Page 154 of 258

STARTING UP AND DRIVING153
3
Accessories fitted on longitudinal bars
Remove any accessories such as: longitudinal bars, ski
racks, luggage rack, from the roof if they are not being
used. These accessories decrease aerodynamic penetration
and have a negative effect on fuel consumption. It is bet-
ter to use a trailer to transport particularly bulky objects.
Electrical devices
Use electrical devices only for the amount of time needed.
The heated rear windscreen, additional headlights, wind-
screen wipers and heater fan need a considerable amount
of energy; increasing the requirement of current increas-
es fuel consumption (up to +25% in the urban cycle).
Climate control
The climate control system leads to higher fuel consump-
tion (up to +20% on average): use air vents only when the
external temperature allows.
Spoilers
The use of non-certified aerodynamic items may adversely
affect air drag and fuel consumption levels.DRIVING STYLE
Starting
Do not warm the engine up with the car standing: the en-
gine warms up very slowly in these conditions, increas-
ing fuel consumption and emissions. It is advisable to start
off immediately and slowly keeping the engine speed
down: the engine will warm up much faster this way.
Unnecessary actions
Avoid revving up when starting at traffic lights or before
stopping the engine. The latter action, like doubling the
clutch, is unnecessary and causes increased fuel con-
sumption and pollution.
Gear selection
Use a higher gear as soon as traffic and road conditions
allow. Using a low gear for faster acceleration will increase
fuel consumption.
In the same way improper use of a high gear increases
fuel consumption, emissions and engine wear.
Top speed
Fuel consumption considerably increases as speed in-
creases. Keep your speed as even as possible, avoiding un-
necessary braking and acceleration, which cause excessive
fuel consumption and increased emissions.
Page 155 of 258

154STARTING UP AND DRIVING
Acceleration
Sudden acceleration has a very negative effect on fuel con-
sumption and emissions: accelerate gradually.
CONDITIONS OF USE
Cold starting
Short distances and frequent cold start-ups will prevent
the engine from reaching optimal running temperature.
Consequently, both fuel consumption (from +15 to +30%
on urban cycle ) and emissions will increase.
Traffic and road conditions
Rather high fuel consumption is caused by heavy traffic,
for instance when travelling in a queue with frequent use
of low gears or in cities with many traffic lights. Moun-
tain and rough roads also have a negative effect on fuel
consumption.
Traffic hold-ups
During prolonged hold-ups (level crossings) the engine
should be switched off.TOWING TRAILERS
IMPORTANT NOTES
The car must be provided with a type-approved tow hitch
and adequate electrical system to tow caravans or trail-
ers. Installation must be performed by specialised per-
sonnel who will issue the required papers for travelling on
roads.
Install any specific and/or additional rear-view mirrors as
specified by the Highway Code.
Remember that when towing a trailer, steep hills are hard-
er to climb, braking distances increase and overtaking
takes longer depending on the overall weight of the trail-
er.
Engage a low gear when driving downhill, rather than con-
stantly using the brake.
The weight of the trailer on the car’s tow hitch will reduce
the loading capacity of the car by the same amount. Con-
sider the weight of the vehicle at full load, including ac-
cessories and luggage to make sure you do not exceed the
maximum towable weight (shown on the registration cer-
tificate).
Respect the speed limits specific for each country for ve-
hicles towing trailers. In all cases, the top speed must not
exceed 100 km/h.
Page 165 of 258
164IN AN EMERGENCY
after driving for about 10 minutes, stop and check the
tyre pressure again; remember to engage the hand-
brake;if, on the other hand, a pressure of at least 1.8 bar pres-
sure is read, restore the correct pressure (with engine
running and handbrake on) and continue driving;
drive with the utmost care to the nearest Lancia Deal-
ership.
Apply the adhesive label in a position clear-
ly visible by the driver as a reminder that the
tyre has been treated with the quick repair
kit. Drive carefully, particularly on bends. Do not
exceed 80 km/h. Do not accelerate and brake sud-
denly.
Stop if the pressure has dropped to less than
1.8 bars: The automatic Fix & Go fast repair
kit cannot work properly because the tyre is
excessively damaged. Contact a Lancia Dealership.
Remember to inform the workshop that the
tyre has been treated with a quick repair kit.
Give the instruction booklet to the tyre repair
workshop personnel.
Page 170 of 258

