to also re-
set the “Trip B”, which, on its turn, is
used to reset the values of the corre-
sponding function. Travel time
This value shows the time elapsed
since the start of a new mission.
IMPORTANT If information is not
available, the message “----” will ap-
pear instead of the Trip Computer
values. Displaying of the values will
be resumed regularly when normal
operation is restored without resetting
the values displayed before the failure
nor starting a new mission.
TRIP button fig. 32
ButtonTRIPlocated on the top of the
right steering column stalk is used
(with ignition key at MAR) to display
and reset the previously described val-
ues to start a new mission:
– short pressing to display the differ-
ent values;
– long pressing to reset and then start
a new mission. Values displayed
Range
It indicates the distance left to travel
based on the fuel in the tank assuming
that driving conditions will not change.
The message “----” will appear on the
display in the following cases:
- the range value is below 50 km (30
miles) or the fuel level is below 4
litres;
– car left parked with engine running
for long.
Trip distance
This value shows the distance covered
from the start of a new mission.
Average consumption
This value shows the average con-
sumption from the start of a new mis-
sion.
Instant consumption
This indicates the fuel consumption.
The value is constantly updated. The
message “----” will appear on the dis-
play if the car is parked with the en-
gine running.
Average speed
This value shows the car average
speed as a function of the overall time
elapsed since the start of the a mis-
sion.
fig. 32L0D0027m
007-037 MUSA 3ed GB 12-11-2007 11:33 Pagina 36

37
SAFETY
DEVICES
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
Start of journey procedure
With ignition key at MAR,press and keep button TRIPpressed for over 2 seconds to reset.
Exit TRIP
ExitTRIPis performed automatically after having displayed all the related values or by keeping the button MODE
pressed for over 2 seconds.
Reset TRIP B
End partial mission
Start new
partial missionEnd partial mission
Start new
partial mission
Reset TRIP B
End partial mission
Start new partial mission Reset GENERAL TRIP
End entire mission
Start new missionReset GENERAL TRIP
End entire mission
Start new mission
End partial mission
Start new
partial mission Reset TRIP B
Reset TRIP B
TRIP B
TRIP B
TRIP B GENERAL TRIP
˙
˙
˙
˙
˙
˙˙
˙
fig. 33
007-037 MUSA 3ed GB 12-11-2007 11:33 Pagina 37

38
SAFETY
DEVICES
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
Adjusting the backrest tilting
Move the lever D-fig. 34following the
direction of the arrow: bring the back-
rest to the desired position and then
release the lever.
Lumbar adjustment
(where provided)
The position of the driver’s back
against the seat backrest is adjusted
by turning the knob C-fig. 34clock-
wise to increase the lumbar push or
anticlockwise to reduce it.
SEAT
ADJUSTMENT
FRONT SEATS
Longitudinal adjustment
Lift the stalk A-fig. 33and push the
seat either forwards or backwards un-
til the desired position is reached:
your arms should rest on the steering
wheel rim while you are driving.
Check that the seat is firmly locked in
the runners by trying to move it back
and forth.
Height adjustment
(driver’s side) (where provided)
Move lever B-fig. 33upwards or
downwards to achieve the required
height.
IMPORTANT Adjust the seat sitting
on the driver’s seat after stopping the
car.
fig. 33L0D0041mfig. 34L0D0042m
After these adjustments,
make sure that the seats
are securely locked.
WARNING
038-094 MUSA 3ed GB 12-11-2007 11:34 Pagina 38

39
SAFETY
DEVICES
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
Armrest adjustment
(where provided) fig. 35
To use the armrest bring it from
position1to position 2.
Positioning the passenger’s seat
to be used as a table
Bring the armrest (where provided) in
vertical position.
Sit on the driver’s seat or rear seats
and move the lever A-fig. 36follow-
ing the direction of the arrow: tilt the
backrest fig. 37on the cushion and
then release the lever. In this position
the back of the seat can be used as a
table.Seat warming (where provided)
The seat warming function is en-
abled/disabled by pressing the but-
tonsB-fig. 38to warm the driver’s
seat and C-fig. 38to warm the pas-
senger’s seat.
When the function is active, a led on
the button is on.
Positioning the seat
on the driver’s side to be used
as a table
To position the seat on the driver’s
side for using it as a table remove the
headrest (see paragraph “Headrest re-
moval” in section “Headrest”) fol-
lowing the previously described pro-
cedure.
fig. 35L0D0043mfig. 36L0D0044m
fig. 37L0D0045m
fig. 38L0D0046m
038-094 MUSA 3ed GB 12-11-2007 11:34 Pagina 39

