2008 HONDA FIT remove seats

When not using the LATCH system,
all child seats must be secured to the
vehicle with the lap part of a lap/
shoulder belt.With the child seat in the desired
seating position, route the belt
through the child seat according
to the seat maker’s instructions,
then insert the latch plate into the
buckle.To activate the lockable retractor,
slowly pull the shoulder part of the
belt all the way out until it stops,
then let the belt feed back into the
retractor.
Af ter the belt has retracted, tug on
it. If the belt is locked, you will not
be able to pull it out. If you can pull
thebeltout,itisnotlocked,and
you will need to repeat these steps.
In addition, the lap/shoulder belts in
all seating positions except the
driver’s have a lockable retractor
that must be activated to secure a
child seat.
If you intend to install a child seat in
the center seating position of the
rear seat, remove its head restraint,
and make sure the detachable seat
belt is securely latched (see page
). 2.
1.
3.
93
CONT INUED
Installing a Child Seat with a L ap/
Shoulder Belt
Installing a Child Seat
Driver and Passenger Saf ety
45
\f—\f—y\f
y
(
\fy\f\f\fy
2008 Fit

The head restraints in the rear outer
seating positions do not adjust f or
height. To remove one f or cleaning
or repair, push the release button,
and lif t the restraint up.
The f ront head restraints adjust f or
height. You need both hands to
adjust a restraint. Do not attempt to
adjust it while driving. To raise it,
pull upward. To lower the restraint,
push the release button sideways,
and push the restraint down.
Theyaremosteffectivewhenyou
adjust them so the center of the back
of the occupant’s head rests against
the center of the restraint.
Seats
88
RELEASE
BUTTON
FRONT
Failure to reinstall the head
restraints can result in severe
injury during a crash.
Always replace the head
restraints before driving.
\f—\f—y\fy
(
\fy\f\fy
2008 Fit

Remove the f ront head restraints
(see page ), and store them
securely.
You can recline the seat-backs on the
f ront seats so they are level with the
rear seat cushions, making a large
cushioned area. To do this:
Recline the rear seat-backs as far
backward as possible (see page ).
When a passenger is seated in the
rear center seating position, make
sure the center head restraint is
properly positioned.
Make sure the head restraint locks
in position when you reinstall it.
1.2.
87 88
CONT INUED
Reclining the Front Seats
Seats
Inst rument s and Cont rols
89
SLIDE LEVER
SEAT-BACK ANGLE
ADJUSTMENT LEVER
REAR CENTER
RELEASE BUTTON
\f—\f—y\f\fy
(
\fy\f\fy
2008 Fit

Pull up the rear seat cushion, and
f old the seat leg down. Push the seat
cushion f irmly against the seat-back
to lock it.
The lef t and right rear seat cushions
can be lifted up separately to make
room f or cargo.
Remove any items from the seat
beforeyoufolduptheseatcushion.
Pull up the seat-back angle
adjustment lever, and pivot the
seat-back backward until it is level
with the rear seat cushion.
Using the slide lever, move the
frontseatcushionsasfarforward
as possible.
Reverse this procedure to return the
f ront seats to the upright position.
When you return the seat-back to its
upright position, hold the seat-back
to keep it f rom going up too quickly.
Make sure you install the head
restraints and securely lock the seats
bef ore driving.
3.
4.
Seats
Folding the Rear Seat Up
90
\f—\f—y\f

y
(
\fy\f\fy
2008 Fit

Whenyoufolddownthedriver’sside
rear seat, use the latch plate to
release the center seat belt from the
detachable anchor (see page ).
Allow the seat belt to retract into the
holder on the ceiling, and store the
buckles in it.Move the front seat cushions as
f ar f orward as possible.
The rear seat-backs can be f olded
down f or more cargo room.
Each side f olds down separately, so
you can still carry a passenger in the
rear outer seating position.
Remove any items from the seat
before folding down the seat-back.
Make sure there are no items on the
floor before folding down the seats.
To return the seat cushion to its
original position, f irst make sure
there are no items on the f loor, then
pull up the seat leg f ully, and push
down the seat cushion slowly while
holding it with your hands. Set the
seat leg in the f loor guide. A latch
comes out when the leg is set
properly. 1. 93
CONT INUED
Folding the Rear Seat Down
Seats
Inst rument s and Cont rols
91
LATCH PLATE
FLOOR GUIDE LATCH LEG
\f—\f—y\f\fy
(
\fy\f\fy
2008 Fit

A non-Honda f loor mat may not f it
your vehicle properly. This could
prevent the proper operation of the
f olding rear seats and the passenger’s
seat weight sensors. We recommend
using genuine Honda f loor mats. Do
not put additional f loor mats on top
of the anchored mats.
If you remove a f loor mat, make sure
tore-anchoritwhenyouputitback
in your vehicle.
Foor Mats, Audio Antenna
A udio A ntenna
204
REAR
Your vehicle is equipped with an
antenna at the rear of the roof . Bef ore
using a ‘‘drive-through’’ car wash,
remove the antenna by unscrewing it by
hand. This prevents the antenna f rom
being damaged by the car wash brushes.
\f—\f—y\fy
(
\fy\f\fy
2008 Fit