IN AN EMERGENCY169
4
REMOVING THE SUBWOOFER
(versions with Bose HI-FI system, where provided)
IMPORTANT The following procedure only applies to ve-
hicles equipped with Bose Hi-Fi systems with Subwoofer
(where provided).
SUBWOOFER AND SMALL SPARE WHEEL
Proceed as follows to remove the Subwoofer:
open the luggage compartment, pull tab A-fig. 10 and
lift up the mat;
undo locking device A-fig. 8 and lift up the Subwoofer.
Then remove connection cable B from Velcro attach-
ment C;rest the Subwoofer to one side in the luggage com-
partment, remove the container and take out the small
spare wheel;
replace the wheel as described in this chapter.
After tyre replacement:
reposition the container and place the Subwoofer on
top of it, taking care to position it according to the in-
structions on the container (fig. 9) so that the arrow
on the spacer is pointing in the direction of travel;
rest cable B-fig. 8 into Velcro Attachment C to avoid
pinching it. Then tighten locking device A-fig. 8. Re-
place the luggage compartment mat.
fig. 8L0E0176mfig. 9L0E0177m
Page 171 of 258

170IN AN EMERGENCY
Taking out the small spare wheel
Important notes:
the jack weight is 1.76 kg;
the jack requires no adjustment;
the jack cannot be repaired; If it breaks it must be re-
placed with a new jack;
no tool other than the cranking device may be fitted
on the jack.
To replace a tyre proceed as follows:
stop the car in a position where it does not present a
danger for on-coming traffic and where you can re-
place the wheel safely. The ground must be flat and
compact.
turn the engine off and engage the handbrake;
engage first gear or reverse;
lift up the luggage compartment mat using handle A-
fig. 10 (in the presence of a double load platform, first
lift the upper cover and then the luggage compartment
mat).
loosen the fastener B-fig. 10;
take out the tool box C and place it next to the wheel
to be changed;
remove the small spare wheel D-fig. 10;
use the provided screwdriver to remove the hub cap,
levering the dedicated opening on the outer edge;
fig. 10L0E0081m
Page 197 of 258

196IN AN EMERGENCY
TOWING THE CAR
The tow ring provided with the car is housed in the tool
box under the luggage compartment mat.
FASTENING THE TOW RING fig. 43-44
Proceed as follows:
release cap A;
take the tow hook B from its seat in the tool support;
tighten the ring on the rear or front threaded pin.
fig. 43L0E0090mfig. 44L0E0091m
Before starting towing operations, turn the ig-
nition key to MAR and then to STOP, without
extracting it. If the key is extracted, the steer-
ing wheel lock will be automatically activated, thus
preventing steering. The power brakes and the elec-
trical power steering will not work while the car is be-
ing towed. More effort on the brake pedal and steer-
ing wheel will therefore be required. Do not use wires
for towing. Do not jerk. Make sure not to damage parts
in contact with the car while towing. Respect the spe-
cific rules of the Highway Code when towing the car
specifically in relation to the towing device and the be-
haviour to maintain on the road. Do not start the en-
gine while towing the car.
Page 199 of 258

198CARE AND MAINTENANCE
SCHEDULED SERVICING
Correct maintenance is essential for ensuring long car life
under the best conditions.
Lancia has prepared a series of checks and service oper-
ations to be carried out every 30,000 kilometres (for petrol
versions) or every 35,000 kilometres (for diesel versions).
Scheduled servicing will not however fully cover all of the
needs of your car: also in the initial period before the
30,000/35,000 km service and later, between one ser-
vice and another, ordinary care is still required such as
routine checks, topping up the fluid levels,checking tyre
pressure, etc.
IMPORTANT Scheduled Services are required by the man-
ufacturer. Failure to carry them out may invalidate the
warranty.Scheduled Services are offered by all Lancia Dealerships
according to a set time schedule.
If during each operation, in addition to the scheduled ones,
the need arises for further replacements or repairs, these
may be carried out only with the explicit agreement of the
Customer.
IMPORTANT You are advised to contact a Lancia Deal-
ership in the event of any minor operating faults, with-
out waiting for the next service.
If your car is used frequently for towing, the interval be-
tween one service and the next should be reduced.
Page 200 of 258

CARE AND MAINTENANCE199
5
SCHEDULED SERVICING PLAN
Petrol versions
Thousands of kilometres
Check tyre condition/wear and adjust pressure if required
Check lighting system operation (headlights, direction indicators, hazard lights,
passenger compartment lights, boot lights, instrument panel warning lights, etc.)
Check windscreen wiper/washer operation
Check the position/wear of the windscreen/rearscreen wiper blades
Check condition and wear of front disc brake pads and
brake pad wear indication
Check rear disc brake pad condition and wear
Visually inspect the condition of: bodywork, underbody
protection, pipes and hoses
(exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check cleanness of bonnet and boot locks and
linkage cleanness and lubrication;
Check and top up, if required, fluid levels (engine coolant, brake/hydraulic
clutch fluid, windscreen washer fluid, battery fluid, etc)
Check the handbrake lever stroke and adjust it, if necessary
visually inspect the condition of the accessory drive belt
Visually inspect the condition of the toothed timing drive belt30 60 90 120 150 180