2008 FORD SUPER DUTY trailer

[x] Cancel search: trailer

Page 229 of 368

FORD SUPER DUTY 2008 2.G Owners Manual Loading
•Keep the center-of-gravity low for best handling.
•Trailer loads should be evenly distributed front to back and left to
right.
•The load distribution within the trailer should be such t

Page 230 of 368

FORD SUPER DUTY 2008 2.G Owners Manual •Disconnect the trailer tow electrical connector to prevent blown fuses
caused by water entering into your trailer’s electrical wiring.
Exceeding these limits may allow water to enter critical veh

Page 237 of 368

FORD SUPER DUTY 2008 2.G Owners Manual If you’re parking your vehicle on a grade or with a trailer, press and hold
the brake pedal down, then set the parking brake. There may be a little
vehicle movement as the parking brake sets to hold

Page 242 of 368

FORD SUPER DUTY 2008 2.G Owners Manual Always set the parking brake fully and make sure the gearshift is
latched in P (Park). Turn the ignition to the LOCK position and
remove the key whenever you leave your vehicle.
R (Reverse)
With the g

Page 246 of 368

FORD SUPER DUTY 2008 2.G Owners Manual 3. Turn the ignition off.
Do not park your vehicle in Neutral, it may move unexpectedly
and injure someone. Use 1 (First) gear and set the parking brake
fully.
REVERSE SENSING SYSTEM (IF EQUIPPED)
The

Page 265 of 368

FORD SUPER DUTY 2008 2.G Owners Manual ROADSIDE ASSISTANCE
Getting roadside assistance
To fully assist you should you have a vehicle concern, Ford Motor
Company offers a complimentary roadside assistance program. This
program is separate f

Page 272 of 368

FORD SUPER DUTY 2008 2.G Owners Manual Fuse/Relay
LocationFuse Amp
RatingPassenger Compartment Fuse Panel
Description
12 7.5A Power mirror switch, Driver power seat
(Memory)
13 7.5A Not used (spare)
14 10A Upfitter relay #3 feed
15 10A Cli

Page 274 of 368

FORD SUPER DUTY 2008 2.G Owners Manual If the battery has been disconnected and reconnected, refer to the
Batterysection of theMaintenance and Specificationschapter.
The high-current fuses are coded as follows:
Fuse/Relay
LocationFuse Amp
Page:   < prev 1-10 9-16 17-24 25-32 33-40 next >