40
SAFETY
DEVICES
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
Adjusting the backrest tilting
Move levers AorB-fig. 42to adjust
the desired part of the seat. Bring the
seat in the desired position and then
release the lever.
Adjustments from luggage
compartment
Longitudinal adjustment
Move the handles FandG-fig. 41to
adjust the desired part of the seat by
moving it forwards or backwards. REAR SLIDING SEATS
Adjustments from car inside
Longitudinal adjustment
Lift levers A-fig. 39orBto adjust the
desired part of the seat. Then, move
the seat forwards or backwards.
Adjusting the backrest tilting
Move the lever C-fig. 40until the
backrest reaches the desired position
and then release the lever.
To prevent possible irregular move-
ments always push the lever Call the
way down.
fig. 39L0D0047mfig. 40L0D0252m
fig. 41L0D0253m
fig. 42L0D0049m
After these adjustments,
make sure that the seats
are securely locked.
WARNING
038-094 MUSA 3ed GB 12-11-2007 11:34 Pagina 40

41
SAFETY
DEVICES
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
The central box is brought back to
vertical position by moving the lever
D-fig. 44again (one lever on each
side) to re-align it with the side rear
backrests until the safety click is
heard indicating that the locking hook
Ehas been secured.
Using the drawer in the
central box compartment
The central box is supplied with a
drawerB-fig. 45.
To use the drawer Bpress button C
and lift the cushion. Adjusting the central box from
the inside
The central box is brought to hori-
zontal position as follows:
❒move lever D-fig. 44(one lever on
each side);
❒bring the central box all the way
down;
❒release the lever.
When the central box is all the way
down, and the headrest has been re-
moved, it is possible to use the glass
recess A-fig. 43(where provided).
fig. 43L0D0051mfig. 44L0D0050mfig. 45L0D0358m
After releasing the adjust-
ment lever, always check
that the seat is locked on the run-
ners by trying to move it back and
forth. If it is not locked, the seat
may move unexpectedly.
WARNING
For max. protection keep
the backrest in upright po-
sition, fully rest your back on it
and place the seat belt snug on the
hips.
WARNING
038-094 MUSA 3ed GB 12-11-2007 11:35 Pagina 41

42
SAFETY
DEVICES
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
Rest position on driver’s side
It is the same procedure as above.
However, the headrest must be re-
moved from the seat on the driver’s
side (see paragraph “Headrest” in this
section).
IMPORTANT Refer to section “Boot
Enlargement” for information on the
operations to be carried out with seats
for enlarging the tailgate. Rest position on passenger’s side
fig. 47
To place the seat in the rest position
keep the rear door open and:
❒bring the passenger’s seat to the
“table” position (see paragraph
“Positioning the seat to be used as
a table” in this section);
❒move the rear seat forwards until
the end of its stroke fig. 48;
❒move the passenger’s seat in table
configuration backwards until the
end of its stroke;
❒remove the rear window shelf (see
paragraph “Removing the rear
window shelf” in this section);
❒tilt the backrest of the rear seat to
the desired position. Adjustment of central box from
luggage compartment
Pull the rope F-fig. 46and at the
same time push the upper part of the
backrest forwards until the stop clip
is released. Move the backrest until it
is positioned horizontally and release
the rope F. To bring the backrest back
to vertical position, repeat the opera-
tion in reverse sequence until the stop
clip is secured.
fig. 46L0D0255mfig. 47L0D0242mfig. 48L0D0243m
038-094 MUSA 3ed GB 12-11-2007 11:35 Pagina 42

43
SAFETY
DEVICES
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
Adjusting the central
box and using the ski
compartment
When the central box is positioned all
the way down, it can be used as the
rear armrest and creates a ski com-
partmentB-fig. 49.
CompartmentBcan be used for car-
rying long loads (e.g. ski) by sliding
them into the boot.
For better use of this compartment we
recommend removing the cushion C
to prevent damage.
WARNING If after cushion Cremoval
the cushion is stored in the boot tem-
porarily, do not place heavy loads on
it which may cause damage or defor-
mations.Removing the cushion
The cushion C-fig. 50can be re-
moved.
For cushion removal: press button D
and extract it from the central box.
For cushion reinstallation: press but-
tonDto secure it to the backrest
panel and make sure that it is locked.
fig. 49L0D0249mfig. 50L0D0344m
Heavy loads in the ski
compartment must be
properly secured to prevent them
from violently moving in the event
of a collision or brisk braking.
WARNING
Carry out adjustments af-
ter stopping the car.
WARNING
Stationary rear seats
(where provided)
For seat tipping see paragraph “Tail-
gate enlargement”.
038-094 MUSA 3ed GB 12-11-2007 11:35 Pagina 43